Q2) Venturi Meter Kerosene (SG = 0.85) flows through the Venturi meter shown in Figure below with Flow rates between 0.00o5 and 0.050 m3/s. Determine the range in pressure difference, pl - p2, needed to measure these flowrates. Kerosene. SG = 0.85 (2)•D,- 0.06 m (1) 0.005 m'a ses0.050 ms

Q: What are the liquid and vapor flow rates for the bottom and distillate streams

A:

Q: Air moving at 100 m/s enters a 2-in scheduele 80 steel pipe in an adiabatic flow system. The air is…

A:

Q: Pressure in the inner tube of a bike tire is 118 psi. Change this pressure to atm. O A. 8.03 atm B.…

A: Answer: A. 8.03 atm

Q: Water flows in a pipeline composed of 75 mm and 150 mm pipe. Calculate the mean velocity in the 75…

A:

Q: 5. A Pitot tube in the pipe in which air is flowing is connected to a manometer containing water as…

A: Given that- Manometer difference in water level, x=87.5 mm= 0.0875m Tube coefficient, CP=0.90…

Q: (a) Air at 1 atm (abs) is flowing through a tube having an inside diameter of 50 mm at a velocity of…

A: Given a) Ait at P=1atm Tube D=50mm T=350K V=15m/s Find Heat transfer coefficient, h Effect of…

Q: 17-86 Air enters a normal shock at 22.6 kPa, 217 K, and 680 m/s. Calculate the stagnation pressure…

A: Assume that ;Air is an ideal gas with constant specific heats and Flow through the nozzle is steady,…

Q: A wind (atmospheric air) at 5 m/s flows parallel to the surface of a container containing ethyl…

A: Given data: Velocity of air = 5 m/s T = 293 k p = 1 atm Distance from leading edge = 0.5 m

Q: Determine the surface area required for a rectangular settling tank for a wastewater flow rate of…

A: The surface area required by the rectangular settling tank for the given flow rate of wastewater is…

Q: Air at 1 atm and 400 K and with a velocity of U∞o = 10 m/s flows across a compact heat exchanger…

A:

Q: An oil (S = 0.85, v = 1.8×105 m²/s) flows through 0.1m diameter pipe at 2m³/sec, 150m long. Find the…

A:

Q: The velocity profile of a fluid in a horizontal circular pipe having a radius R is found as; Vz =0.4…

A: Given data: Velocity profile for a fluid in a circular horizontal pipe is given by the following…

Q: An oll (SG = 0.9) issues from the pipe shown in the figure below at Q= 35 ft/h. The length of the…

A: Write the energy balance equation for the given process as follows: P1ρg + v122g + z1 = P2ρg + v222g…

Q: A 3-in Schedule 40 iron pipeline carries steam at 6 atm gauge. The line is uninsulated and is 70m…

A: Given D = 3in P=6atm(gauge) L=70m T∞=25℃           ε=0.7 Find Steam condense per hour %Heat loss…

Q: Air at 300 K and 1 atm enters an in-line tube bank consisting of 5 rows of 10 tubes each. The tube…

A: Tube banks are found mostly in heat exchangers. The tubes here are arranged in-line and are not…

Q: 1. A flow rate of 16 m/(m² h) is maintained through a 0.6-m-deep bed of filter sand. The sand is…

A: Given: Velocity in bed V = 16 (m3/m2.h) = 16 m/h = 163600m/s = 0.0044 m/s diameter d = 0.4 mm =…

Q: Water at 30°C is being pumped through a 30 m section of 19.49 cm. diameter steel pipe at a mass flow…

A: Given data: Length of the pipe = 30 m Diameter of pipe = 19.49 cm Mass flow rate = 0.07 kg/s Density…

Q: average speed of air in the 450 × 350 duct? ume flow rate in m³/s and mm³/hour. What is the rate of…

A: Given: Follow the notation assigned to the given figure;

Q: A straight pipe with an expansion in pipe from 6 to 11 cm transports water at a rate of 0.011 m /s.…

A:

Q: 5.1-2. Frictional Pressure Drop in a Flow of Olive Oil. Calculate the frictional pressure drop in…

A: Olive oil density and viscosity at a given temperature are obtained. The Reynolds number is…

Q: calculate the largest discharge for which the flow will be definitely laminar Water flows in a 2 cm…

A: This question is based on fluid mechanics. The flow in consideration is Laminar flow. Data given :…

Q: The wastewater treatment process at a polymer plant consists of a longitudinal bio-remediation pond…

A:

Q: IVAN IVOU, Q3: Three pipes (A, B and C) are interconnected as shown in figure (3). Determine the…

A:

Q: Sulphuric acid is flowing through a pipe (2.5 inch diameter, 50 ft length) in a velocity of 0.006 m3…

A: Given: diameter D = 2.5 inch = 0.0635 m, A = pi.D2/4 = 0.003165 m2 Thus, V = Q/A = 0.006/0.003165  =…

Q: P.4.14 Water (density 1000 kg/m', viscosity 1 mNs/m²) is pumped through a 50 mm diameter pipeline at…

A: Case 1: Flow of water through pipe Mass flow rate of water, mW = 4 kg/s Diameter of the pipe, d = 80…

Q: Water at 30°C is being pumped through the annular area of a laboratory scale 1-pass, 1-shell tube…

A: Volumetric flow rate of water = 0.1 m3/s Inside diameter of the shell, d2 = 18.4 cm Outside diameter…

Q: A Poiseuille flow experiment was carried out to measure the viscosity of air at 298 K. The sample…

A: Given data: Length of tube; L=100 cm=1 mInternal Diameter; D=1 mm =0.001 mRadius; R=0.0005 mP1=865…

Q: A steady-flow 100% efficient water power plant has the following inlet and outlet conditions:…

A:

Q: Write the assumptions thats need to be taken ...

A: It's important to remember that these are general assumptions. Depending on the specific…

Q: Repeat problem 9.13 for the case where the fluid is water at 15°C, assuming the Reynolds number…

A: Note: Since we are entitled to answer only 3 subparts, we’ll answer the first 3. Please resubmit…

Q: Q2: A 60 mm diameter pipe contains glycerin (sp.gr 1.258) flowing at 8.5 m'/hr as shown in the…

A: Given: d = 60 mm, specific gravity = 1.258, Q = 8.5 m3/hr and zA = 0m, zB = 12 m. PA = 2 atm and PB…

Q: If the natural gas flow rate is 120 MMSCF/Day in a gas pipeline, NPS 20 with 0.25 in wall thickness,…

A: To calculate the outlet pressure using the Panhandle A equation, we can use the following…

Q: Water leaves the 25 mm diameter nozzle of a fire hose at a velocity of 25 m/s. What will be the…

A: Givendiameter of nozzle when water leaves D = 25 mm…

Q: Q5:Air flows inside pipe 12 cm diameter with mass flow 1.5 kg/min. 1-Is flow laminar or turbulent?…

A: