Q2) The output voltage of transmitter is given by 500(1+0.4 Sin 3140 t) Sin 6.2 X 107 t. This Voltage is fed to a load of 600 2. Find : 1- carrier frequency. 2- modulating frequency. 3- carrier power. 4- mean power output.
Q: If a sinusoidal wave has a frequency of 50OHZ and RMS current of 30 A, which equation represents the…
A:
Q: A radio can be tuned into a particular station frequency by adjusting the capacitance in an L-C…
A: Required to find the inductance and capacitance
Q: The AM band extends from approximately 500 kHz to 1,600 kHz. If a 1.5-?H inductor is used in a…
A: Given: AM band ranges between 500 Hz - 1600 Hz That is, fmin=500 kHz=500×10-3 Hz & fmax=1600…
Q: Channels above 1600 kHz are often reserved for very low range applications like local traffic or…
A: GivenThe resistance of our entire circuit is R = 1.5. ohmantenna voltage for the channel at 1610 kHz…
Q: For an AM envelope with maximum peak a voltage of 52 V and a minimum peak to peak voltage of 24…
A: Given: Maximum peak voltage(Amax) =52VMinimum peak volatage(Amin)= 24V To calculate:…
Q: 02. A 1-0 half-wave rectifier is used to supply power to a load of impedance 82 from 220V, 50 Hz AC…
A: Given Impedance (R) = 8 Ω Voltage Vs rms = 220 V Frequency (f) = 50 Hz Firing angle α = 60°…
Q: Q1) A sinusoidal AC has a maximum value of 15A. What are its RMS values? If the time is recorded…
A:
Q: 2. A 60V chopper drives a resistive load of 12fL The chopper frequency is set to 1 kHz. Calculate…
A:
Q: Find the value of the capacitive reactance and current through a 100 µ F capacitor when connected to…
A: Given data: Capacitance (C) = 100 μF = 100×10-6 F Voltage (V) = 24 V Frequency (f) = 50 Hz…
Q: If a sinusoidal wave has a frequency of 50HZ and RMS current of 30 A, which equation represents the…
A:
Q: o 5042. If the greatest power transferred f At
A: Given as, Impedance is given z = 5042 ohm, Power, P = 150 W.
Q: When an antenna is connected to a RF cable, the Return Loss is 10 dB; what is the SWR? a. 3dB b. 6dB…
A: Given: Let us consider the given data, Return loss=10 dB To find: The SWR.
Q: FM radio stations are assigned frequencies every 0.2 MHz, but two nearby stations cannot use…
A:
Q: . A 2.0- F capacitor has a capacitive reactance of 1.0 k calculate the frequency of the applied…
A: The charge on a capacitor which voltage V being applied, Q=CV (1) If the voltage being…
Q: Determine the potential difference, VA-V8, in the circuit segment shown below when / = 21 mA and Q =…
A: Given: The current flow through this combination is I = 21 mA The charge flow across the capacitor…
Q: Using the Reactance approach, calculate v, across the capacitor. 20 cos(10t+100°) 0.5 H [mm] 1092 20…
A: Given, The circuit diagram, The input voltage, V=20cos10t+100° V=20∠100° V
Q: For a dipole of physical length (PL), where the PL is λ/100<PL </4, the reactive part of input…
A: The physical length of the dipole is PL is determined as the above where that ranges from…
Q: Citizen's band (CB) radio utilizes frequencies between commercial AM and FM. What is the frequency…
A: Given Data: The wavelength of a CB channel is, λ=11.63 m The expression for the relationship…
Q: A part of a radio tuning circuit has an inductance of 0.2microH and a variable capacitor. If the…
A: Concept used: Resonant frequency is obtained when capacitive reactance is equal to inductive…
Q: If the Maximum value for the sinusoidal waveform is 200V, the voltage peak to peak will be O 400V O…
A:
Q: The AM band extends from approximately 500 kHz to 1,600 kHz. If a 2.5-uH inductor is used in a…
A:
Q: A 60 Hz sinusoidal emf wave has a maximum value of 240 V. Determine the instantaneous values of emf…
A:
Q: During a radiofrequency ablation (RFA) procedure to destroy a cancerous liver tumor, an electrode…
A: Given,According to part (a),The intensity, b. The electric field is,
Q: Q-20: -An A.C generator has a maximum potential difference output of 150 volt. a) Find V rms Vvalue…
A: Given data: The maximum potential difference is VP=150 V. Resistance of the coil is R=30 Ω.
Q: Thirty signals, twenty of them have 4kHz bandwidth, the other have bandwidth of 3 kHz are FDM/SSB…
A: Thirty signals, twenty of them have 4kHz bandwidth, the other have bandwidth of 3 kHz are FDM/SSB…
Q: 4. A sin wave has a great (maximum) value for the Vp=12 v find. а) Уг.m.s b) Ур c) Vayg
A: Peak voltage=Vp=12V
Q: Find the value of the capacitive reactance and current through a 100 u F capacitor when connected to…
A:
Q: 25 analog signals (each is bandlimited to 15kHz) are transmitted simultaneously over a channel via…
A:
Q: HO09 1.75x 10°F
A:
Q: In Microwave diathermy The frequency used is .a 750MHZ .b 900MHZ .c 800MHZ .d 600MHZ
A: Microwave diathermy is used to heat superficial muscles and joints such as the shoulder. It is also…
Q: If the uplink transmitter has a power of 100W, what's the EIRP? dBW
A: Given data : Ga = antenna gain =43.62 dB Frequency=1.8GHz Diameter=10meters Efficiency=0.65 We…
Q: If a sinusoidal wave has a frequency of 50Hz and RMS current of 30 A, which equation represents the…
A: frequency (f) = 50 Hz Rms current (Irms) = 30 A
Q: Q4.The impedance value of a generator is 0.2 pu on a base value of 11 KV, 50 MVA. The impedance…
A: Solving question 4: Given data: Initial base value: The impedence value of a generator is x1=0.2 pu…
Q: A 0.35 µH inductor is used in an FM radio circuit that oscillates at 100 MHz. The current through…
A: It is given that, The value of indicator is . The…
Q: Find the value of the current flowing through a capacitance 0.5 u F when connected to an AC source…
A: Write the given data. V=150 Vf=180π HzC=0.5×10-6 F
Q: In an ac circuit, ac generator 179.3V, 76.7 Hz is connected across RLC series circuit. Determine the…
A: The output of an ac generator is sinusoidal and varies with time according to the following…
Q: An AM radio station picks up a 1000kHz signal with a peak voltage 5.0mV The tuning circuit consists…
A: (given) Peak voltage (V0) = 5 mV = 5 Angular frequency (ω0) = 1000 kHz = 1 MHz Capacitance (C) of…
Q: 8. The resonant frequency of an RLC circuit receiver is for when the initial capacitance value is…
A: Initial capacitance (C) = 2 F Let the inductance = L The resonant frequency = fo
![Q2)
The output voltage of transmitter is given by 500(1+0.4 Sin 3140 t) Sin 6.2 X 107 t. This Voltage
is fed to a load of 600 2. Find:
1- carrier frequency.
2- modulating frequency.
3- carrier power.
4- mean power output.](/v2/_next/image?url=https%3A%2F%2Fcontent.bartleby.com%2Fqna-images%2Fquestion%2Ff47793ab-a9ef-4b1a-a31a-f29166be81b3%2F826aec50-25c7-4f73-b838-572e4d31eb9f%2Fejbxgpo_processed.jpeg&w=3840&q=75)
![](/static/compass_v2/shared-icons/check-mark.png)
Step by step
Solved in 2 steps
![Blurred answer](/static/compass_v2/solution-images/blurred-answer.jpg)