Q2) Consider the full wave rectifier circuit shown in fig 2 .The converter is operating with firing angle delay angle 45° 1. Draw and calculate the average output voltage 2. The load current in Amper 3. Determine the output power 4. Accurately plot the current through the two thyristor V1= 220 sinwt T1 100 mH V2= 220 sin (wt-180) T2 2 ohm

Q2) Consider the full wave rectifier circuit shown in fig 2 .The converter is operating with firing angle delay angle 45° 1. Draw and calculate the average output voltage 2. The load current in Amper 3. Determine the output power 4. Accurately plot the current through the two thyristor V1= 220 sinwt T1 100 mH V2= 220 sin (wt-180) T2 2 ohm

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Q.4) A single-phase full-wave controlled rectifier is supplied from 220V, 50Hz. The load is R 100 and L 100mH. Find the firing angle that produced ripple factor equal to 121%. Q theo WILLE K
2. A simple half wave rectifier consists of a diode and load. If the internal resistance of the diode is 1 ohm and the load resistance is 5 ohms. What will be the DC load current if the supply voltage is 12 Volts, draw the schematic diagram and also draw the waveform of the rectifier. 3. Determine the output voltage in the figure below Si Ge Vo R₁ 2kQ 20V R2 2kQ
In a full wave bridge rectifier, the transformer secondary voltage is 10sinwt. Theforward resistance of each diode is 25Ω and load resistance is 1KΩ.Calculate,i. Imii. Idciii. Pdciv. Pacv. η
Can you answer the question step by step ?
The RMS output voltage of a Full-Wave Bridge Rectifier is 20 volts, Calculate the average current (in amperes) flowing into the load resistor with 4.6 kiloohms resistance. 0.00210 O 0.00296 O 0.00391 O -0.00182
A 60 Hz sinusoidal voltage is applied to an SCR full-wave rectifier. If the DC output voltage is 162 V and the firing angle of the SCR is 60 degrees, the peak voltage of the input sinusoidal would be: O A. 197 V O B. 228 V O C. Can't tell; need more information. O D. 340 V O E. None of the other choices are correct
Please answer all parts
11. A conductor carries a current that is equivalent to a 2.5 amp continuous current *A conductor carries a current that is equivalent to a 2.5 amp continuous current m one direction and a superimposed full-wave rectifier in the opposite direction. What is the maximum value of the latter if the average conductor current is zero?
q1
Solve 2,3 only.Note the load resistance is 10 ohm and frequency 60 Hz