Q2) Consider the following router in the diagram below RIP Received Message from router B Net1 3 Net2 5 Net 3 2 Net6 3 Net8 2 Net9 5 ↓ Updating algorithm Old routing table Net1 6 A Net2 3 B Net6 7 C Net7 3 D Net9 3 F Write the new update routing table

Q2) Consider the following router in the diagram below RIP Received Message from router B Net1 3 Net2 5 Net 3 2 Net6 3 Net8 2 Net9 5 ↓ Updating algorithm Old routing table Net1 6 A Net2 3 B Net6 7 C Net7 3 D Net9 3 F Write the new update routing table

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Related questions

Q: Refer to the exhibit. The network topology is provided and we are using Distance Vector Routing…

A: Hey there, I am writing the required solution of the questin mentioned above. Please do find the…

Q: Consider the case when two end hosts communicate remotely, through multiple intermediate network…

A: Here the correct option is Information the router's CPU uses to select the best path between the…

Q: We have 5 routers labled A-E. Suppose we have the forwarding tables shown below after the routing…

A: To send a message from A to E , the least possible cost is 2 and there are two paths having cost 2…

Q: Suppose most of the Internet used some form of geographical but that a large addressing,…

Q: P1. Consider the network below. a. Show the forwarding table in router A, such that all traffic…

A: Host: A host is a computer system or any device connected to other system or device in a network…

Q: 6. In link state routing algorithm after the construction of link state packets, new routes are…

A: Link state routing : It is a routing protocol which is used in packet switching. In this protocol…

Q: OSPF will update routing tables A It never does B When the network changes C Every 120…

A: Given options : A. It never doesB. When the network changesC. Every 120 secondsD. Every 90 seconds

Q: how do we configure each router to have its own routing table?

A: Introduction : Among computer networks, a router is a networking device that forwards data packets.…

Q: How do we configure a routing table for each router?

A: Configuring a routing table The first step is to login to the configure page of a router. Then the…

Q: Referring to the previous problem, once router 1d learns about x it will put an entry (x, ) in its…

A: Given: Given a networking question we need to choose the correct option.

Q: c. Tabulate a Distance Vector Routing Table with the following headings; Destination, Route, Least…

A: Answer :

Q: Q2/ For the given network topology find the best path to go from A to I based routing algorithm…

A: Your solution will be in next step

Q: Give forwarding tables for each of the switches A-E in the following network. Destinations are A-E…

A: BELOW ? STEP BY STEP COMPLETE SOLUTION REGARDING YOUR PROBLEM WITH EXPLANATIONS :

Q: uppose AS3 and for their intra-AS routing protocol. Suppose AS1 is running RIP for its intra-AS…

A: All 3 answers are explained below in detail

Q: The weight attribute is: a) Local to a single router. b) Local to a single AS. c) Local to…

A: Introduction: This question pertains to the weight attribute in the context of routing protocols,…

Q: Specifically, how does the routing work? Give some background information on the distance vector…

A: The act of picking a route across a single network or numerous networks is referred to as routing,…

Q: Consider the count-to-infinity issue in the distance vector routing. Can the count-to-infinity issue…

A: Count-to-infinity issue in the distance vector routing

Q: 2. Assume link state routing is used, and the following link state packets have just come into…

A: Based on the image you uploaded, I can see that you are trying to solve a problem related to link…

Q: 2 S1 3 1 S3 1 S2 D 1 2 A B C Assume all forwarding tables are empty. Fill in the forwarding tables…

A: ANSWER:

Q: build the network route using cisco pack tracer base on what you see on the picture(some part are…

A: In the dynamic and interconnected landscape of computer networks, effective routing is a critical…

Q: )in the case of link failure from C-E show the update routing table from. - A receive update from C…

A: 1)C-> A = 22)B-> A = 53)A-> D = 3

Q: With this given information configure static routes for router R3. And also explain the concept of…

A: Routing is a process which is performed by network layer devices to deliver packets from one network…

Q: give the proper solution of given questions thanks In OSPF, describe two methods that can be…

A: The answer for 2,3 5 is given below, except for 1 and 4.

Q: Consider the following arrangement of switches and destinations. Give forwarding tables (in neighbor…

A: Component Required:(1) x Sintron Uno R3(1) x Passive buzzer(2) x F-M wires (Female to Male DuPont…

Q: Defined the STP protocol? Then, write the number of the Maximum loops that should be stopped by STP…

A: Spanning tree protocol creates a spanning tree by disabling all links that form a loop or cycle in…

Q: GO/2 Go/o 50/1 G0/1 GO/1

A: Note: Here we use that the last name is of even number of letters so the network address uses here…

Q: Consider the network topology in the figure above and assume that the routers are configured to use…

A: Answer

Q: By using distance vector routing protocol, complete all the five tables for routers A, B, C, D and E…

Q: Consider the network shown below, and Dijkstra's link-state algorithm. Suppose that Dijkstra's…

A: The above question is solved in step 2 :-

Q: that include default forwarding entries; the default entries should point toward S5. The default…

A: For eliminating all other entries we will eliminate S1 and S2.

Q: What is the optimal approach to configuring a routing table for each individual router?

A: In this question we need to explain an optimal approach in order to configure any routing table for…

Q: 3. Consider the following forwarding table (that uses longest prefix matching). Rewrite this…

A: the forwarding table using the a.b.c.d/x notation is given below

Q: For each router, how do I configure a routing table?

A: To configure a routing table on a router, you typically need to access the router's command-line…

Q: For each of following ICMP messages, list their possible senders (routers, non-destination hosts,…

A: a) Type: destination unreachable,Code: 2/3 – protocol/port is unreachable - Destination host b)…

Q: Complete the following resulting forwarding table at node x. Destination Outgoing link (X,Y) u y W Z

A: A basic routing table includes the following information: Destination: The IP address of the…

Q: Use netstat –rn to display the forwarding (routing) table for your computer on the screen. Show the…

A: Table # netstat -rnKernel IP routing tableDestination Gateway Genmask Flags MSS…

Q: (a) Where might a datagram be queued inside a router to wait for further processing? (b) How does…

A: The computer networks are the set of the computers that are interconnected with the transmission…

Q: What is meant by the "match plus action" operation of a router or switch? In the case of…

A: Match plus action: It is the process of matching header fields of incoming packets and acting on the…

Q: build the network route on the picture explain what was the challenging part and how you solve them.…

A: In the dynamic and interconnected landscape of computer networks, effective routing is a critical…

Q: Consider the network shown below, and Dijkstra's link-state algorithm. Suppose that Dijkstra's…

A: Link state routing is a technique in which each router shares the knowledge of its neighborhood with…

Question

Q2) Consider the following router in the diagram below
RIP Received Message from
router B
Old routing table
Net1 6 A
Net2 3 B
Net6 7 C
Net7 3 D
Net9 3 F
Net1 3
Net2 5
Net 3 2
Net6 3
Net8 2
Net9 5
Į
Updating
algorithm
Write the new update routing table

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, computer-science and related others by exploring similar questions and additional content below.

Similar questions

59. Consider the network in Figure 3.56, using link-state routing. Suppose the B-F link fails, and the following then occur in sequence: (a) Node H is added to the right side with a connection to G. (b) Node D is added to the left side with a connection to C. (c) A new link D-A is added. The failed B-F link is now restored. Describe what link-state packets will flood back and forth. Assume that the initial sequence number at all nodes is 1, that no packets time out, and that both ends of a link use the same sequence number in their LSP for that link, greater than any sequence number either used before. IFIGURE 3.56 Network for Exercise S9.
4. An ACK segment that carries data will not consume sequence number. True / False. Answer: 5. 127.0.0.0 network is used as address. Answer: 6. In static routing, the routing table configurations will be modified by Answer:
Which protocol is based on Link State Routing? Explain with example also apply Dijkstra algorithm to find route infollowing given network. Take B as root/starting point.
15. Consider the following plot of TCP window size as a function of time (y axis is the congestion window size (segments), and x axis is the transmission round). Assuming that TCP Reno is the protocol experiencing the behavior shown above, answer the following questions. 18 16 14 12 10 00 8 6 4 2 0 1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16 17 18 19 20 1) Identify the intervals of time when TCP slow start is operating. 2) After the 5th transmission round, is segment loss detected by a triple duplicate ACK or by a timeout? 3) What is the value of Threshold at the 7th transmission round? 4) What is the value of Threshold at the 15th transmission round?
List all the static routes on each of the 4 routers required for full communication across the topology. The addresses with question marks have been relabeled. I think each router should have 3 static routes. This is using the ip route command (ip route <netid> <net mask> <next hop>)
Q18. Draw the single call routing diagram between people with following telephone numbers given in Table B2, (Refer Table B3 for national numbering plan and country code.) Table B2 Person Name Fixed Telephone number Mohammed +96823412345 Ahmed +96823424346 Manahil +96824568795 Wedad +96826245486 Table B3 Country Code NDC Туре Fixed Operator Omantel(Dhofar, Al Wusta) 23хх Oman +968 24xx Fixed Omantel(Muscat) 26хх Fixed Omantel(Al Batinah, Musandam) 22xx Fixed Oredoo, Omantel, Awasr
Q2/ For the given network topology find the best path to go from A to J using flow based routing algorithm knowing that the mean packet size is 400 bits and the mean number of arrivals in packets/sec listed in the table. B D 20 10 10 A 10 10 DESTINATION A B D E F H I AF AFG ACEHAHDI ABDU AB 2 AC ABD 2 BD A ACE BA BAC BACE BAF BG BGH BDI BOU CDEF CIG CBH CIGE CI 2. DU CA CAB CD CDE D DBA DB DC DBGHE DIF DBG DIGH DI ECA ECAB EDC ECF EHG EH EHGI EHU CEDE FA FAB FID FCE FO FGH FI FU G GFA GBD GB GBC GHE GF GH GHI H HECA HGB HBC HGID HE HGF HG HGI HJ IDBA IDB IGHE IGH TIDBA JIDB JC JID JHG SOURCE
What is the best way to configure a routing table for each individual router?
Two users, one using Telnet and one sending files with FTP, both send their traffic out via router R. The outbound link from R is slow enough that both users keep packets in R's queue at all times. Discuss the relative performance seen by the Telnet user if R's queuing policy for these two flows is (a) Round-robin service. (b) Fair queuing. (c) Modified fair queuing, where we count the cost only of data bytes and not IP or TCP headers. Consider outbound traffic only. Assume Telnet packets have 1 byte of data, FTP packets have 512 bytes of data, and all packets have 40 bytes of headers.
Take the perspective of router 1 and find the least-cost path from every router to router 1 using Dijkstra's algorithm. Indicate the set ?’, and the value of ?(∙) and ?(∙) for the current least-cost path to all other routers after each step.
Consider the network shown in the figure below, and assume that each node initially knows the costs to each of its neighbors. If the distance-vector algorithm is used by all the routers, what would be the distance table entries at node E?
Consider a router that interconnects three subnets: Subnet 1, Subnet 2, and Subnet 3. Suppose all of the interfaces in each of these three subnets are required to have the prefix 223.10.128/24. Also suppose that Subnet 1 is required to support at least 50 interfaces, Subnet 2 is to support at least 100 interfaces, and Subnet 3 is to support at least 12 interfaces. Provide three network addresses (of the form a.b.c.d/x) that satisfy these constraints.