Q2) a vibratory system with viscous damping: Mass = 2.5 kg; spring constant k = 3 N/mm and the amplitude X decreases to 0.25 of the initial value after five consecutive cycles. Determine the damping coefficient of the damper in the system. k spring ww + b damper m mass x(t) Time

Q2) a vibratory system with viscous damping: Mass = 2.5 kg; spring constant k = 3 N/mm and the amplitude X decreases to 0.25 of the initial value after five consecutive cycles. Determine the damping coefficient of the damper in the system. k spring ww + b damper m mass x(t) Time

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Suppose a spring with spring constant 7 N/m is horizontal and has one end attached to a wall and…

Q: The graph shows the displacement versus time of a mass in a mass-damper-spring system. Which of the…

Q: 2.20. Calculate the frequency of damped oscillation of the system shown in Fig. 2.23 for the values…

A: Answer: The value of critical damping is 35,000 N•s/m.

Q: Find the natural frequencies of the system shown in Fig. 6.19 with m = 1 kg, != 1 m, k = 1000 N/m,…

Q: Use the proportionality constant for unit analysis where necessary.

Q: 3. b www 2000 N/m 100 kg x (t) Figure 2 By referring to Figure 2, compute the value of the damping…

Q: Q- A block of mass 100 kg is attached to springs of spring constant K₁ = 40 N/m and K₂ = 60 N/m. The…

A: Mass of the block m = 100 kgspring constant K1 = 40 N/m and K2 = 60 N/m distance x = 2.5 mTo…

Q: Determine the value of the viscous damping coefficient c for which the system shown is critically…

A: Given: The stiffness, k = 35 kN/m The mass, m = 100 kg

Q: Q3. Consider a spring-mass-damper system with m 80 kg, c 15 kg/s, and k = 1500 N/m with an impulse…

Q: A baby with a mass of 10.6 kg bounces up and down in his crib. The crib mattress behaves like a…

Q: 4. Consider the system shown below. Let K-2 N/m, C- 2 kg/s, M = 1 kg, x(0)=-0.1 m, and v(0) = 1 m/s.…

A: The mass is .The spring constant is .The damping constant is .The intial condition are .

Q: QUESTION 2 Vibration absorber (also called tuned mass damper) is used to reduce* the vibration at…

A: The objective of the question is to find the response amplitude of the second mass in a vibration…

Q: An oscillator system without damping has a natural frequency of omega 0 = pi rad/s. Several types…

A: Given : ω0 = 3.14 rad/s ζ=0.1,0.5,1 To find: a) Frequency of oscillator b) Displacement at t = 2…

Q: A mass-spring damper system has the following parameters: • mass 250g damping constant 1/36000 Nh/m…

Concept explainers

Free Damped Vibrations

Free vibration is a type of vibration in which the external force is removed after giving the initial displacement to a body/system. In other words, in this type of vibration, force is applied at the initial displacement of the system, and after the initial displacement, force is removed, and the system vibrates at the natural frequency.

Question

Q2) a vibratory system with viscous damping: Mass = 2.5 kg; spring
constant k = 3 N/mm and the amplitude X decreases to 0.25 of the
initial value after five consecutive cycles. Determine the damping
coefficient of the damper in the system.
k spring
G
b damper
m mass
x(t)
Time

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1: Identification of given data

VIEW

Step 2: Calculation of logarithmic decrement

VIEW

Step 3: Calculation of damping coefficient

VIEW

Solution

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 4 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Problem 2.151: Energy Dissipated in Viscous Damping Find the energy dissipated during a cycle of simple harmonic motion given by x(t)=0.2sinwot (m) by a viscously damped single-degree-of-freedom system with the following parameters. (a) m=10 kg, c=50 (b) m = 10 kg, c=150 N• sec m N sec m k = 1,000 k = 1,000 N m N m
2.- Determine if the system shown (modulator) is: (1 point) 2.1- Linear 2.2. Invariant in time.
A pump of mass 30 kg is supported on a support structure which has 4 springsarranged in parallel with stiffness values of 10 kN/m, 15 kN/m, 8 kN/m and12 kN/m respectively. Viscous damping is present within the system and 1 kNs/mis applied by a damper.i) Produce a neat sketch of the system and state its equation of motion.ii) Determine the damping ratio for the system, commenting on its value. iii) Determine the damped frequency of vibration.iv) Determine the logarithmic decrement for the vibrating system.
A force of F = 50 N is applied to the rope that causes the angle 0₁ = 60 degrees to keep the system at equilibrium. The N spring constant is k = 100 m B a 0₁ с a b с Variable Value 2 m 2 m 2 m F b Values for the figure are given in the following table. Note the figure may not be to scale. cc i❀O BY NC SA 2013 Michael Swanbom
5B Material point of mass m moves under the influence of force F-kr=-krî With in other words, the mass m is at the tip of an isotropic harmonic oscillator with equilibrium position at the origin of the axes. c) To qualitatively study the movement of the mass m for all its permissible values of total energy of E and L 0. d) To qualitatively study the movement of the mass m for all its permissible values of total energy of E and L = 0.
Q1. Consider a 3-meter long pendulum placed on the moon and given an initial angular displacement of 0.4 rad and zero initial velocity. Note that gravity on the earth's moon is g,m g is the acceleration due to gravity on earth. g/6, where m mg (A) Write down the equation of motion for the pendulum (B) Calculate the amplitude of the angular displacement of the swinging pendulum (C) Calculate the maximum angular velocity of the swinging pendulum (D) Calculate the maximum angular acceleration of the swinging pendulum
A mass-spring damper system has the following parameters: • mass 250g damping constant 1/36000 Nh/m • spring stiffness 500 N/m Calculate the damped frequency. O 1.55.2 rad/s O 2.25.8 rad/s O 3. Not possible to calculate. O 4.79.4 rad/s O 5.44.7 rad/s
QUESTION 3 Vibration absorber (also called tuned mass damper) is used to reduce* the vibration at the natural frequency of the original system. Consider a M-K system shown below. Original System x(t) Modified System x₁(1) X2(t) K K MA M 0000 M F(1) F(t) absorber K This system has a natural frequency at rad. The absorber mass and the spring are attached to the original system as shown in the figure, and the values are selected so that (1) the amplitude of the original mass, M. at the original natural frequency is zero, and (2) the new natural frequencies are moved away from the original natural frequency. The selection of absorber mass and stiffness, m and k, is easy. They have the same ratio as the ratio of the original system. That is, M/m = Klk. Find the transfer functions X1(s)/F(s) and X2(s)/F(s) before you can answer questions. What is the fundamental frequency (first natural frequency) of the modified system in rad/s? Use scientific notation with 3 signifincant figures. Omit…
1- Two mass-spring-damper systems A & B. System A has = 0.1 and @n = 20 rad/sec, and system B has < = 0.3 and wn = 5 rad/sec. Which system will vibrate longer in time? Why?
2. Consider a car suspension, modeled as a mass/spring/damper system (mass m, stiffness k, damping b). Suppose the height of the chassis is lo at rest, the height of the terrain below the driver varies as h(t), and the height of the chassis is denoted lo + y(t). (i.e., spring deflection away from rest is y(t) – h(t)). 2 (a) Give the transfer function G(s) = H(s) · = (b) Suppose the ground follows an oscillatory profile h(t) A cos(wx (t)) with magnitude A (in meters) and frequency w (measured in radians per meter). Suppose the car is traveling at a constant forward speed v. Using a frequency response analysis strategy, give the amplitude of oscillations experienced by the driver at steady state as a function of m, k, b, A, w, and v. Hint: You can't simply consider |G(iw)| to get the amplification in this case. (c) Suppose the ground varies by A = 5cm, w = 2 rad/m, and you are driving at v = 15 m/s. Using your answer to part (b), what amplitude of oscillation is felt by the driver when m…
A vibratory system consists of a spring of stiffness 5 N/mm and a mass of 10 kg. Mass of spring is 3 kg. The natural frequency of the system in rad/sec is
P3). A heavy block of m = 40.0 kg is connected to a spring. The natural frequency of the blockspring system is 0.30 Hz. The system is forced to vibrate sinusoidally. The amplitude of the driving force and its frequency is 5N and vibrating system is Q= 1. 0.190 Hz , respectively. The Quality Factor of this а) Determine the spring constant k of the spring. b) Determine the block's amplitude of motion for the above condition (i.e., at f= 0.190 Hz) c) The driving force suddenly becomes zero. Determine the time it takes for the vibration amplitude to decrease to 1/2 its initial value.