Q2/ A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickness onto another tube of 250 mm external diameter and 25 mm wall thickness, both tubes being made of the same material. The stress set up at the junction owing to shrinkage is 10 MN/m2. The compound tube is then subjected to an internal pressure of 80 MN/m2 Find the chrinkage allowance

Q2/ A compound cylinder is formed by shrinking a tube of 250 mm internal diameter and 25 mm wall thickness onto another tube of 250 mm external diameter and 25 mm wall thickness, both tubes being made of the same material. The stress set up at the junction owing to shrinkage is 10 MN/m2. The compound tube is then subjected to an internal pressure of 80 MN/m2 Find the chrinkage allowance

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Similar questions

A cylindrical steel pressure vessel 400 mm in diameter with a wall thickness of 20 mm, is subjected to an internal pressure of 4.5 MPa.Calculate the transverse stress in steel.
For the hollow built-in pipe with an inner diameter of 48 mm and an outer diameter of 60 mm, the forces given in the figure were applied. Calculate the stresses at point A by reducing the applied forces to point B, then to the cross section at A and show them on the stress element.
i need the answer quickly
SolveSample Problem 4.1.All remain as presented, except for the following changes.The factor ofsafety is now 2, and not 3.As Presented, the thickness of the tube is uniform. In the new one that you are solving,let the thicknessesof the top and bottom be the same,ttb, and the thicknesses of theleft and right be the same,tlr.Theheightand the width of the tube are still respectively 5 in and 3.25 in.As you make thesethickness changes,you are to keep thetotal mass of the tube unchanged. Answer the same questions (a) and (b).Explain your findings
Find the principle stresses at A if diameter is 1 inch.
10.5 (B) A compound tube of 300 mm external and 100 mm internal diameter is formed by shrinking one cylinder on to another, the common diameter being 200 mm. If the maximum hoop tensile stress induced in the outer cylinder is 90 MN/m² find the hoop stresses at the inner and outer diameters of both cylinders and show by means of a sketch how these stresses vary with the radius. [90, 55.35,-924, 57.8 MN/m²]
Find the cross sectional area if applied force is 26 N and stress produced is 60 N/mm2
MPa) which requires at least a pressure of 10 MPa to prevent leakage. Problem 8.5 A joint in the figure uses a compressed asbestos gasket (E-480 Dimensions are in mm 10 20 200 100 D 150 The cover plate is tightened by using 8, metric grade 5.8, M10x1.5 bolts. If the cylinder is to be rated for an internal pressure of 3500 kPa, calculate the necessary tightening force per bolt for a factor of safety of 2.
10 MPa 5 MPa 20 MPa In class exercise: Plot Mohr's circle for the given stress state