Answered: Q1c: Given the voltage and current… | bartleby

Related questions

Question

Q1c: Given the voltage and current values in the table below, how can you directly calculate the resistance? This same
data is plotted on the right. How can you determine the resistance from this graph (V=IR)?
Voltage (V) Current (mA)
8.0
21.0
30.0
38.0
51.0
2
3
4
5
Voltage (V)
5
4
3
2
1
10
20
I
●
30
Current (mA)
●
40
●
50

Expert Solution

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 1 images

SEE SOLUTION Check out a sample Q&A here

Blurred answer

Similar questions

You may want to review (Pages 742 - 745). Part A Find the equivalent resistance between points A and B shown in the figure(Figure 1). Consider Rj = 2.7 N, R2 = 3.5 N , R3 = 2.8 N , R4 = 2.3 N , R5 = 7.2 N , and R = 8.2 N . Express your answer using two significant figures. ? Req = |1.5 Submit Previous Answers Request Answer X Incorrect; Try Again; 4 attempts remaining Provide Feedback Figure 1 of 1 R3 R4 R R2 R5
Q1/ R1= 5 k ohm R2=15 k ohm R3= 20 k ohm R4= 10 k ohm R5= 20 k ohm I = 5 mA Find: a) I1 , I2 , I3 , and IT . b) Total Resistance of the circuit. c) The voltage (V) and Power supplied(P) by the battery.
In the circuit shown, the potential difference VA = VB = 46.0 V and the resistance R1 = R2 = R3 = R4 = 155 Ohms. The arrows for currents IA and IB indicate the direction of positive current flow. The arrows do not necessarily indicate the direction that the current flows. Find IA Find IB
If Vs = 6 V, R1 = 14 2 and R2 = 83 2, what voltage would you expect to see displayed on a voltmeter (in V to 1 decimal place) connected as in the circuit shown below? You should assume that the voltmeter is displaying a positive value. R1 0 R2 Vs
Q1) Ohm's Law (in electricity) states that the current (I) is proportional to the applied voltage (V). The constant of proportionality is the resistance (R). The resulting equation is: V = IR. This equation is re-arranged to: I = (1/R) V. Since this is a linear equation, the plot between V (on the x-axis) and I (on the y-axis) should be a straight line, with the slope being 1/R. In an experiment, the following data has been obtained for current for different values of the voltage. Voltage 1 2 3 Current 0.8 2.5 2.9 4.2 5.6 a) Determine the equation for the best-fit line from this data, by using the method of least squares. Equation: Plot the data points, and the straight line representing the equation that you found in part b) 'a'. (Note: the best-fit line will not pass through all the data points) c) Use the slope of the line to find the resistance. Resistance: LO