Q1/A- For the circuit shown in Fig., find: (a) V₁ and V₂ (b) the power dissipated in the 3K0 and 20 KQ resistors, and (c) the power supplied by the current source. 1 ΚΩ 3 ΚΩ + 30 mA · 5 ΚΩ + τ 20 ΚΩ

Q: Draw the following signal -t/3 Please upload picure of your graph.

A: we need to draw the graph of given statement.

Q: If the input Vi is a triangle voltage signal. What will be the form of the output Voltage? write…

A: The circuit shown in the question is a differentiator amplifier because the capacitor is connected…

Q: The platinum RTD has been connected to the wheatstone bridge circuit represented by R3 with Vin =…

A:

Q: Look at the diagram and answer the following questions

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: What is the difference between the pins under number 1 and the pins under number 4, and mention when…

A: The difference between pin 1 and pin 4 is the transmitting ability (information) to external…

Q: If neither switch is closed, how can you tell whether there is a potential difference across any of…

A: In the question  2 switches are consist in the circuit. If neither switch is closed, how can you…

Q: 0.05x+0.10(150,000-x)=10,000 Solve

A: Given  An equation involving a single variable,we need to solve for X value. Please find the below…

Q: Design a synchronous counter using JK flip-flops to produce the following sequences. 3 5 1

A: According to the question, we need to design a synchronous counter, which follows the following…

Q: what is the application of galileo number

A: Galileo number (Ga): It is a dimensionless pack addressing a proportion of forces present in the…

Q: Which of the following is NOT included in MMDST kit? Small bell with 2 ½ inch diameter opening…

A: The solution is given below.

Q: a. b. d.

A: A computer port is used as an interface between the computer and different peripheral devices.

Q: The full form of PIPO is

A: Given, PIPO

Q: Prove that the maximum efficiency occurs when the iron losses are equal to the copper losses…

A: To Prove: Maximum efficiency occurs at, Iron loss = Copper loss Considering the current as a…

Q: QUESTION 29 Select all signals that are inputs for the 8088. Use the schematic for our board. OSC…

A: Consider the schematics of 8088 shown below,

Q: What is the Circular chart recorder with diagram

A: As the name suggest a circular  chart recorder records data. It records data on a paper disc that is…

Q: Q1/The Gray code (10110111101)= ( ) in decimal number None of them O 1753 O 869 O 1749 O 931 O 1750…

A: We need to do convert the gray code to decimal number

Q: 7) The following readings are obtained in the measurement of an inductor: 1.003,0.998, 1.001, 0.991,…

A:

Q: Explain the differece between continous and discountinous current mode of convetrer operation

A: There are basically two modes of converter operations  1) Continuous Converter Operation the current…

Q: ALL FINAL ANSWER SHOULD BE ACCURATE TO 3 DECIMAL PLACES USE POSITIVE ANGLE EQUIVALENT, NOT GREATER…

A:

Q: With the aid of diagrams, discuss the procedure to detect zero error and cyclic error in fieldwork.

A: Field work- Field work is typically work that is not done in the main office buy at the customers…

Q: Find three patterns respositories for user-Interface patterns, select one patterns from each and…

A: Three patterns respositories for user-Interface patterns are, Welie pattern library Yahoo design…

Q: If the input voltage Vi is a square signal. What will be the form of the output Voltage? (Write your…

A: Given op-amp circuit shown

Q: I can't view images

A: here we have to find the voltage V0 using thevenin theorem.

Q: Quiz; An alternating current of frequancySoHe has makimum Value of (I 20A). write the instantanous…

A: Given : Freq = 50 HZ Imax =Io = 120A ω=2πf

Q: I have an LED that I want to slowly dim and bring back to full brightness. To which area on my…

A: Generally we use PWM pins in the Arduino board to vary the brightness of the LED by the variation of…

Q: *:Choose the right answer for each line Internal Noise External Noise Atmospheric Noise Thermal…

A: External Noise:   External noise is the noise that is produced due to external sources. Under…

Q: In a typical AAS what is the ouput of the istrument given out as data?     % composition…

A: Generally in the typical AAS the output of the instrument output data is  absorbance.

Q: AC or DC coupled Type of waveform Chopped or alternate mode.

A: Answer- 4 Since both waveform of signal-1 and signal-2  are periodic therefore the average value of…

Q: 2. Identify each device. (a) 74LS157 (ь) 74LS151

A: According to the context of the given question, it is only required to identify the given ICs in the…

Q: Need solution within 15 mins. Give 5 stars for correct solution

A: The solution is provided in the following section:

Q: Convert the OCTAL NUMBER 65 40.7 20 2 to decimal number. Answer = %3D

A:

Q: use the constant voltage drop model in analyzing the diode circuit below 10 Ω M V₁ (+ D₁ If V₁ is -3…

A: In this question We need to choose the correct option.  We know If diode is working in forward…

Q: finding the voltage to each resistance?

A:

Q: I can't clearly see the lines in the column of the equation.

A: De Morgan's theorems can be expressed as A+B=A.B--->(1)A.B=A+B--->(2)

Q: Stylus Film Substrate Stage Profile Signal Film Thickness Figure 8 Profilometer is one of the…

A: Profilometer is one f the important characterization equipment to determine the thickness of metal…

Q: ALL FINAL ANSWER SHOULD BE ACCURATE TO 3 DECIMAL PLACES USE POSITIVE ANGLE EQUIVALENT, NOT GREATER…

A:

Q: |= 7mA. Determine Vo (in Volts)? I ka I ka Select one: Oa. 1.75 O b.-13 Oc.7.00 Od. +13 O e. 4.69

A:

Q: deterptiar the alue to a clese leep Coantael Date. tn a cteed teep Contrel system $s Hal, yte due to…

A:

Q: need handwrite version of solutions

A:

Q: Where a 2 1/2 inch conduit enters an angle pull box with three 400 MCM type THHN conductors and a 2…

A: For angle pulls, the distance between each raceway entry inside the baox and the opposite wall of…

Q: Discuss in detail whether the incident energy can be sampled or not with pick up probe at port ‘4

A: The directional construction is shown in the figure below:

Q: What is a line refernce number in electrical prints

A: For developing the circuit diagram, it needs to be identified as the unique components. The…

Photoconductive Cell

Photoconductive cells are light-sensitive resistors in which resistance is inversely proportionated to light intensity when illuminated. These devices consist of a thin single-crystal or polycrystalline film of composite semiconductor materials. Cadmium sulfide (CdS) is used to make the most commercially available photoconductive particles which are sensitive to light in the visible spectrum. Other less commonly used substances respond to infrared light, but not to the visible spectrum. Such substances are lead sulfide (PbS), lead selenide (PbSe), and lead telluride (PbTe), and so on.