Q16 - A distance shown with 12 cm in the 1 / 600.000 scaled map I. It is indicated by 20 mm on the map. Accordingly, II. What is the scale of the map? A) 1 / 2.400.000 B) 1 / 3.600.000 C) 1 / 100.000 D) 1 / 200.000 E) 1 / 2.000.000

Q: The (X,Y) coordinates (in feet) for a closed-polygon traverse ABCDEFA follow: A (460.88, 139.31), B…

A:

Q: What is the coordinate using the survey foot definition? Express your answer in survey feet to…

A: Metric coordinateThe dimension of any structure or a component can be measured in the International…

Q: II I I| |||| Using the contour map what are the elevations of the contour lines Labeling Contours…

A:

Q: Draw contours for the following data using the grid method. The following data of a piece of land…

A:

Q: Question: If coordinate of point A is (157.717, 111.375), use the given below data to calculate…

A: Given :Coordinate of point A (157.717,111.375)Azimuth of FA=73°17'21''Interior angle of…

Q: Find the scale ratio for the map described below. 1 mm (map) = 5 km (actual) The scale ratio is 1 to…

A: Introduction : The given question is related with surveying topic . In this question we are provided…

Q: (a)Draw a sketch of the following figure and determine, by the cross-coordinate method, the area of…

A: Note:- Hi! Thank you for the question As per the honor code, We’ll answer the first question since…

Q: For this assignment you are given three contour maps. Draw a profile elevation for each contour map.…

A:

Q: A NOT TO SCALE TODLI I VERSIUN

A:

Q: Show illustration/diagram with complete and detailed solution. Compute the area of a cross section:…

A: Given To find : area of cross section

Coordinate Geometry of Survey

Coordinate geometry (COGO) is a method of inserting surveying or engineering data into geographic information system (GIS), computer-aided design (CAD), or mapping software. These data can be collected on the proposed construction site using standard surveying techniques and instrumentation or may be taken from existing maps, engineering plans, drawings, or records. Data gathered on the site includes coordinates of points, bearings, and distances between points. The data are noticed and noted through conventional surveying procedures, like a traverse or layout measurement series and it can be either digital or non-digital. The maps and plans are inclusive of boundaries, divisions, and other components, and these features are shown with coordinate values, the lengths, offset distance, and bearings between them.