Q11: A signal f,() is bond - limited to 3.6 KHz, and three other signals fi(t), f2(t), f3(t) and f4(t), are band – limited to 1.2 kHz each. These signals - are to be transmitted by means of time - division multiplexing. (a) Set up scheme for accomplishing this multiplexing requirement, with each signal sampled at its Nyquist rate. (b) What must be the speed of the commutator (in samples per second)? (c) If the commutator output is quantized with L 1024 and the result is binary- coded, what is the output bit rate?

Q11: A signal f,() is bond - limited to 3.6 KHz, and three other signals fi(t), f2(t), f3(t) and f4(t), are band – limited to 1.2 kHz each. These signals - are to be transmitted by means of time - division multiplexing. (a) Set up scheme for accomplishing this multiplexing requirement, with each signal sampled at its Nyquist rate. (b) What must be the speed of the commutator (in samples per second)? (c) If the commutator output is quantized with L 1024 and the result is binary- coded, what is the output bit rate?

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

Sketch the electronic symbol (schematic) for the following components/ devices. Briefly describe the function of the electronic component and use the IEEE/ANSI standard symbol as indicated below. Fixed Resistor Any Variable Resistor Polarized Capacitor
B01.2 QUESTIONS ON THIS CHAPTER C a رها The conductivity of a pure semiconductor is due to: al electrons. 2 □ 3 04 □5 al 02 3 04 5 A pure semiconductor is a good conductor when the temperature is: □ 2 □3 4 5 AP type semiconductor is obtained by adding impurities such as: al LESSON BOI: INTRODUCTION TO SEMICONDUCTORS 2 holes positive ions of the N regions and electrons electrons and holes positive ions of the P regions and holes □ 3 04 5 very high very low ol □ 2 □ 3 4 □5 absolute zero when ranging between 0 and 25 °K it is not affected by temperature An N type semiconductor is obtained by adding impurities such as: those belonging to group III of the periodic table of the elements al phosphorus only those belonging to group V of the periodic table of the elements those belonging to the group III of the periodic table of the elements antimony only gallium only boron in the proportion of 25 %, and arsenic as 75 % boron only aluminum and antimony together at 50% those belonging to group V…
write 4 points on working of nuclear power station
Your email will be recorded when you submit this form * Required Q1: A) used as a preamplifier for a microphone. Finds the voltage gain if Vin =40mv and Vo=30v Vo Rz Vin 75 750 75k 750k from the Q1 find the name of circut * II
write legibly and show complete process and solution
Compare between the practical and theoretical results.
Question 1 Consider the adjacent circuit diagram of three different rectifier topologies connected to an 373 Volt three-phase AC system. Assume a load resistance of 36Ω in ALL instances with NO losses in the rest of the circuit. Observe the connections to the AC supply and determine the parameters for, Rectifier B: 1.1) the maximum voltage across the load and the dc load voltage and the r.m.s. load voltage. 1.2) the rectification efficiency and the r.m.s. current rating of the diodes. 1.3) the conduction period of a single diode and the PIV rating of the diodes.
Short answer. What happens to the resistance of a negative temperature coefficient material if its temperature increases? Use the editor to format your answer Short answer. What is the advantage of a semiconductor device if in the conduction of current there is no voltage drop across it? Use the editor to format your answer Short answer. Why a semiconductor diode is called a non-linear device? Use the editor to format your answer
Draw the pin diagram of 8051 & 8237 and write down the difference between them.