Q10: Windmills slow the air and cause it to fill a larger channel as it passes through the blades. Consider a circular windmill with a 7-m-diameter rotor in a 8 m/s wind on a day when the atmospheric pressure is 100 kPa and the tempera- ture is 20°C. The wind speed behind the windmill is mea- sured at 6.5 m/s. Determine the diameter of the wind channel downstream from the rotor and the power produced by this windmill, presuming that the air is incompressible. Flow channel W

Q: You wash your roof with a water hose at a height of 8.0 m above the ground. You connect two garden…

A: Given- P1 = Atmospheric pressure = 1.01 x 105 Pa v1 = 6 m/s height from datum 2 to 1 = (h) = 8 m By…

Q: 1. A turbine is fed from a mountain reservoir 300 metres above it. Calculate the drop in…

A: The objective of the question is to calculate the drop in mass specific energy and the volumetric…

Q: A power plant requires 940 L/min of water. The required net head is 5 m at this flow rate. An…

A:

Q: A water truck drives slowly around a construction site, spraying water to keep dust down. A pump…

A:

Q: you have a flat tire and need to pump up the tire on your car  with a hand pump, what force do you…

A:

Q: A centrifugal pump is running at 1000 r.p.m. The outlet vane angle of the impeller is 30° and…

A:

Q: • The firefighter holds the hose 1 m off the ground. What is the speed of the flow as it leaves the…

A: according to bartleby policy, answering first 3 subparts only.

Q: 5. Consider a propeller based aircraft with a supercharger. It operates with a revo of 2700 rpm, has…

A: Assume the given process is adiabatic therefore, apply the relation as follows.

Q: Water flows between two reservoirs, with a 170 meters elevation between them, to a turbine where…

A:

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.