Q1: The figure below represents a three sides polygon (ABC). Use the given information and answer the following questions: 1. The Azimuth and distances of all sides (AB, AC, CB). 2. The interior angles B and C 3. The coordinates of the polygon's vertices A, B, and C 28m C 90° 15m 35m

Q: 14 ..... (Units are cm) 1) a) Locate the centroid of the area. b) Determine the moment of inertia…

A:

Q: Determine the magnitude and direction of the resultant force for the force system shown below. The…

A: Force system in which different forces were acting. We need to calculate resultant force for the…

Q: Determine the distance y to the centroid of the beam's cross sectional area; then find the moment of…

A: y=A1y1+A2y2+A3y3A1+A2+A2y=6×10.5+4×142+4×1426×1+4×1+4×1y=6×10.5+4×142+4×1426×1+4×1+4×1y=1.3572in

Q: do the nodes A B and C have any horizontal displacement despite there only being vertical loads on…

A:

Q: Using ONLY 2 sub-areas (present your calculations in a table): a) Determine the centroid [m] for the…

A: The dimensions of the given figure are marked after splitting it into two rectangles as follows

Q: Using Mohr’s circle, determine for the area indicated the orientation of the principal centroidal…

A: Given,

Q: Using the method of virtual work, find the vertical displacment of Point D. E = Ksi 1 inz 29,000…

A: To find the vertical displacement at the point D in the given truss using the method of Virtual…

Q: Determine the slope and deflection of point B of the beam shown by the direct integration method. 6…

A:

Q: For the beam shown in Fig.Q4, use the principle of virtual work to determine (1) the vertical…

A: Given Point force(P)=35KN Uniformly distributed load(q)=14 kN/m Length of AB span (L)=4 m Length of…

Q: For the area shown, determine: a) The centroidal coordinates X and Y. b) The moment of inertia…

A:

Q: Find the moment of inertia Ix'x for the cross-section shown, Point C is the center of area for the…

A: Consider the figure,

Q: 4. Given two vectors both with a magnitude of 1 making a 67 deg angle, use the law of cosines to…

A: Please see the attached image for the solution. The law of cosines is used to compute the unknown…

Q: Draw the M, N, T diagrams of the beam in the figure using the integration method. 8kN 4kN/m A В 3kNm…

A: 1. First let us calculate the reactions∑MA =0The load at C acts at an angle equal to…

Traverse Survey

Traverse surveying is a popular method of surveying. Traversing is that type of survey where several connected survey lines form a framework and the directions and lengths of the survey lines are measured with the help of a tool to measure angles and tape or chain respectively. Traverse networks involve placing survey stations in a queue or trail and using pre-tested points as a basis for looking at the next point. This type of surveying is different from Tacheometric surveying, where only angles are measured and the process of chaining is reduced.