Q1 The feed to a propylene ammoxidation process contains 14.55 % of C3H, by mass, 7.0 % ammonia by mass, and 78.45 % air by mass. A fractional conversion of 30.0% of the limiting reactant is achieved, taking 1000 kg feed as a basis, determine the ratio of the unreacted oxygen to the feed by mass, the percentage by which each of the other reactions is in excess, and the mass amounts of all product gas constituents for a 30% conversion of the limiting reactant Feed 100 mole P = ? Reactor =? = 0.1455 NNH3 =? x = 0.07 noz =? xair = 0.7845 N2 =? %3D NC3H3N =? NH20 =? C3H6 + NH3 + 3/202 - C3H3N + 3H20

Q: In a reactor, the following reaction takes place in a gas phase at a temperature of 600K and a…

A: The equilibrium constant, Keq is defined as the ratio of the equilibrium concentrations of products…

Q: In Deacon process, gas phase reaction was carried out in isothermal batch reactor to form chlorine…

A:

Q: When 13 g of reagent Z dissolves in 500 g of water in a coffee cup calorimeter, the initial…

A: The heat released or absorbed can be calculated by the product of the mass of the substance,…

Q: Butene is obtained as a result of the dimerization reaction of ethylene: 2C2H4(g) → C4H8(g)…

A:

Q: A feed, composed of 95 mol% ethylene (C.H.) and 5 mol% ethylene oxide Problem 1 (C:H.O) is fed to a…

A:

Q: 2(g) Ammonia is synthesized in the Haber Process following the reaction N + H → NH In the reactor, a…

A: Ammonia is synthesized by the Haber Process reaction as shown below: N2(g)+H2(g)→NH3(g) Conversion…

Q: Hydrogen and oxygen are reacted and the water formed is collected at 25°C, where it has a density of…

A: Given that mass of hydrogen (m1)=36.8 g mass of oxygen (m2)=168 g density of water (d)=0.997 g/ml

Q: Exereuse 1. 69 The total combustions of mole of Liquid methanol under Standard pressure and…

A: Moles of methanol = 1 molAmount of heat released during combustion at STP = 725.2 kJ/mol

Q: 5. In a continuous reactor, the feed contains 85% ethane and the balance inerts (I). fraction…

A: Given that, Reactions: Reaction 1: C2H6 → C2H4 + H2Reaction 2:C2H6 + H2 → 2CH4 Mole% of ethane in…

Q: 2. Ethanol is produced by the hydration of ethylene according to the first reaction below. However,…

A: Ethanol is produced by the hydration of ethylene and and side reaction produces the diethyl ether as…

Q: Q2 Sulphur trioxide gas is obtained by the combustion of pyrites (FeS,) according to the following…

A:

Q: Q1// Calculate change in standard enthalpy of formation AH (Fe203) and Standard Enthalpy of…

A: Calculating the standard enthalpy of formation:

Q: (c) Now consider producing m mole of methyl acetate using n mol of acetic acid (use your dataset for…

A:

Q: 13.9 mole Boron Trichloride (BCl3) enter a reactor with 22.3 mole water for the following reaction:…

A: Boron trichloride reacts with water to give hydrochloric acid fumes and boric acid. A significant…

Q: The synthesis of chemical intermediate C can be written as: A + 2 B = 2 C The reaction is to be…

A:

Q: A gas mixture of 0.270 mol acetic acid/mol, 0.300 mol water/mol, and 0.430 mol inerts/mol at 88.0 C…

A: Mole fraction of acetic acid (A), water (W), and inert (I) in a gas phase mixture is given as:…

Q: 4.69. Ethanol can be produced commercially by the hydration of ethylene: C₂H4 + H₂O → C₂H5OH Some of…

A: Given reaction for the hydration of ethylene is,Side reaction is,Mole percent of ethylene = 43.3…

Q: 2. In the methanol synthesis described above, small quantities of non-reactive gaseous impurities…

A:

Q: Formaldehyde is produced by the gas phase oxidation of methanol with air over a catalyst in the…

A:

Q: Phthalic anhydride (PA) is produced by oxidation of o-xylene (C3H10) in a fixed bed reactor…

A:

Q: Antimony is obtained by reacting pulverized Stibnite (Sb2S3) with scrap iron and drawing off the…

A:

Q: 4FES2 + 150z – 2F€203 + 8S03

A: Sulphur trioxide gas is obtained by the combustion of FeS2 (pyrites)  4FeS2  +   15O2…

Q: Ethylene oxide (C:H:O) is produced by the reaction of ethylene (C:H4) with oxygen: 2C:H4 + O2 –…

A: Write the reaction as follows: 2C2H4 +O2 → 2C2H4O 2 moles of C2H4 reacts with 1 mole of O2 and forms…

Q: Determine the fractional conversion of the excess reactant at maximum extent of the desired…

A: Conversion can be defined as the ratio of reactant used to reactant produced in the reaction. This…

Q: In a process for the manufacture of chlorine by direct oxidation of HCl with air over a catalyst to…

A: Basis: 100 moles of product stream The number of moles of components in the product stream nHCl,P =…

Q: Formaldehyde (CH20) is produced industrially by catalytic oxidation of methanol (CH30H) according to…

A: Given data: Formaldehyde is produced by catalytic oxidation of methanol. % excess air = 80 %…

Q: solve this problem by hand calculation. The production reaction for methyl acetate from methanol is…

A: It is given that a gas phase reaction takes place in a batch reactor to equilibrium…

Q: 50% by mass NaOH was diluted to 10% by the addition of water. The temperature of the 50% by mass…

A: Given: 50% at 65.6 °C by mass NaOH was diluted to 10% at 37.8 °C Enthalpy change by using NaOH/H2O…

Q: Methane (CH,) and propane (C,H,) react with each other to produce ethane (C,H) via a metathesis…

A: Given that, The total number of moles fed to the reactor nF = 100 moles The number of moles of…

Q: solve this problem by hand calculation. The production reaction for methyl acetate from methanol is…

A: It is given that a gas phase reaction takes place in a batch reactor to equilibrium…

Q: Calculate the AHrxn for the following reaction (Equation 4): C,H, (g) + O, (g) + CO, (g) + H,0 (g)…

A: Note: We are authorized to answer one question at a time, since you have not mentioned which…

Q: 1. Ethylene dioxide is produced by oxidation of ethylene as per the following reaction: 1 C,H, +02 →…

A:

Q: In the manufacturing of chlorine, HCL and O2 are reacted to form Cl2 and H2O. Air is fed with 35%…

A:

Q: Q1. The gas-phase Reaction: 1/2 N₂ + 3/2 H₂ NH3 Is to be carried out isothermally. The molar feed is…

A:

Q: 1. Reaction stoichiometry: Consider the reaction for the complete combustion of butane (CH) in the…

A: a) balanced equation is 2C4H10 + 13O2 = 8CO2 + 10H2O

Q: NaOH (Caustic soda) may be produced in a process from the following reactions: CaCO3 = CaO + CO2…

A: ### 1. Write the overall reaction for NaOH production using salt (NaCl), limestone (CaCO3), and…

Q: Methane (CH,) and propane (C,H,) react with each other to produce ethane (C,H,) via a metathesis…

A: Note: We are authorized to answer three subparts at a time, since you have not mentioned which part…

Q: Ammonia can react with oxygen according to the following two reactions: 4 NH3 + 5 O2  →   4 NO + 6…

A: Whenever a reaction takes place, there may occur another reaction that is undesirable. Here, the…

Q: 13.7 mole Boron Trichloride (BCl3) enter a reactor with 52.4 mole water for the following reaction:…

A: Given that, Reaction: BCl3 + 3 H2O → H3BO3 + 3 HCl The number of moles of BCl3 fed to the reactor =…

Q: 4FES2 + 1502 2FE203 + 8S03

A: Sulphur trioxide gas is obtained by the combustion of pyrites (Fe2S) the main reaction for the…

Q: 2. Formaldehyde (FA) is produced by oxidation of Methanol (CH3OH) in a fixed bed reactor according…

A:

Q: Q2 Sulphur trioxide gas is obtained by the combustion of pyrites (FeS2) according to the following…

A:

Q: A regeneration column operates with 4 equilibrium steps, it is used to separate ammonia from an…

A:

Distillation

Distillation is a process/technique to separate more volatile components from less volatile components using the principle of relative volatility. In chemical engineering, distillation is one of the most common and important topics that is involved in almost every industry and process.