Q1: Calculate the dynamic viscosity of an oil, which is used for lubrication between a rectangular plate of size 0.75m x 0.55 m and an inclined plane with angle of inclination 45" as shown in figure 1. The weight of the rectangular plate is 0.5 kN and it slides down the inclined plane with a uniform velocity of 0.35 m/s. The thickness of oil film is 1.75 mm. Then, state the scope for this obtained viscosity? Rec anglar plabe -oil Inclined plane Figure 1

Q: Are you able to show an answer in terms of using formula from start to finish to get the answer…

A: Are you able to show an answer in terms of using formula from start to finish to get the answer…

Q: A part may be properly represented on an engineering drawing with as few views as: A. one B. two…

A: Please find the answer in the next page.

Q: From the following identify  the false statement . In general safety precaution the machine should…

A: Precaution and safety

Q: Help , Handwritten only. No Chatgpt

A:

Q: 2 ft 2 ft 3 ft A 6 ft

A:

Q: Orthographics: Add missing lines and complete any missing views. Draw the isometric

A: The missing lines of the given views are shown below.

Q: 1500# 1500# 1500# 1500# 12' K I

A: In this problem, following steps will be taken 1. Determine the reactions at the supports.' 2. Using…

Q: Select the correct statement about the notation circled in green and marked as letter C. Assume all…

A:

Q: Question attached

A: (a) Relative humidity is the ratio of the partial pressure of water vapour in the mixture to the…

Q: Draw the Mohr stress circles for the states of stress at a point given in the figures below. For (a)…

A: Draw the Mohr stress circles for the states of stress at a point given in the figures below.  To…

Q: Can you show the work but written out please so I can see the steps better.

A:

Q: 200 m The spool has a mass of 40 kg and a radius of gyration of k-0.65 m. If the 20 kg weight is…

A:

Q: I need answers for 7,8, and 9,

A: A 0.250”X0.250” square hole.

Q: C) What is the maximum possible mass flow rate that the pump can produce?

A:

Q: Consider the crank assembly of the figure. The bearings at points A and B are in good alignm…

A:

Q: Which of the following statements is CORRECT? Don't Know A force can be moved along its line of…

A: Given problem is

Q: The question is not answer fully. Please answer the second part of the question statement.

A:

Project Management Techniques

The guideways or the roadways that are undertaken to perform a project efficiently and all the tools required to accomplish the task are the general outlines for project management techniques.