Answered: Q1: An oil pipeline and a 1.3m³ rigid…

Q1: An oil pipeline and a 1.3m³ rigid air tank are connected to each other by a manometer, as shown in Fig. If the tank contains 15 kg of air at 80°C, the absolute .pressure in the pipeline

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: B2. An oil of specific gravity 0.88 is flowing through the pipe of diameter 30cm. one end of the…

Q: In the setup seen in the image, an oil tank's central circular opening is sealed off by a solid…

A: Given: The specific gravity of mercury, SGm = 13.6

Q: Determine the altitude of the atmosphere above sea level in meters if the atmosphere has an absolute…

Q: Q3. Determine the gauge pressure at point A in the figure shown. Is it higher or lower than…

A: The gauge pressure at point A is PA,gauge = 12281.62 Pa (vacuum). It is lower than Patmosphere.

Q: Show complete solution. Determine the gauge pressure at P in the figure below which shows a…

A: Pressure formula P = Po + ρgh

Q: 6. For the manometer shown, determine the pressure difference between Points A and B. (PA-PB) [3.69]…

Q: determine the height of the mountain.

A: Given: At sea level barometer reads 750 mm At Mountain level reads 745 mm Specific weight 12 N/m3 To…

Q: 4. You are designing a U-manometer to measure the differential pressure due to the flow of air. The…

Q: B2. An oil of specific gravity 0.86 is flowing through the pipe of diameter 30cm. one end of the…

Q: 6. You are a researcher at a company that makes pressure cookers, and you are in charge of designing…

A: Given Gauge pressure = 100kpa = 100 × 103 Pa Cross-sectional area = 5 mm2 = 5 × 10–6 m2 Mexico city…

Q: Oil (SG = 0.92) fills both pipe "A" and pipe "B" which are vertically separated by 24-inches. The…

Q: Figure 1 shows a fairly large U-tube manometer containing water (density p= 1000.0 kg.m³) and oil…

Q: (b) The gage pressure of the air in the tank shown in figure Q1(b) is measured to be 8 kPa and…

Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…

A: This numerical is the basic numerical of fluid mechanics. Concept used is variation of pressure with…

Q: 1. Water has a density of 1000- and seawater has SG of 1.024 and m gravitational acceleration at Om…

A: Given Data: Specific gravity of seawater, SG=1.024

Q: The manometer shown is connected to a chamber of air on the right at unknown pressure P₁ and is open…

Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…

Q: B2. An oil of specific gravity 0.74 is flowing through the pipe of diameter 30cm. one end of the…

A: As Given specific gravity of oil =0.74 So, Density of oil = 0.74×1000 Density of oil = 740 kg/m3 As…

Q: The system in the figure is in equilibrium. Calculate the gauge pressure (P g= … kPa) measured on…

Q: Determine the following: 1. Pressure at point A, B and C 2. Equivalent "h" of the fluid at…

Q: Two spherical of different size contain the same gas and are connected by means of a pipe with the…

Q: A large truck tire is inflated to a gauge pressure of 82 psi. The total area of one sidewall of the…

Q: Q2: For the pipeline system shown in Figure, determine the value of pressure at Oil SG 0.79 Psage…

A: Solution

Q: 2. Convert the following readings of pressure to kPa absolute, assuming that the barometer reads 760…

Q: Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains…

Q: Assuming the English units, the standard atmospheric pressure, Patm is 14.696 psi (abs). Assume the…

Q: The basic barometer can be used to measure the height of a building. If the barometric readings at…

A: Given Pressure at the bottom, Pbot = 29.7 Hg Pressure at the top, Ptop = 28.7 Hg…

Q: Shown in figure below, the manometer fluid of density 875 kg/m3 shows a column height difference of…

A: Given data the density of the manometric fluid (ρm) = 875 kg/m3 ∆h = 3 cm Po = 101 kPa To…

Q: Figure Q1 shows the tank containing 5 kg of air at an absolute pressure of 340 kPa and a temperature…

Q: Question Q:- Determine the force exerted on the cone curved surface. The liquid in the tank has a…

A: Given data specific weight of liquid (γ) = 27kN/m3absolute pressure of the air (Pa) = 151 kPa…

Q: If the PO2 is 100 mm Hg at one barometric pressure (760 mm Hg), what is the approximate PO2 if the…

A: given : Pb = 100 mm Ph = ?

Q: A tank containing helium has a manometer attached, as shown in the figure. The local atmospheric…

A: Let pHe = pressure of helium gas in the tank patm=100kPa g =9.81m/s2 As density of any fluid is not…

Q: Manometer and guage pressure are connected to one gas tank. If the atmospheric pressure is 100 kPa…

A: The problem is based on fluid mechanics and can be solved as :

Concept explainers

Work and Heat Transfer

It is generally related to thermal engineering which tells about the use, creation, conversion and transfer of heat energy between the systems. It is also considered that to transfer heat from one source to another, transfer of masses is also required. There are various mechanisms by which, transfer of heat takes place i.e. thermal conduction, convection, radiation or by change of phase. All these mechanisms have their own specific features which sometimes occur simultaneously within the same system.

Question

Q1: An oil pipeline and a 1.3m³ rigid air tank
are connected to each other by a
manometer, as shown in Fig. If the tank
contains 15 kg of air at 80°C, the absolute
. .pressure in the pipeline
Oil
1.3 m
Air, 30°C
SG=2.68,
It= 75 cm
Alt = 20 cm
3D
'D=4 mm
50°
Mercury
SG = 13.6

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Given

VIEW

Solution

VIEW

Page 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

h = 4 ft F 2 ft A hemispherical glass bubble is installed in the side of a tank as a viewing window with its center 4 ft below the surface of the water. What is the magnitude of the vertical component of the force on the glass in lbs? The specific weight of water is 62.4 lbf/ft3.
多95 6 نقاط Two tank with the same fluid at * their base are separated by piston whose weight is (50 N) and (30 cm) diameter, as shown below. Calculate the gage pressure at point A, B and * .C respectively Piston B Air Air 50 cm 30 cm 25 cm E 30 cm Water 90 cm
the system in the figure is in equilibrium. Calculate the gauge pressure (Pg= … kPa) measured on the manometer at the bottom and the height of the mercury in the column (ZHg= …m)? You choose the density and gravity value of mercury, water. The value of the mass on the piston will be M=229kg.
For the given fluid heights and specific gravity, calculate the pressure difference at point B and A.
In a food industry two fluids are flowing in two separate pipe,in pipa A oil is flowing and in pipe B water is flowing. A U-tube differential manometer is connected to two pipes at A and B.Pipe A contains an oil of specific gravity {s} and pipe B carrying water.If the pressure at point A is 160 KN/m2. Find the pressure at point B for the following data h1=12 cm, h2=5 cm and h3=22 cm
Please show ALL calculations step by step
A closed vessel contains air at a pressure of 160 kN/m2 gauge and temperature of 30?C. The air is heated at constant volume to 60?C when barometric pressure is 100 kpa. What is the final gauge pressure?
The system in the figure is in equilibrium. Calculate the gauge pressure (Pg= … kPa) measured on the manometer at the bottom and the height of the mercury in the column (ZHg= …m)? You choose the density and gravity value of mercury, water. The value of the mass on the piston will be M=229kg.
Q1: From Figure 1, the tube and the tank are open to the atmosphere. If L is 2.13 m, what is the angle of tilt 0 of the tube? Oil 50 cm Figure 1 SG = 0.8 Water 50 cm SG = 1.0
Fig shows a U-tube differential manometer connecting two pressure pipes at A and B. Pipe A contains a liquid of specific gravity 1.7 under the pressure of 107 kN/m?. The pipe B contains oil of specific gravity 0.5 under the pressure of 216 kN/m2. Find the difference of pressure measured by mercury as fluid filling U-tube in mm. The value of x and y are 2.4 m and 1.1 m respectively. Pe S, X \Mercury The Mercury level difference ( h ) in mm
Both a and b otherwise skip please i will upvote for sure