Q1/ A- The current in the circuit was measured by measuring the voltage drop across a resistance of 40 N. The voltmeter reading was 95 V. Later it is found that the actual value of the resistance was 0.22 greater than the specified value. Also, the voltmeter reading was 0.95V greater than the true value. a. What is the apparent value of circuit current? b. The error in the measured current in percent of the measured value and in ampere.

Q1/ A- The current in the circuit was measured by measuring the voltage drop across a resistance of 40 N. The voltmeter reading was 95 V. Later it is found that the actual value of the resistance was 0.22 greater than the specified value. Also, the voltmeter reading was 0.95V greater than the true value. a. What is the apparent value of circuit current? b. The error in the measured current in percent of the measured value and in ampere.

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

WHAT IS THE RESISTANCE AND THE TOLERANCE VALUES OF THE RESISTOR BELOW, WHICH COLOR CODES ARE GREEN= BLUE-GREEN-GOLD (VALUE 10%)
Best choice
4. Four cells each of 2.10 volt internal emf are parallel connected together to make a battery. The internal resistances are 0.004, 0.005, 0.003 and 0.0025 ohm. Calculate for parallel connections: (a) internal emf and resistance of the single equivalent cell (b) current for a terminal voltage of 1.95 volts, (c)current in each cell
Show how Ohm’s Law may be applied in three ways varying two factors and maintaining one as constant.
compute the IC SATURATION CURRENT IF BCE IS EQUAL TO 0.4V
Problem 19. The current flowing through a resistor of 5 k2 ±0.4% is measured as 2.5 mA with an accuracy of measurement of +0.5%. Determine the nominal value of the voltage across the resistor and its accuracy.
PROBLEMS 1. A four-band resistor has a tolerance +5% and has a maximum resistance of 4.2 MO. Determine the minimum resistance, the resistor rating, and the resistor color code.
What is the effect of decrease in voltage at constant resistance on a current according to ohms law
Voltmeter can measure DC current a. O b. only DC voltage Oc only AC voltage both DC and AC voltage d.
26
UPVOTE WILL BE GIVEN. PLEASE WRITE THE SOLUTIONS LEGIBLY. NO LONG EXPLANATION NEEDED. ANSWER IN 2 DECIMAL PLACES.
A 50 μA basic D'Arsonval movement with an internal resistance of 500 is to be used as a voltmeter. The value of the multiplier resistance required to measure a full-scale voltage range of 0-5 volts is?