Q1/ A solution was prepared dissolving 329 mg of K,Fe(CN), in sufficient water to give 750 ml. calculate .'a) the molar concentration of K) .b) The mass/volume percentage of K,Fe(CN),) the number of millimoles of K' in 50.0 ml of this © .solution .d) the concentration of [Fe(CN),]* in ppm) K=39 Fe=56 C=12 N=14

Q1/ A solution was prepared dissolving 329 mg of K,Fe(CN), in sufficient water to give 750 ml. calculate .'a) the molar concentration of K) .b) The mass/volume percentage of K,Fe(CN),) the number of millimoles of K' in 50.0 ml of this © .solution .d) the concentration of [Fe(CN),]* in ppm) K=39 Fe=56 C=12 N=14

Fundamentals Of Analytical Chemistry

9th Edition

ISBN:9781285640686

Author:Skoog

Publisher:Skoog

Chapter13: Titrations In Analytical Chemistry

Section: Chapter Questions

Problem 13.30QAP

See similar textbooks

Similar questions

A solution is made by dissolving 34.0 g of NaCl in 100 g of H2O at 0C. Based on the data in Table 8-1, should this solution be characterized as a. saturated or unsaturated b. dilute or concentrated
A patient has a “cholesterol count” of 214. Like manyblood-chemistry measurements,this result is measured inunits of milligrams per deciliter (mgdL1). Determine the molar concentration of cholesterol inthis patient’s blood, taking the molar mass of cholesterolto be 386.64gmol1. Estimate the molality of cholesterol in the patient’sblood. If 214 is a typical cholesterol reading among men inthe United States, determine the volume of such bloodrequired to furnish 8.10 g of cholesterol.
Some lithium chloride, LiCl, is dissolved in 100 mL of water in one beaker, and some Li2SO4 is dissolved in 100 mL of water in another beaker. Both are at 10 C, and both are saturated solutions; some solid remains undissolved in each beaker. Describe what you would observe as the temperature is raised. The following data are available to you from a handbook of chemistry:
Calcium chloride, CaCl2, has been used to melt ice from roadways. Given that the saturated solution is 32% CaCl2 by mass, estimate the freezing point.
The freezing point of 0.10 M KHSO3 is -0.38C. Which of the following equations best represents what happens when KHSO3 dissolves in water? (a) KHSO3(s)KHSO3(aq) (b) KHSO3(s) K+(aq)+HSO3(aq) (c) KHSO3(s) K+(aq)+SO32(aq)+ H+(aq)
Sodium chloride (NaCl) is commonly used to melt ice on roads during the winter. Calcium chloride (CaCl2) is sometimes used for this purpose too. Let us compare the effectiveness of equal masses of these two compounds in lowering the freezing point of water, by calculating the freezing point depression of solutions containing 200. g of each salt in 1.00 kg of water. (An advantage of CaCl2 is that it acts more quickly because it is hygroscopic, that is. it absorbs moisture from the air to give a solution and begin the process. A disadvantage is that this compound is more costly.)
You make 20.0 g of a sucrose (C12H22O11) and NaCl mixture and dissolve it in 1.00 kg water. The freezing point of this solution is found to be 0.426C. Assuming ideal behavior, calculate the mass percent composition of the original mixture, and the mole fraction of sucrose in the original mixture.
Refer to Figure 13.10 ( Sec. 13-4b) to answer these questions. (a) Does a saturated solution occur when 65.0 g LiCl is present in 100 g H2O at 40 C? Explain your answer. (b) Consider a solution that contains 95.0 g LiCl in 100 g H2O at 40 C. Is the solution unsaturated, saturated, or supersaturated? Explain your answer. (c) Consider a solution that contains 50. g Li2SO4 in 200. g H2O at 50 C. Is this solution unsaturated, saturated, or supersaturated? Explain your answer. Figure 13.10 Solubility of ionic compounds versus temperature.
Solutions Introduced directly into the bloodstream have to be isotonic with blood; that is, they must have the same osmotic pressure as blood. An aqueous NaCl solution has to be 0.90% by mass to be isotonic with blood. What is the molarity of the sodium ions in solution? Take the density of the solution to be 1.00 g/mL.
Explain the trends in solubility (grams per 100 mL of water) of the alkali-metal fluorides and permanganates.
Aqueous solutions introduced into the stream y injection must have the same osmotic pressure as blood; that is, they must be isotonic with blood. At 25C, the average osmotic pressure of blood is 7.7 atm. What is the molarity of an isotonic saline solution (NaCl in H2O)? Recall that NaCl is an electrolyte; assume complete conversion to Na+ and Cl- ions.
A solution, prepared by dissolving 9.41 g NaHSO3 in 1.00 kg water, freezes at 0.33 C. From these data,decide which of these equations is the correct expressionfor the dissociation of the salt. (a) NaHSO3(aq)Na+(aq)+HSO3(aq) (b) NaHSO3(aq)Na+(aq)+H+(aq)+SO32(aq)