Q.8) In a large autonomous system (AS) with hundreds of routers, a network administrator is tasked with implementing a routing protocol that can provide the best path selection and also dynamically react to network changes. Which protocol would be the most suitable for an internal large-scale network that requires efficient path selection, fast convergence, and the ability to handle a large number of routers from given options? A) RIP (Routing Information Protocol) B) OSPF (Open Shortest Path First) C) BGP (Border Gateway Protocol) D) EIGRP (Enhanced Interior Gateway Routing Protocol)

Q.8) In a large autonomous system (AS) with hundreds of routers, a network administrator is tasked with implementing a routing protocol that can provide the best path selection and also dynamically react to network changes. Which protocol would be the most suitable for an internal large-scale network that requires efficient path selection, fast convergence, and the ability to handle a large number of routers from given options? A) RIP (Routing Information Protocol) B) OSPF (Open Shortest Path First) C) BGP (Border Gateway Protocol) D) EIGRP (Enhanced Interior Gateway Routing Protocol)

Database System Concepts

7th Edition

ISBN:9780078022159

Author:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Publisher:Abraham Silberschatz Professor, Henry F. Korth, S. Sudarshan

Chapter1: Introduction

Section: Chapter Questions

Problem 1PE

See similar textbooks

Similar questions

If you were in charge of the administration of a network, in what kinds of scenarios would you employ static route configuration?
If you were in charge of network management, under what circumstances would you choose to adopt a static route configuration?
Outline the pros and cons of connectionless protocols, and how they stack up against their more traditional counterparts, connection-based protocols.
Comparing connectionless protocols to connection-based protocols, as well as connection-based protocols to connectionless protocols, should be subjected to a cost-benefit analysis.
a) Explain the general functions provided by the Transport layer in the OSI reference model. In the TCP/IP implementation compare the differences between the two transport layer protocols, TCP and UDP. Give examples where each protocol would be used. b) Give details of the hardware and software required to configure a new managed switch or router for a network. Explain how the initial connection can be made to configure the device. What is the term given to this type of access.
1. Build a Router network which has three Generic Routers and totally of Six networks in it. From each Router the required switch shall be connected through Fast Ethernet port and the switch is connected to two users. On the whole there are '6' networks in the configuration. Along with the network diagram do the packet transfer in simulation mode and write results for three different combinations.
a) Briefly describe the process followed by link-state routing protocols building their routing tables. [b) Briefly discuss any FIVE characteristics of the Open Shortest Path First (OSPF) protocol. c) Explain FOUR similarities between RIPv2 and OSPFv2.
A 1500 byte message is sent over the network using a protocol stack with HTTP, TCP, IP and Ethemet. Each protocol header is 20 bytes long. The percentage of the network bandwidth "on the wire" is wasted due to the overhead is (in %).
Explain the concept of routing protocols in networking. How do dynamic routing protocols like OSPF and BGP work, and what are their respective use cases?
Investigate, analyse, and contrast the three most frequent methods of route planning All of the routing techniques mentioned above are instances of distance-vector routing.
Explore the concept of routing protocols in detail, including their role in determining the best path for data in a network.