??? Q.42MASS FLOW AT A PIPE JUNCTIONConsider the steady flow in a water pipe joint shown in the diagram.The areas are: A= 0.2 m. Az = 02 m, and A, = 0.15 m'. In addition,fluid is lost out of a hole at 9. estimated at a rate of 0.1 m'is. Theavcrage speeds at sections @ and 3 are V =5 mis and V3=12 mis.respectively. Find the velocity at section30Given: Steady flow of water through the device.A = 0.2 m A: = 0.2m A, = 0,15 mV = 5m/s V, = 12m/s p= 999 kg/mVolume flow rate at e =0.t m'sFind: Velocity at section a

Answered: Image /qna-images/answer/16f25cd1-2a7c-4170-9c72-115610234e00.jpg

Q.42 "MASS FLOW AT A PIPE JUNCTION Consider the steady flow in a water pipe joint shown in the diagram. The areas are: A= 0.2 m. Az = 02 m, and A, = 0.15 m'. In addition, fluid is lost out of a hole at a. estimated at a rate of 0.1 m'is. The avcrage speeds at sections @ and are V =5 mis and V3 = 12 mis. respectively. Find the velocity at scction . Given: Steady flow of water through the device. A, = 0.2 m A: = 0.2m A, = 0,15 m V = 5m/s V = 12m/s p= 999 kg/m Volume flow rate at =0.t m's Find: Velocity at section

Q.42 "MASS FLOW AT A PIPE JUNCTION Consider the steady flow in a water pipe joint shown in the diagram. The areas are: A= 0.2 m. Az = 02 m, and A, = 0.15 m'. In addition, fluid is lost out of a hole at a. estimated at a rate of 0.1 m'is. The avcrage speeds at sections @ and are V =5 mis and V3 = 12 mis. respectively. Find the velocity at scction . Given: Steady flow of water through the device. A, = 0.2 m A: = 0.2m A, = 0,15 m V = 5m/s V = 12m/s p= 999 kg/m Volume flow rate at =0.t m's Find: Velocity at section

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

3Q)Give the name of the tool / Equipment and write the use of it.
how many different ways are there to arrange six people in a round table?
Help me to understand the structural theory principles. Thankyou
! Fill the blanks with correct answer for each of the following: 4- Any member with two nodes subjected to many types of loads can be classified as 5- Roof thickness specified at dialog box to define the material properties is available under element. button. ......
What is the difference between volume measurements and capacities?
show your manual soulution
What is the use of die stock.
What kinds of changes can be made in the work?
Don't copy from other experts answer. Note: Give me right answer with explanation. Section lining or crosshatching is also known as a …? A. Section pattern B. Hatch pattern C. Section-line pattern D. Phantom-line pattern
What is foot bridge and its functions?
Who created UML and when was it created?
Write the factors that will affect the ultimate choice of the material?