Q.27: For the circuit shown in figure beside, derive the current equation in each branch and calculate the total consumed power in the circuit if the total current is: (i=10+4sin500t+2sin 1500t) Amp. (Ans.: İL=10+3.36sin(500t-15°)+1.4 sin(1500t-28.2° A Pr=436W) iT 102 4mH :250uF ic=1.2sin(500t+49.2°)+1sin(1500t+42.9°A.

Q: Find Vout in terms of waveform generator.

A: The derivation of Vout in terms of waveform generator has been derived. A detail explanation has…

Q: Project # 2: Give the following AC circuit (take note that L1 & R2 are in series but parallel with…

A:

Q: D. Consider the folowing circuit. Determine the following values if Vz-10v, Izx=2mA, PZM=250m Watt:…

A: In this question, we need to determine the Voltage across resistance Rs and supply voltage Vsource…

Q: *30. Find the average power loss and power factor for each o the circuits whose input current and…

A: In this question voltage and current is given....We have to find out average power and power…

Q: Please indicate if the following system is controllable 1 - 1.5 JLX2.

A: For controllable rank (B:AB) should be equal to n ,Here n is 2.

Q: Q1: For the network of figure Determine Zi ,Zo, Av, and A, by using the complete hybrid equivalent…

A:

Q: A1. Use the AC circuit shown in Figure 1 to calculate the following. 10 20 Amp. 1₁-1960 720 Figure…

A:

Q: Q3] Design a circuit to produce an average voltage of 27V across a 102 load resistor from a 70V ms…

A:

Q: 1. Determine the current of each line and the neutral current and measure the total power supplied…

A: Given: 3 phase 4 wire star connected load ZR= 950 ohm resister in series with 3 H inductor ZB = 1950…

Power Measurement

According to Blondel's theorem, the total power is measured with one less number of wattmeters than the number of wires present in the system. So, a single-phase and two-wire system will require one wattmeter and a single-phase and the three-wire system will require two wattmeters, and a three-phase and the three-wire system will also require two wattmeters and a three-phase and the four-wire system will require three wattmeter devices. The wattmeter is a device that measures power using one voltage and one current input as shown in the above figure. Multiple current or voltage input pair cables are used by many power analyzers and digital storage oscilloscopes (DSOs) for measuring watts, in effect within a single instrument acting as multiple wattmeters. It is possible to measure three-phase and four-wire power with one correctly specified power analyzer.