Q.2 A/Use Khosla theory to check safety against uplift pressure at points F, K, G, J and H 149.6m 0.5 m 148.5m 147m 146m 1m 145m 1m F H 2m 143.25m 6m 8.5m 2.5m 2m 9m 140m 140m B/is the value of uplift pressure at K equal to uplift pressure at G ?Why ? If you applied Lane or Bligh could the values be equal ? How can you fix this ?

Q: Calculate the super elevation ё for a railroad track having a rail guage of 1560 mm for a 625 meter…

A:

Q: The figure shown below illustrates a continuous 1-way slab with four equal spans. The centre-…

A: Note : Since you have asked multiple questions, we will solve the first question for you. If you…

Q: Given the Dam shown in the figure. Determine the factor of safety against sliding and the factor of…

A:

Q: Determine the mean spring constant ka of a rail support of an existing track section, the rail is…

A:

Q: Load Analysis: A floor beam is used to support the 3-m width of a reinforced concrete slab having a…

A: A reinforced concrete member can sustain these stresses for long periods by combining steel tensile…

Q: The section of the masonry dam is shown in Figure 3a. If the uplift pressure varies uniformly from…

A:

Q: The motor draws in the cable at C with a constant velocity of Vc = 4 m/s. The motor draws in the…

A: vc=4 m/saD= 3.5 m/sec2VD=0 when , t=0

Q: Problem 2. Determine the minimum horizontal force P required to begin sliding the crate up the…

A: ASKED: To compute the minimum horizontal force P required to cause the motion of the crate up the…

Q: An overhang beam is given in the figure. Which of the following bending moment is correct for the…

A: For a given overhang beam, as shown below,To check which is correct bending moment out of 4 options

Q: 3 m 3 m 1.2 m A B (b) Elevation plan

A:

Q: 3 m 3 m 3,7m Given reinforced concrete Hospital Building (framed structure) is going to be…

A: Step 1:Step 2:Step 3:Step 4:

Q: Using the assigned wide-flange section in the picture having Fy=260 MPa, determine the value of “Pn”…

A: Solution: Given: fy = 260 MPa Span = 30 ft

Q: A 5 m long cantilever concrete beam is supporting a uniformly distributed load of w = 4 kN/m and a 4…

A: Beam with loading is as shown

Q: 3.13 3.14 In Problems 3.13 through 3.17, compute the corrected horizontal distance (assume normal…

A: 3.13) h = 6.35 feet            Lo = 198.61 feet  Cs (correction due to slope) = -h2/2Lo

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.