Q. The following results were obtained from a CBR test on a compacted subgrade soil. Calculate the CBR value for the soil. Do you recommend to use it as subbase? Illustrate your answer? Penetration (mm) Load (KN) 0.625 0.15 1.25 0.18 1.875 0.40 2.5 0.73 3.75 1.32 1.80 7.5 2.34 10 2.53 12.5 2.91 Standard Loads: 2.5 mm .......13.36 KN 5.0 mm .......,19.96 KN

Q. The following results were obtained from a CBR test on a compacted subgrade soil. Calculate the CBR value for the soil. Do you recommend to use it as subbase? Illustrate your answer? Penetration (mm) Load (KN) 0.625 0.15 1.25 0.18 1.875 0.40 2.5 0.73 3.75 1.32 1.80 7.5 2.34 10 2.53 12.5 2.91 Standard Loads: 2.5 mm .......13.36 KN 5.0 mm .......,19.96 KN

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

The following data were obtained from sand-cone experiment where a volume of a certain soil is replaced with a sand in order to find the density of the soil. Density of sand used in test = 1.3 g/cc Wt. Of soil excavated from the pit = 925 g Wt. of sand filling the pit = 675 g Water content of natural soil = 15% Specific gravity of Solid = 2.7 a) Determine the wet density of the soil in g/cc. b) Determine the dry density of the soil in g/cc. c) What is the porosity of the soil?
The table below shows the results from the specific gravity (S.G.) test performed in a soil laboratory including twenty samples of sand. Determine the Coefficient of Quartile Variation
2b. The following data was obtained from Sieve Analysis conducted at a Soil Lab. Using the data given in Table 02 determine: Table 02: Sieve analysis data of coarse-grained soil i. ii. iii. + Sieve Opening (mm) 20 10 4.75 2.36 1.18 0.6 0.3 0.15 0.075 Pan Mass of Soil Retaining on each Sieve (g) 5.21 20.21 180.21 360.21 280.11 70.11 50.21 17.21 10.11 8 Percentage of clay, silt, sand and Gravel in the soil sample Uniformity coefficient and coefficient of curvature Classify the soil according to BS soil classification system
A sieve analysis of a soil sample of weight (400 g) was performed and the results were as follows. Required 1-Find the% passing and plot the gradient gradient. 2-Find the regularity coefficient and the Cu gradient
The following data represent the results obtained from the specific gravity (S.G.) test performed in a soil laboratory including twenty sand samples. The value of mode is 2.65. * Specific Gravity Number of Samples 2.30-2.39 1 2.40-2.49 2.50-2.59 2.60-2.69 2.70-2.79 2.80-2.89 1 47
Q': A- Classification tests have been performed on a soil sample and the grading curve that shown in (Fig. 1) and Atterberg limits obtained. Classify the soil using the USCS? L.L=32 and P.L=26 100 80 60 40 20 Fig. 1 0.1 1 Particle size (mm) 0.0001 0.001 0.01 10 100 % Finer
Q1: Use the USCS to Classify the soil sample with the following data: % passing 4.75 mm Sieve = 64 % passing 75- Sieve =4 Uniformity Coefficient= 7.5 Coefficient of Curvature=2.7 Plasticity index = 2.5 Solution: Q2: Use the USCS to Classify the soil samples with the following data dalla Soil LL PL Group Symbol Soil Name 15 35 25 ABC 8. ८८ 25 45 65 2-Seepage velocity (m/s) = 70 3- Flow rate in (m3/s) = oss and dry ng www Parmbly & volume change decrease Campering wes Toughness and dry strength dease Presby & val change in 10 20 30 40 50- 60 Liepakt. 70 80 Atra -0.73 (W₂-201 90 Q3: For the soil shown below the hydraulic conductivity is (3 m/day). The sample diameter is 1.5 m. The porosity is (30%). Find: 1- Flow velocity (m/s)== 100 110 120 Soil 4 m ITE
Following are the results of a field unit-weight determination test performed on the same soil by means of the sand cone method: -Calibrated dry unit weight of Ottawa sand = 15.4019 kn/m3 -Calibrated weight of Ottawa sand to fill the cone = 5.3496 N -Weightof jar + cone + sand (before use) = 74.451 N -Weightof jar + cone + sand (after use) = 46.886 N -Weight of moist soil from hole = 29.509 N -Moisture content of moist soil = 10.21% DETERMINE AND SHOW COMPLETE SOLUTION 1. Dry density of compaction in the field in kg/cu.m.
No.3
Problem 1.2.1: The data below were obtained with tension device from two soils of unknown texture. Suction (en) 0 10 20 50 100 300 1000 10,000 20,000 100,000 Water content Soil A Soil B 44 44 43.9 38 22.5 12.5 7 5.2 5.1 4.9 52 52 52 31 48 32 20 13.5 13 128 Answer the following questions: 1. Which soil has a higher porosity? 2. What is the bulk density of the two samples? (Assume that the density of solids comprising both samples is ps = 2.65gm/cm³.) 3. What is estimated water content in the two samples at suction 15cm?
The results of a compaction test on the sample of soil that are to be listed are to be used for an embankment on a highway project are listed below . Determine the maximum dry unit weight of compaction and the optimum moisture content. The table is shown in image