Q. The ends of the cylinder are made of conducting discs and the space between these discs are filled with an inhomogeneous ohmic medium whose conductivity o = L/(z+1). Where L is the separation distance of the discs. A d-c voltage Vo is applied across the discs as shown on the right. Determine L a) The total resistance between the discs b) The surface charge densities on the discs c) The volume charge density and the total amount of charge between the discs y

Q. The ends of the cylinder are made of conducting discs and the space between these discs are filled with an inhomogeneous ohmic medium whose conductivity o = L/(z+1). Where L is the separation distance of the discs. A d-c voltage Vo is applied across the discs as shown on the right. Determine L a) The total resistance between the discs b) The surface charge densities on the discs c) The volume charge density and the total amount of charge between the discs y

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

2. answer with complete and detailed solutions.
A spherical conducting shell has a charge of 22 uc 14- on its outer surface and a charged particle in its hollow. If the net charge on the shell is 16 µC ,what is the charge of the particle? -6 uC A) 38 µC B) -38 uC 6 µC E) 0
for an infinite line charge along x-axis, the maximum firled strenght experienced by a test charge at (y,z) is? a. at distance equal to x b. at distance equal to y c. at distance equal to z d. depends on the line charge density
A coadal cable has a surface charge density of-10 Cim, at the outer conductor and 10 Cim at the inner conductor The inner radius is 2 m, outer Xradius is 6 m and length of this coaxial cable is 100 m. What is the E field inside the inner conductor in between two conductors and outside of the outer conductor (You can leave the expression in terms of permittivity)
Two small identical conducting spheres have charges 2 x 10° coulomb and -0.5 x 10° Coulomb respectively. If they are brought together and then separated by 4 cm. What is the force between them?
B10
(1) THE FOLLOWING QUESTIONS ARE BASED ON THE INFORMATION GIVEN HERE. A rod of semiconducting material of length L = 7 m and cross-sectional area A = 2.5 mm2 lies along L. The material obeys Ohm's law, and its resistivity varies along the %3D the x-axis between z = 0 and z = rod according to p= po 1 where po L? 2.5 x 10 4N. m. The end of the rod at a = 0 is at a %3D potential Vo = 40 V greater than the end at a = L. A) What is the total resistance, in units of 2, of the rod? Answer: B) What is the current, in units of miliamperes, in the rod? Answer: C) What is the electric potential, in units of Volt, in the rod at z = L/2? Answer:
Please provide answers for the question in the picture
A sphere has radius of R. The sphere also has a uniform charge of 4Q. There is a point charge of -Q at sphere's center. Derive an equation for E at points where the radius is less then R.
A round conductor has a radius and a total charge of 0.1 m and 20uC. If points A and B are 15 cm and 5 cm from the center of the conductor. If a test charge, q = 25mC, is to be moved from A to B, find the potential at A, electric potential energy at B, work done from moving the charge, and the rate of change (potential) due to to length in the conductor
2. A hollow cylinder of length 2 m has its cross section as shown in Figure below. If the cylinder is made of carbon (o = 105 mhos/m), determine the resistance between the ends of the cylinder. Take a = 3 cm, and b = 5 cm.
a rod of semiconducting meterial of length L = 2 m and cross-sectioanal area A=5mm2 lies along the x axis between x=0 and x=L. the meterial obeys Ohm's law, and its resistivity varies along the rod according to p=p0 (1-(x2/L2)) where p0=4,5 * 10-4 ohm*m. the end of the rod at x=0 is at a potential V0= 30 V greater than the end at x = L. a)what is the total resistance, in units of ohm, of the rod ? b)what is the current, in units of miliamperes in the rod? c)what is the electric potential, in units of Volt in the rod at x=L/2 ? d)what is the electric field magnitude E, in units of V/m, in the rod at x=L/2 ?