Q. 2. A Figure 2 shows an isometric view of an object. Draw to a full size scale the following views in first angle projection. (a) Sectional front view, (b) Top view and (c) Sectional side view

Q: Problem C 1. Recreate the ORTHOGRAPHIC VIEWS as shown below. 2. Draw the HALF-SECTION VIEW in the…

A: Orthographic views:- These are the views of a 3D diagram representing as 2 dimensional views for…

Q: 2.

A:

Q: Question 1 (a) The three planes of 'orthographic' projection of an object are presented in Figure…

A: Please find the solution below

Q: Draw the Isometric views of these ones

A: Given:Find:Isometric view

Q: 4. ㅂ 1

A:

Q: Based on the front view and the right side profile view shown, use any projection method to find the…

A: Given Front and right view of the object To find Top and isometric view

Q: Select the best top view (3rd angle projection) of the following drawing: O a Ob Od OC O None of the…

A:

Q: Assuming that same 20wt% Cu alloy was then cooled slowly from 780 to 778 °C, determine the phase…

A: Given data: The weight percent of copper alloy is, CO = 20 wt.%.   The temperature 778oC, is just…

Q: isometric view of a cube with edges of 50 mm using isometric projection.

A:

Q: 40 30 20 20 100

A: front view

Q: Q. 2. A Figure 2 shows an isometric view of an object. Draw to a full size scale the following views…

A: A Figure 2 shows an isometric view of an object. Draw to a full size scale the following views in…

Q: Given the Top and Front Orthographic views of an object, construct a One-point Perspective view in…

A:

Engineering Drawing

Technical drawing has been around since ancient times. As in the ancient Renaissance, complicated drawings were created, including Leonardo da Vinci's drawing. Modern engineering drawing, including its specific orthographic projection with scale conventions, began in Europe (France) during the early stages of Industrialization. L.T. C. Rolt also made some of Marc's drawings for its block-making machinery (in 1799) that also may have contributed significantly to British engineering technology. Since he learned the art of presenting three-dimensional(3D) items in a two-dimensional(2D) plane, as we now term mechanical drawing.