Q: The table below represents the elevation-area curve for a reservoir, the maximum storage is 32 000 000 m', the elevation of powerhouse (turbine) =65m, the normal pool level is 74.5m, and the height of the dam is 13m, Determine: 1. The elevation-area-volume curve, Draw the storage zone of the reservoir with elevations

Q: Determine (a) the x, y, and z components of the 750-N force, (b) the angles 0,, 0, and 0, that the…

A: first, draw the vertical and horizontal components Then calculate the scalar components The force…

Q: Convert the following and round off to nearest hundredth if necessary. 10ft³ to cm³

A:

Q: The two wires are tied to the ring at A. Find P and the tension in the two wires knowing the…

A: Suppose tension in string AB = TB→                 tension in string AC = TC→ weight of sphere W→ =…

Q: Find the moment about point A due to the two forces using two different methods by a) Breaking each…

A:

Q: as pule a5 pyle PL 6x1 6 pulg 2<3x3x1/2 15 pulg I pule -3 pulg-3 pulg Angular 3x3x:A=2.75 in :j =…

A: For any compound section to find the centroid we divide that compound section into basic elements…

Q: 1. From the given figure shown below, determine the centroidal moment of Inertia (Ixo and lyo) of…

A:

Q: Problem 2.7 - Find the x, y, and z components of the 26-N force shown and find its direction…

A: Given:F=26 NLet,θ=Angle made by the 26 N force with horizontal.Then, from the figure,sinθ=513 and…

Q: A 100m tape is 100m long at 15 kg, at 25 kg tension it is used to measure the length of the line.…

A:

Unit Conversion

Standard units are also called SI units. SI units are used for measuring a physical quantity satisfying certain conditions. There are two types of units: fundamental units and derived units. Fundamental units are physical quantities that are independent, that is, they do not depend on other quantities like mass, length, or time. There are plenty of quantities in our lives which need to be measured and compared. Measuring is the comparison of a particular physical quantity with its reference value. A unit is a measure of a fixed physical quantity. A physical quantity is the product of a unit and the numerical value we need to compare with.