Q- In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.) of the starting station is 100.000 m, the R.L. (in m) of the last station is

Q- In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.) of the starting station is 100.000 m, the R.L. (in m) of the last station is

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Related questions

Q: If the Reduced Level (R.L.) of BenchMark (B.M.) is 100.00 m, the back sight is 1.215 m and the…

A: RL of benchmark = 100 mBack sight = 1.215 mForesight = 1.870 mTo Find :RL of forward station :

Q: A stadia measurement was undertaken with theodolite having an internal focusing telescope and a…

Q: An ESP must treat 800,000 acfm with 99.1% efficiency. Assuming an effective drift velocity of 14…

A: Given: The discharge is 800,000 ft3/min. The efficiency is 99.1%. The effective drift velocity is 14…

Q: differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ft) and losed on BM…

A: StationB.SH.IF.SElevationAdjusted Elevation(R.L)B.M…

Q: n a levelling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m…

A: Given data: The sum of back sights, ∑BS=3.085 m The sum of fore sights, ∑FS=5.645 m. Reduced level…

Q: A line of levels is run from BM1 to BM2, which is 12 km long. Elevation of BM1 was found out to be…

A: Elevation of BM1=100m Elevation of BM2 =125.382m To find corrected elevation of BM2

Q: A line of levels 15 km is run on a soft ground to check the elevation of BM-2 which has been found…

Q: Station B.S. 71cm H.I. F.S. Elevation 100 BM1 Remarks TP1 TP2 66cm-72cm 32cm-37cm 185-189.5 291-294…

Q: .(b) If the sensitivity of the bubble tube of a level is 30 of are per division, determine the…

A: Given data , Sensitivity of the bubble tube = 30" m= 1 Sensitivity of the bubble tube =

Q: Station B.S. 71cm Н. F.S. Elevation Remarks BM1 100 TP1 TP2 ТРЗ 66cm-72cm 32cm-37cm 34cm-36cm…

A: We will use Height of instrument method HI = RL of that station +BS of that station RL = HI of…

Q: Following observations were taken for determining the R.L. of station A. Instrument -station Height…

Q: The following readings were taken during a leveling process:1.05, 1.30, 1.42, 1.52, 0.75, 1.35,…

A: The readings taken during levelling process are: 1.05, 1.30, 1.42, 1.52, 0.75, 1.35, 1.34, 1.75,…

Q: 13 Differential leveling runs from BM10 to BM11 at a distance of 7.5 km. It was observed that the…

A: Solution:-Given,Distance=7.5km=7500mThe leveling rod was inclined=6°The average BS…

Q: A surveyor conducts trigonometric leveling to determine the elevation of a target point P based on…

Q: Q3) leveling staff setup on a BM of elevation of 89.90 m is observed from point A where the three…

A: Solution: Inst. at Staff point V.A. Staff Reading A BM -5o32' 1.00,2.37,3.75 B +4o30'…

Q: Which one of the following is a significant error in leveling? а. Таре O b. Average level C. Reduced…

A: There are many causes of errors in levelling, among the above options given the significant error is…

Q: Q2) 1-Four stations C, A, B, and D were set out in a straight line such that CA = AB= BD = 30 m. A…

A: Given: CA = AB = BD = 30m level at C A1=2.135, B1= 1.823 level at D A2= 2.026, B2= 1.768 Required:…

Q: 10) Where the total station at point P, the slope distance and altitude angle to point Q were…

A: Given: @point P to point Q slope distance = 790.55 m Angle = -05o20'30'' Elevation of point Q =…

Q: The sum of negative departures exceeds that of the positive departures by 0.47 meter. The sum of the…

Q: 1. Given: STATION ELEVATION (m) DISTANCE SAD HILL 680 SAD hill to LOVE hill = 12km LOVE HILL 645…

A: (a) elevation diagram of sad hill and love hill

Q: Which type of leveling is carried out to get the rough idea about the profile of the ground in a…

A: Fly levelling is used to get rough idea about the profile of ground in short time. In fly levelling,…

Q: Calculate the leveling error in feet due to Earth curvature and light refraction (c + r) for the…

A: The question has asked to find out the levelling error due to Earth Curvature and light refraction.…

Q: Describe the procedure to adjust an optical plummet on a total station.

A: Following steps are followed for the set up of total station1. Set up the tripod approximately over…

Q: Q3) A leveling staff setup on point R of elevation (-8.79 m), is observed from point A where the…

A: Reduced level: The vertical distance between the survey point and the datum line is known as the…

Q: Problem 4: Jet Trajectory Assume the jet leaves the spray nozzle at 30° above horizontal, and…

Q: A benchmark (RL=20.345m) was observed as a backsight with a staff reading of 1.413m. Calculate the…

Q: The following readings were taken during a leveling process:1.18, 1.55, 1.50, 1.52, 0.85, 1.25,…

Q: Line Length(m) Azimuth DA 500 290° DC 2000 90° СВ 1000 90° AB ? ? Calculate the length and the…

A: The latitude of the line is defined as the project of a line along the north-south direction.…

Q: + Q3) A leveling staff setup on point R of elevation (-8.79 m), is observed from point A ,where the…

A: Introduction:- Reduction level:-The Reduced Level is the vertical distance between the survey point…

Q: While leveling across a river, the staves readings held at (R) and (S) from the instrument stationed…

A: Reciprocal levelling is used to determine the true difference in elevations of two points that are…

Q: A differential leveling circuit began on BM Hydrant (orthometric height 5869.31 ft) and closed on BM…

A: BM Hydrant =5869.31 ftBM Rock (orthometric height 5830.03 ft). Readings 2.28 (+S) on BM Hydrant,…

Q: The following consecutive readings were taken with a leveling instrument at intervals of 25 m.…

A: There are two methods of solving this problem. 1.Height of instrument method (HI method) 2.…

Q: A backsight is taken on a benchmark of rod reading of 1.30 meters, vertical angle of 22° 30’, and…

Q: The instrument used was a transit with an internal focusing telescope and a stadia interval factor…

A: As per our Honor code, we are allowed to attempt the first three sub parts. If you want answers for…

Concept explainers

Errors in surveying

An error in surveying is defined as the difference between two or more values of an identical quantity. However, the estimates are never accurate and there will always be a degree of variability regardless of the research tool or method used. These differences are known as errors that need to be reduced or eliminated to maintain certain levels of accuracy. Even if you carefully follow the prescribed test procedures, the considerations may contain errors.

Question

Q- In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have
been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.)
of the starting station is 100.000 m, the R.L. (in m) of the last station is

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Given data:

VIEW

Step 2: Calculation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, civil-engineering and related others by exploring similar questions and additional content below.

Similar questions

A transit with a stadia interval factor of 99.89 was set at C on the line between points A and B, the following stadia readings were observed. (draw the Instrument set up) If the stadia constant is 0.31 m determine the following: Length of line AB (horizontal). ANSWER: ____________________ If the elevation at B is 752m what is the elevation at B. ANSWER: ___________________
Reading staff 3.100 with distance 120m the Line of sight :inclined (+3). Corrected reading is 2.995m O 3.205m O 3.200m O 2.900m O
need fast and asap
Construction Surveying
In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.) of the starting station is 100.000 m, the R.L. (in m) of the last station is
Surveying
In a leveling work, sum of the Back Sight (B.S.) and Fore Sight (F.S.) have been found to be 3.085 m and 5.645 m respectively. If the Reduced Level (R.L.) of the starting station is 100.000 m, the R.L. (in m) of the last station is
A transit with a stadia interval factor of 100 was set up at C with elevation of 500m. and the following stadia reading were observed at points A and B: POSITION OF VERTICAL HAIR READINGS AZIMUTH ROD ANGLE UPPER (a) MIDDLE (c) LOWER (b) ROD HELD AT A 25°36' -25°35' 1.43 m 0.175 m 0.920 m ROD HELD AT B 305°40' +18°28' 2.022 1.854 1.686 If the stadia constant is 0.30m. determine the following: a. Elevation at points A and B HI at C is 1.00 m b. The distance of line AB c. Grade from point A to point B
In the two-peg of a dummy level, the following observation are taken. What is the difference in elevation between A and B? Answer: ____________ If the line of sight is not in adjustment, determine the correct rod reading on B with the instrument still set up at A. Answer: ____________