Q) Find the density of metallic body which floats at the interface of mercury of sp.gr 13.6 and water such that 40 % of its volume is sub-merged in * .mercury and 60% in water 24160 kg/m3 O 3020 kg/m3 O 12080 kg/m3 O 6040 kg/m3 O

Q) Find the density of metallic body which floats at the interface of mercury of sp.gr 13.6 and water such that 40 % of its volume is sub-merged in * .mercury and 60% in water 24160 kg/m3 O 3020 kg/m3 O 12080 kg/m3 O 6040 kg/m3 O

Elements Of Electromagnetics

7th Edition

ISBN:9780190698614

Author:Sadiku, Matthew N. O.

Publisher:Sadiku, Matthew N. O.

ChapterMA: Math Assessment

Section: Chapter Questions

Problem 1.1MA

See similar textbooks

Related questions

Q: Determine the dynamic pressure of 59 deg F air at atmospheric pressure moving at 67.2 miles per…

Q: It is estimated that 80 percent of an iceberg's volume is below the surface, while only 10 percent…

Q: A hollow iron cube filled with helium is placed in a container with water. The wall thickness is 1…

A: Concept Used:The concept used in the above question is Archimedes' principle, which states that an…

Q: B water mercury S-133 60 cm 60 cm 20 cm What is the pressure at the center of plpe l (kPa)

A: Given Data: The specific gravity of mercury, S=13.3

Q: a scuba diver with, tank, and gear has a mass of 78 Kg. The diver and gear displace a total volumen…

Q: An open-topped rectangular metal boat containing sand as a ballast floats on water. The boat has a…

A: Note: As per policy, we can solve the first question from the multiple questions. Please resubmit…

Q: Before immersion, the liquid was 75 mm deep. At what level will the solid cylinder float?

Q: A thin, circular, 0.860-kg disk of wood has a radius of 20.0 cm and floats on top of a cylindrical…

A: Solution: Assuming the density of the anti freeze=1050kg/m3 Weight of the wooden disk…

Q: Contrary to what you might expect, a solid metal ball can float on water due to the surface tension…

Q: (a) Find the buoyant force acting on the balloon, assuming the density of air is 1.29 kg/m3. kN…

A: The radius of the spherical weather balloon r=3.10 m The total mass of the balloon m=22.0 kg The…

Q: A 2-m3 volume of water is contained in a rigid container. Estimate the change in the volume of the…

Q: In Fig.the tank contains water and immiscibleoil at 20 ° C. What is h in cm if the density of the…

A: Given, The temperature of the water and immiscible oil, T= 20 °C the density of oil, ρo=898 kg/m3…

Question

Q) Find the density of metallic
body which floats at the
interface of mercury of sp.gr
13.6 and water such that 40 %
of its volume is sub-merged in
* .mercury and 60% in water
24160 kg/m3
3020 kg/m3 O
12080 kg/m3 O
6040 kg/m3

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 2 steps with 2 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, mechanical-engineering and related others by exploring similar questions and additional content below.

Similar questions

Bathyscaphes are capable of submerging to great depths in the ocean. What is the pressure at a depth of 5 km, assuming sea water has a constant specific weight of 10.1 kN m-³? Express your answer in kilopascals. The bathyscaphe contains several ballast tanks to regulate its buoyancy. If the dry mass of the bathyscaphe is 800 kg and its volume is 15 m³, the ballast tanks must contain what volume of seawater for the bathyscaphe to begin to sink? LF
There are various methods that can be used to calculate the hydrostatic force on a submerged surface. Which of the following statements are correct? (i) (iii) The pressure prism method gives good understanding of the fundamentals but it can only be used for plane surface uniform in the spanwise direction. The parallel axis theorem can be used for surface not uniform in the spanwise direction such as a circular or triangular plane surfaces, but it is limited to simple geometry where the second moment of area can be easily defined. The elementary area method can be used for any 2 or 3 dimensional surface as long as the geometric unit normal vector is known at any point on the surface. (A) (B) (C) (D) (i) and (ii) (i) and (iii) (ii) and (iii) All of the above The Eulerian frame of reference is commonly used in analyzing fluid problems instead of the Lagrangian frame of reference. The main differences between these 2 frames of reference are: (i) The steady motion in Lagrangian frame of…
The bottom of a steel "boat" is a 7 m ✕ 8 m ✕ 4 cm piece of steel (ρsteel = 7900 kg/m3). The sides are made of 0.480 cm thick steel. What minimum height must the sides have for this boat to float in perfectly calm water? The side height should not include the thickness of the bottom. (Answer in cm, thanks)
2. There is a liquid having density of Np below a liquid of density p (N is an unknown constant). A piston of a rectangular cross section (width H into the page) is attached to a completely submerged sphere of density e/3 and volume 4/2H3, with a pulley attachment as shown in the figure. The piston surface has a 45° angle with respect to the horizontal direction and a 90° angle with the pulley cable. It is measured that the within the piston is atmospheric. pressure (a) Identify all the forces applied to the piston surface, and mark them on a free body diagram. Accurately indicate their points of action. (b) Evaluate N if all the forces applied to the piston surface balance. Air P/3 2H g Piston surface Np H
When analyzing a sample of ore, a geologist finds that it weighs 2.00 Newtons in air and 1.13 Newtons when immersed in water. What is the density of the ore? What assumptions did you make to answer this question?
6. DETAILS A tennis ball has a volume of 141.00 cm³ and an average density of 275.00 What is the tennis ball's mass, in grams? g kg m³ O 73.37 N MY NOTES What amount of force would need to be applied to cause the tennis ball to be completely submerged in ethyl alcohol (Pethyl alcohol=806- the vertical direction (weight, buoyant force, and applied force). When writing the buoyant force, note that the ball will be fully submerged. What does this do to V?) 1.11 N 0.73 N 0.38 N 38.00 N 7337.36 N ASK YOUR TEACHER kg -)? (HINT: Set up a FBD and look at all the forces acting in
We calculated the mass of water in a large reservoir. We will now consider the pressure and force acting on the dam retaining water. The dam is 500 m wide, and the water is 80.0 m deep at the dam. (a) What is the average pressure on the dam due to the water? (b) Calculate the force exerted against the dam and compare it with the weight of water in the dam (previously found to be 1.96X10 N).
Design and conduct an experiment to measure the density of the following liquids: a. cooking oil b. engine oil c. water d. milk e. ethylene glycol (antifreeze) Express your findings in kg/m3, slugs/ft3, and lbm/ft3 for each liquid
please answer explaining in paragraph form why steel boats can float in water.
A rock weighs 60 N in air and has a volume of 2.5 x103 m³. The weight of the rock when submerged in water is