Q) Calculate velocity and flow rate of fluid (Water) in pipes. Also, determine the power of the pump, and the elevation of water in reservoir D. Finally draw E.G.L. of the following system. Ignore miner head losses. The height of energy at point C is 150 m. npump = 80% Pipe No. Diameter (m) Length (m) Friction factor (f) 1 0.2 1000 2 0.25 2000 0.025 3 0.10 250 4 0.15 500 120m E=? 100m A 120M Pump E

Q: Problem 7: The two pumps in problem 6 are now arranged in parallel. The static head is 40 ft. The…

A: Given that the two pumps are connected in parallel. The static head is 40ft. Hs = 40ft Diameter, D =…

Q: 3. Oil with sg = 0.86 is being pumped from a reservoir as shown. The pressure at point 1 to point 2…

A:

Q: Determine the discharge in liters/s of a new 1.0 m diameter cast iron pipe if the friction loss is…

A: Diameter, D =  1m Friction loss = 10 kPa Length, L = 100 m Specific gravity, S = 0.912 kinematic…

Q: View Policies Current Attempt in Progress The turbine shown in the figure below develops 100 hp when…

A: Determine (a) the elevation h, (b) the pressure difference across the turbine, (c) the flowrate…

Q: 7.30 FLUS For this refinery pipe, DA = 20 cm. Dg = 14 cm, and L= 1 m. If crude oil (S = 0.90) is…

A:

Q: Q4: A turbine is located in pipe No.2, shown in figure (4). If the turbine efficiency is (90%), what…

A:

Q: 64 A pelton wheel works under a head of 400 m. Frictional loss through the pipe flow is limited to…

A: A Pelton wheel turbine-Head of wheel  = 400 mLimitation of frictional loss = 10%The coefficient of…

Q: The 600 mm pipe shown conducts water from reservoir A to a pressure turbine, which discharges…

A: Head lost from A to 1 = 5 x velocity head in pipeHead lost from 2 to B = 0.2 x velocity head in…

Q: Given Water at 10°C flows at the rate of 970 L/min from the reservoir and through the pipe shown in…

A:

Q: Bernoulli. Water is siphoned from a large tank filled to a depth of 3m using a tube (Dr=0.6 cm) with…

A: Bernoulli's theorem : In fluid dynamics, Bernoulli's theorem describes the relationship between…

Q: Water is being discharged from an upper reservoir to a lower reservoir through a turbine (assume 80%…

A: Given  Discharge = 0.15 cumec Efficiency = 80%  Height difference = 197.3- 50 = 147.3 m To calculate…

Q: Water is pumped up from a reservoir to a smaller holding tank. If the flow rate through the pipe is…

A: NPSH is the net positive suction head, which is measured in the centrifugal pump.If the local…

Pressurized pipe flow

A 15-kilometer-long pipe with a pipe diameter of one meter transports water at a speed of one meter per second. The pipe has a friction coefficient of 0.005. Calculate the frictional head loss?