Q: A Mercury manometer is attached to a pipe having suction pressure. the right limb is open to the atmosphere while the contact between Mercury and water is in left limb at a distance of 30 cm from the center of the pipe. a) if the difference in the level of Mercury in the two limbs is 20 cm. what will be the pressure in the pipe. b) if the pressure in the pipe is increased to 2900 pascal. what will be the new difference in Mercury level.

Q: A Mercury manometer is attached to a pipe having suction pressure. the right limb is open to the atmosphere while the contact between Mercury and water is in left limb at a distance of 30 cm from the center of the pipe. a) if the difference in the level of Mercury in the two limbs is 20 cm. what will be the pressure in the pipe. b) if the pressure in the pipe is increased to 2900 pascal. what will be the new difference in Mercury level.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

I need all right solutions with clear calculations
Atmospheric pressure at this location is 102.0 kPa and fluid temperature is presently 30°C. Oil (sg = 0.90) C Water 125 mm 475 mm 250 JU mm 50 mm Mercury (sg = 13.54) Figure 1: Compound manometer (note: sg = specific gravity)
Convert the 115/85 systolic/diastolic pressures given in millimeters of Hg to Pa .
Q1 A U-tube manometer is used to measure the pressure of oil of specific gravity 0.85 flowing in a pipe line. Its left end is connected to the pipe and the right-limb is open to the atmosphere. The centre of the pipe is 100 mm below the level of mercury (specific gravity- 13.6) in the right limb. If the difference of mercury level in the two limbs is 160 mm, determine the absolute pressure of the oil in the pipe. Liquid (5,-ERS) Pips
I need the answer as soon as possible
Example 7: The figure below shows a complex manometer. Calculate: 1. The gauge pressure of the air in the tube (2943 N/m²). 2. The gauge pressure at A (20718.72 N/m²). 3. The absolute pressure at A if the atmospheric pressure is 105Nm2 (120718.72 N/m²). s.g.= 0.90 S.g.= 2.94 B Air 0.6m 0.3m D FU 0.8m Water Density of water = 1000 kg/m³.
An oil of specific gravity 0.89 is flowing through a horizontal venturimeter fitted to a 242 mm diameter pipe at the rate of 108 liters/s and throat diameter is 98 mm. The entrance and throat of the venturimeter are connected in the two limbs of a U-tube mercury manometer. The difference in mercury level shows 841 mm. Calculate (i) the head difference in m of oil, (ii) the theoretical discharge in m3/s, (iii) the actual discharge in m3/s, and (iv) the coefficient of discharge of a venturimeter. If instead of a U-tube mercury manometer, the pressure gauges are inserted at the entrance and throat of venturimeter. Find (v) the pressure at the throat in N/mm2, if the entrance pressure gauge shows0.13 N/mm2.
A mercury manometer is used to measure the static pressure at a point in a water pipe as shown in Fig.2.9. The level difference of mercury in the two limbs is 10 mm. The gauge pressure at that point is Water H,0 10mm Hg"
Two thermometer. one reading and the other are both immersed in a fluid. If the farenheit reading is half of the celcius reading, a.) What is the farenheit reading? b.)what is the equivalent temperature of the fluid in degrees rankine?
today at 8:12 pm mee A metallic cube 30 cm side and weighing 450 N is lowered into a tank containing a two fluid layer of water and mercury. Top edge of the cube is at water surface. Determine the position of block at water-mercury interface when it has reached equilibrium.
You are required to design a barometer that uses water instead of mercury to operate under standard sea-level conditions. Draw a conceptual diagram of your barometer design. Show on your diagram what the pressures will be at all liquid-gas interfaces, and where the barometer reading will be taken.Calculate the minimum height requirement of the barometer tube to measure standard sealevel atmospheric pressure.
A manometer consists of a tube of 0.5 inch in the inner diameter and an amount of mercury (SG Hg =13.55). On one side of the tube, oil (SG=1.4) was trapped, a bubble formed, and the fluid inside was stationary. The volume of the oil was 0.6 in^3 and the volume of the air was 0.2 in^3. Now, the oil and bubble are removed. The pressure change across the air bubble is negligible and any curvature on the bubble surface can be neglected in calculating the volumes. Determine how much the mercury height rises (i.e. h 4 -h 2 ).