Q 5. For the circuit shown in Fig.7. what will be the value of R1 to get maximum power? Also, find this power. 203 ,60Ω E180Ω R 10V 190Ω Fig.7

Q: The following circuits are given. Find the current ix. 36 mA (a) R 5ix R₁ 11 ix (b) 120 mA R₂ 24 mA

A: it is asked to find the current ix in given 2 circuits

Q: Q2) Calculate the Rr for the following circuits and draw the equivalent circuits: ㅓㅣㅏ V1 5V 4 R1 ww…

A:

Q: A 5-Ohm resistor is in parallel with a 20-Ohm resistor, is supplied by a 32-V dc battery. Calculate…

A: if two resistors R1 and R2 are connected in parallel than equivalent resistance = R1×R2R1+R2. First…

Q: A 5-Ohm resistor is in parallel with a 20-Ohm resistor, is s current at the 5-Ohm resistor. O 1.6 A…

A:

Q: For the circuit shown, what is the value of the voltage v1? 20 1 A 10 V 20 R2 1 V R1 O 9 V O 3 V O 5…

A:

Q: A simple DC circuit consists of a 24V independent voltage source and three resistors as shown. Find…

A:

Q: VOLTAGE AND CURRENT ANALYSIS (CALCULATED vs Multisim) Explain the data in this table  Parameter…

A: From the given table we can see that the values obtained from the manual calculation and those…

Maximum power transfer theorem

A resistive load will consume maximum power from a network when the load resistance is equal to the resistance of the network as viewed from the open-circuit terminals, with all energy sources removed leaving only the internal resistances. Physicist Moritz von Jacobi introduced the maximum power transfer theorem in 1940. Therefore, this theorem is also known as Jacobi's law.