Q 5. A wave-wound armature of a 6-pole generator has 51 slots. Each slot contains 20 conductors. The voltage required to be generated is 250 V. What would be the speed of coupled prime mover if flux per pole is 0.07 Wb. If the armature is rewound as lap-wound machine and run by same prime mover, what will be the generated voltage? (Ans. 70 rpm; 83.3 V)

Q 5. A wave-wound armature of a 6-pole generator has 51 slots. Each slot contains 20 conductors. The voltage required to be generated is 250 V. What would be the speed of coupled prime mover if flux per pole is 0.07 Wb. If the armature is rewound as lap-wound machine and run by same prime mover, what will be the generated voltage? (Ans. 70 rpm; 83.3 V)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

In a separately excited generator supplying rated load the armature reaction. is always present is always absent O none of these may be sometimes present
q. 11
A long shunt compound generator supplies a load consists of 172 shunt lamps each rated at 48 W, 235 V. The resistance of the armature is 0.035 Q. The resistance of the shunt windings is 35 Q. The resistance of the series windings is ?0.014 Q. Find the efficiency. The stray loss is 583 W
Answer number 5 Make solution neatly and accurate
An 6-pole d.c. generator has 550 armature conductors, and a useful flux of 40 mWb per pole. What will be the e.m.f. generated if it is lap-connected and runs at 1200 rpm? What must be the speed at which it is to be driven produce the same e.m.f. if it is wave-wound? Generated voltage speed
Explain in details how the separately-excited de generator works?
The DC shunt generator with the terminal voltage 300 V, armature drop 7 V and the each brush drop 4 V, then the value of generated emf is
A 25cps single-phase, 8-pole, alternator with 725 mWb flux per pole has 288 slots. The machine coil has 2 turns per coil. In the winding of the armature, the ratio between the chording angle to the fractional pitch is 1/8. Find the voltage between two terminals.
DEGREE: ELECTRICAL ENGINEERING SUBJECT/COURSE: AC MACHINES Answer the following questions (A, B and C) depending on the topic. 1. ALTERNATORS A. Why is it necessary to maintain the speed of an alternator at all times and how do they control the speed of an alternator when in operation? B. Distinguish between half-coiled and full-coiled armature windings in alternators. C. Why are fractional pitch windings generally used in alternators?
A 8 pole wave wound dc shunt generator runs at a speed of 1400 rpm, has an armature and shunt field resistance of 0.9 Q and 200 Q respectively. The armature has 930 conductors and flux per pole is 0.46 Weber. If the lamp load connected has a resistance of 40 Q, determine (i) Generated EMF, (ii) Total Resistance, (iii) Armature Current, (iv) Terminal Voltage. Generated EMF (Eg) Total Resistance (Rt) Armature Current (la) Terminal Voltage (V) an output of 8 HP with an
An 6 pole, wave connected armature has 520 conductors and its generated e.m.f is 125 V. If the machine is driven at 400 rpm, then the flux per pole in Wb is,
2- A 4-pole, wave-wound d.c. shunt generator has an armature winding consisting of 300 turns each of 0.0020. The armature resistance is a) 0.152 b)0.62 c) 0.30 d) none of above