Q 4: Using G codes to make part program. 5" 2.5" p2 p4 1" Tool size = 0.25 inch, Feed rate = 6 inch per minute, Cutting speed = 300 rpm, Tool start position: 2.0, 2.0 Programming in inches 5" 45° Motion of tool: po > p1 > p2 > p3 → p4 > p5 > p1 → po ро (2, 2)

Q: P3)  What are the alternative techniques are there to lean manufacturing

A: Lean manufacturing: It is a type of production process which always try to maximize productivity and…

Q: What is production engineering?

A: Given Data- Topic production engg given We have to explain it.

Q: Batch production Mass production Worker skills * Advantages O Efficiency, speed and low unit cost O…

A: We know that, in mass production, the workers used were low skilled workers because large production…

Q: What process is used to verify that a manufactured part or hardware component conforms/follows the…

A: Process which is used to verify that a manufactured part or hardware component conforms/follows the…

Q: Which among the following statement is false for Design for Manufacturing and Assembly? a. Both DFM…

A: Design for Manufacturing i.e. DFM and Design for Assembly i.e. DFA both help in shortening the…

Q: ...14.15 You are product planner for product A (in Problem 14.14 and Figure 14.14). The field…

A: Given:To find:

Q: Describe the method of making Capital-Expenditure Decisions In manufacturing. engineering?

A: Capital expenditure is the money used by an organisation to acquire new assets for the company. The…

Q: Do engineers and scientists ever get involved in product liability and product recall matters? If…

A: Yes, engineers and scientists get involved in product liability and product recall matters.

Q: ow do company acquisitions and mergers apply to industrial engineering? Note:

A: Different types of financial transactions which may include merging, purchasing of assets,…

Q: B. List some existing products that you think can be improved or replaced. If you think they can be…

A: Product improvement is the process of making significant improvements to a product that results…

Forming and Shaping

Metal forming is a category of metalworking process through which the material can be given the desired shape and size by subjecting it to plastic deformation, where the component undergoes bulk deformation process upon application of loads. Unlike the shearing and machining process, the material does not undergo up to a failure point as indicated in the stress-strain curve. Hence, the stresses induced during the forming process are greater than yield strength but less than the failure strength of the material. The process does not lead to the loss of material, so it can be said to be an economical process. During forming, the material is subjected to tensile forces, compressive forces, bending, and shearing loading conditions. The material should possess the property of ductility to undergo the forming process.