Q-2 Two blocks of rubber, each 80 mm long by 40 mm wide by 20 mm thick, are bonded to a rigid support mount and to a movable plate (1). When a force P = 2,800 N is applied to the assembly, plate (1) deflects 8 mm horizontally. Determine the shear modulus G of the rubber used for the blocks.

Q: Calendering is a special manufacturing process in which large volumes of rolled thin plastic films…

A:

Q: A pressure cylinder has an outer diameter 210 mm, internal pressure 4.4 MPa, and maximum allowable…

A: Given Data

Q: Describe the Spherical Vessel?

A: A vessel is a closed structure containing liquids or gases under pressure. Familiar examples include…

Q: has part B of this problem been done

A: using the Euler's first law for rotation, the reaction force at each bearing is,

Q: A hydraulic press is used to apply 500 lbs of force to press fit an assembly. The cylinder has a 2"…

A: The objective of the question is to calculate the flow rate required to retract the hydraulic press…

Q: A new missile is being developed with the goal of fooling enemy interceptor missiles. The idea is…

A: The initial velocity is The initial approach angle is The mass of part A is The mass of part B is…

Q: 3- Calculate the number of finished goods (output) or N for the figure illustrated below:

A: Given: Total number of goods xi = 1200 Goods accepted after casting = 90% = 0.9 Goods sent for…

Q: what is p3?

A: the pressure at state 1 and 2, P1 = 10 bar the temperature at state 1, T1 = 400 C The temperature at…

Q: Industrial pipes Expansion joints are fragile elements and therefore should be avoided…

A: The objective of the question is to understand when to use expansion joints in industrial piping…

Q: Start a new Part in SolidWorks. Make a 1" diameter x 5" tall cylinder. Put a 0.5" diameter hole…

A: Given that-Diameter of cylinder = 1'' = 1 inchHeight of cylinder = 5'' = 5 inchDiameter of hole at…

Q: I need more details like more infand diagram.

A: Solution:- → Assumption:-   * Gasoline is the fuel used in the snowblower(snow blower)…

Q: Seems incorrect setup, can you resolve?

A:

Q: c) The bore of each cylinder in a six-cylinder car engine is 52 mm and the stroke for each piston is…

A:

Q: How does the tension in the string change as the masses start to move? Or does it?

A: Consider pulley mass system as shown in the figure below, Scenario 1 Assume the pulley does not…

Q: Knowing that time is of the essence determine the best method to identify if the mix bars are AISI…

A: Both AISI 1020 and AISI 1040 are alloys of iron with their average alloy composition basically…

Q: where did you guys get the area from?

A:

Q: Write one to two paragraph Executive Summary of a shell and tube heat exchange and the manufacturing…

A: Executive Summary of a shell and tube heat exchange

Q: What is the max circularity, on a radius, on the part below before a feature control frame is…

A: The tolerance of the part is

Entropy

In physics, entropy means the amount of disorder or the degree of randomness associated with a thermodynamic system. The system is not self-organized when the entropy of the system is high. For instance, when a system is at an elevated temperature, its molecules are in random motion, vibrating and colliding with each other. During this scenario, the probability of finding a molecule at a particular place twice, is low. Under this circumstance, the system can be said to be in a high entropy.