Q-2: Find total stress (o), pore-water pressure (u) and effective stress (o') at B for the following cases: (a) Total heads at A and B are 10 cm and 10 cm respectively. (b) Total heads at A and B are 10 cm and 15 cm respectively. (c) Total heads at A and B are 10 cm and 8 cm respectively. (Assume /sat = 16 kN/m³, and yw = 10 kN/m³)

Q: A flywheel is positioned on a shaft as shown below. The weight of the flywheel and applied torque ac…

A: Given Data:Loads on steel shaft Sy=440MpaL1=650mm, L=1200mm, M=75kg, T=200N-m, D=30mm It is required…

Q: Determine the normal stress in a ball, which has an outside diameter of 165 mm and a wall thickness…

A:

Q: Determine the normal stress in a ball, which has an outside diameter of 195 mm and a wall thickness…

A: step 1-

Q: Problem 4 A thin-walled cylindrical pressure vessel has an internal diameter of d = 2 m and a wall…

A:

Q: Find the stress resultants N, V and M, draw the diagrams of the stress resultants (N,V,M)

A: Stress ResultantsN= -7 kN (Compression)V= 18 kNMmax= 54 kN-m  As seen on the diagram at explanation…

Q: The stresses shown act at a point in a stressed body. Assume stress magnitudes of Sx = 18 MPa, S, =…

A:

Q: Pressure vessel made of alloy steel with Yield Strength of 250 MPa, Pressure acting on Pressure…

A:

Q: A line load of q = 160kN/m with a = 45° is placed on a gre Figure below. Calculate the increase of…

A:

Q: Determine the normal stress in a ball, which has an outside diameter of 170 mm and a wall thickness…

A: Given- a ball inflated to a gauge pressure of 87kpa. Required-to find normal stress in a ball.

Q: Q6. Hoop stress (0₁) in a thin-walled pressure vessel is 40 MPa. What is the maximum 'in-plane'…

A: Introduction : The given question is related with solid mechanics . In this question we are provided…

Q: A line load of q=60kn/m with alpha =300 is placed on a ground surface as shown in figure…

A:

Pressure and Stress