Q . It is proposed to pump 8,000 kg/h of toluene at 114 oC and 1.1 atm abs pressure from the reboiler of a distillation tower to a second distillation unit without cooling the toluene before it enters the pump. If the friction loss in the line between the reboiler and pump is 7 kN/m2 and the density of toluene is 866 kg/m3 . How far above the pump must the liquid level in the reboiler be maintained to give a net positive suction head of 3.5 m? Calculate the power required to drive the pump if the pump is to elevate the toluene 10 m. The pressure in the second unit is atmospheric and the friction loss in the discharge line is 35 kN/m2 . The velocity in the pump discharge line is 4 m/s.

Q: An air compressor is to compress 510m /hr from 100kpa to 10bar, for an ideal compres n=1.3, what…

A:

Q: Please read the problem and solve what is asked. Thanks! A two-stage compressor with an ideal…

A: Givenhellium gasv1=0.5m3/sP1=150kPaT1=300KP2=7500kPa

Q: °C. (Assume all process to be The temperature of air after first stage compression is ideal and…

A:

Q: Air is compressed in a diesel engine cylinder. The initial pressure and temperature are 105 kN/m and…

A:

Q: Air from a line at 12 MPa, 15 deg. Celsius, flows into a 500 L rigid tank that initially contained…

A:

Q: i. An aircraft is flying at a speed of 500 ft/s an altitude of 20,000 ft, where the atmospheric…

A: GIvenspeed of air craft V=500ft/s=152.4m/sAltitude h=20000ftAtmoshperic temeperature…

Q: 8. If 1215 Jof heat was put into the gas during state a-b, how many of those joules went to internal…

A: Given in Question 8: Heat added=1215 J Given in Question 9: mass of water, m=1 kg specific heat of…

Q: H.W: Problem 1: Calculate the change in entropy when 10 grams of ice at 0 °C is converted into water…

A: Entropy is the measure of disorderness of any system. If heat flow occurs through any system, then…

Q: A Cl engine, during suction stroke, draws Air only Mixture of diesel and air A mixture of oil and…

A: Basics of Thermodynamics are used.

Q: A confined volume of 27 moles an ideal gas (with y 1.42) goes through an expansion process so at the…

A:

Q: Compression ratio in Diesel Cycle will be 2.5 time higher than the cutoff ratio. Volume at TDC is…

A: The diesel cycle is an air standard cycle that diesel engines work on. It comprises one adiabatic…

Q: The air entering the turbine with 1200 K and 1200 kPa expands to 100 kPa pressure in two stages.…

A: Given Data Turbine Inlet:1200 K Two stage expansion process P1=1200 kPa, P2=350 kPa, P4=100 kPa

Q: The power requirement of a 3-stage compressor (in kW, two decimal places) in order to supply air at…

A: To Find : The actual power requirement. Given :  The temperature is T=20°C. The discharge is Q=250…

Q: A 32 m high down Comer-tank system operates lloo bar if the exit quality of the steam is what will…

A: Given             Volume, V = 32 m3 Initial pressure, P1 = 100 bar               Quality, x = 0.5…

Q: 111 moles of water (molar mass 18 g/mole) at 50 °C spontaneously changes temperature. Half of the…

A:

Q: 21: Steam at a pressure of 28kpa is passed into a condenser and it leaes as condensate at…

A:

Q: A sample of steam is at a pressure of 500 kPa (x=0.9) before entering a condenser then exiting it…

A:

Q: Oxygen gas in a container is raised from 5°C to 65°C with the pressure head constant at 5x10^5…

A: Ideal gas law refers to the interaction between the molecules of a gas. In general, the gas…

Q: Steam is supplied to a two-stage turbine at 48 bar and 400 °C. It expands in the first turbine until…

A:

Q: [ In a simple turebine setup; a compressor drawn in air from the atmosphere at 3ook and Compressor…

A: Here we will take the compression and expansion to be isentropic as there is no mention of…

Q: Q.4:A) A single-stage reciprocating compressor takes Ikg/min at 1bar, 288K and delivers it at 5bar…

A: Part A  Given,

Q: When you get your all changed (assume "light oil"), the mechanic adds your dirty and hot 6 quarts of…

A: Solution: Given Data: v1=6 quartsT1=210oFv2=9 gallonsT2=65oF   To Find: (a) The final temperature in…

Q: P;=1 MPa T;=800 K P2 = 0.1 MPa T;= 400 K SOLID-OXIDE FUEL CELL moles no, = 105 moles 02 = 105- u, =…

A: following is the answer to the above question- 8l

Q: Calculate the change in the entropies of the system (AS,») and the surroundings (ASur), and the…

A:

Q: Water P=200kPa, h=600kJ/kg. v? T?

A:

Q: 1. Turbine 2. Pipe 3. Compressor Pluid B CV ondary 4. Throttling valv T-ellow -Fluid A 5. Heat…

A: The turbine is a device that converts fluid energy into shaft work. A pipe is a tubular section or…

Q: Ans. 3908 m’/min. 14.5 Find the cylinder dimensions of a single-cylinder, double-acting compressor…

A: Answer: The dimensions of the cylinder are: D = L = 27.865 cm.

Q: A turbine passes 67.5 kg/h of steam at 200 km/h at 8 MPa and leaves at 0.5 MPa as wet steam with a…

A:

Q: 20 bar with te angles 30° anc

A:

Q: isentropic. Find the coefficient of performance for the refrigerator assuming 1 kg/ inter-stage…

A: Refrigeration Refrigeration is the process in which heat is extracted from the body or space whose…

Q: There are 5kg/s of CO2 (R=188.96kJ/kg-K, k=1.288) gas compressed polytropically with n=1.2 from…

A:

Q: An air cooled refrigerant condenser (similar to the ones used for home air conditioners) is shown,…

A:

Q: Find the velocity of the steam at the exit of the nozzle

A: Given data: Dry saturated steam at a:      pressure(p1)=10 barIt leaves at a:      pressue(p2)=1 bar…

Q: 1. Using the Steam Tables, find and entropy of steam at the inlet and outlet of a boiler and heat…

A:

Q: Fifty (50) kmol per hour of air is compressed from P₁ = 1.2 bar to P₂ = 6.0 bar in a steady-flow…

A: draw diagram? T1=300ku1=10m/sT2=520ku2=3.5m/sP1=1.2barP2=6bar

Forms of Energy

Energy is described as the capability to accomplish a task, like the ability to push a block by applying force on it. It is a quantitative property that is used to accomplish work on an object.