pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is 10 m. What is the power in KW required if the pump efficiency is 90%

Q: 6.    The velocity in a 2-cm diameter pipe is 20 m/s. If the pipe enlarges to 5-cm in diameter, the…

A:

Q: A crude oil is to be pumped out through a pipeline at flow velocity, v of 5 m/s. As a process…

A: Spring diaphragm is a simple mechanism.

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: The volume of air delivered by fan is 14 m^3/sec and 69 mm water gage. The density of air is 1.27…

A:

Q: Q3/ The horizontal pump in Fig. below discharges 20°C water Neglecting losses, what power in kW is…

A: GIVEN:discharge fromthe pump Q=57m3/h

Q: A pump recieves 5.6kg/s of hydraulic oil (SG=.85) at 2.5kg/cm2 and discharges it at 13kg/cm2. What…

A: Solution is attached below:

Q: 1.)  A Pelton wheel with a needle-controlled nozzle develops 1 050 kW against a gross  head of 300…

A:

Q: A typical industrial-scale wind turbine has a peak efficiency of about 0.44 for a wind speed of 9…

A:

Q: Q1) Benzene with specific gravity of 0.8 flows through 200 mm diameter pipe at velocity of 5 m/s.…

A: Since you have asked multiple questions in a single request we would be answering only the first…

Q: pump rated at 65% efficiency is used to transport water from a large open reservoir to a point 10m…

A: Option b is correct 375000 is nearly Reynolds number because for that value we used orifice metre.

Q: C) Identify the types of water turbines and the limitations that exist within these different types?…

A: Different types of water turbine are listed below Pelton Wheel: The hydro turbine (especially an…

Q: A 5 lbm ball starts rolling up a 30deg incline at speed of 20 ft/s. Using conservation of energy,…

A: Given   Mass, m = 5 lbm       Angle = 30o Velocity, v = 20 ft/s Find  Power, P

Q: Q2/Water is being pumped from a reservoir to the hill, water discharged (0.245m'/s) as shown in Fig.…

A:

Q: Water flows from a cylindrical pipe of diameter 6-cm into another cylindrical pipe of diameter 3-cm.…

A: Given: The diameter of first pipe is D=6 cm. The diameter of second pipe is d=3 cm. The velocity in…

Q: B: The pump in Fig. Q3B increases the pressure in the water from 200 to 4000 kPa with a flow rate of…

A: To Find : The mechanical efficiency of the pump and overall efficiency pump/motor.Given : The…

Q: A closed reservoir filled by water, is under the pressure of 49 KPa as shown in the Fig.1. find the…

A: Given:pA=49 KPa (gauge)zA=3 mVA=0pB=0 KPa (gauge)zB=0

Q: Find the total energy at the location of the manometer, relative to a datum, through the pump.…

A:

Q: 3. For a Pelton turbine the pressure of the flow before the nozzle is 5 bar while the velocity of…

A: As given that the pressure before the nozzle(P) = 5 bar ;the velocity of the flow leaving the nozzle…

Q: Thirty (30) liters/second of stream water must be pumped up a vertical height of 12 meters to…

A: Water flow rate, Q=30 Lit/s Water pumped to vertical height, H=12 m Pump efficiency, ηpump=62% Motor…

Q: A pump rated at 65% efficiency is used to transport water from a large open reservoir to a point 10m…

A: Dear student,                      According to guidelines, I am allowed to answer only one problem…

Q: ! A B C D =150 mm 4-50 mm 1,5 m 3,6 m 2,4 m

A: given; vertical distance from point C to B (h1)=1.5mvertical distance from point C to D…

Q: Water flows over a waterfall 328 Ft in height. Take 2.204 lb of the water as the syste and assume…

A:

Q: 1. A 2 cm diameter water jet having a velocity of 25 m/s and inclined from the horizontal at an…

A:

Q: Q.8 A turbine is working under a head of 200 m. The power developed by the turbine is 100 kW and…

A: Given Data P=100 kW H=200 m Q=0.125 m3/s

Q: A tank is in the form of a right circular cylinder with hemispherical ends. The overall length of…

A: Overall length = 4 m Diameter of hemisphere = 1 m Density = 1.2 kg/litre Flow rate = 225 litre/min

Q: using 2 L please solve it in these steps  step 1- find velocity of the fluir using bernoullis…

A: Step 1:Step 2: Step 3: Step 4:

Q: Water vapor at 400 temperature and 3 mpa pressure enters an adiabatic nozzle at a speed of 40 m/s…

A:

Q: Need detailed solution. 4 decimal places. A fluid is flowing in a 6 in diameter pipe at a pressure…

A:

Q: An irrigation line carries water from a lake down into an arid valley 810 ft below the surface of…

A:

Q: The system curve is O

A: Answer: 1) Plot of actual Pump head and Discharge

Q: ..Consider a leather belt with the following given: width of 100 mm, thickness of 6.4 mm, velocity…

A:

Q: What is the energy requirement in kW for a pump that is 75% efficient if it increases the pressure…

A: Given data    pump efficiency = 75 %  flow rate m.= 10 kg/s             Pwater=kgm3 Initial…

Q: 220ft/s, the diameter of the jet is 4 in. Find the power loss in friction expressed

A:

Q: 2. A.) Water in a concrete detention pond is to be pumped over a berm and into a lake. If the 8-inch…

A:

Q: A pump lifts water at the rate of 6 m3/s to a height of 120 m and the friction loss in the pipe is…

A:

Q: If a pumped hydro installation can hold 30 million m3 of water, and the water head is 36 m:…

A: For solution refer below images.

Applied Fluid Mechanics

A fluid is a substance that is continuously deformed by the application of shear stress. The rate of deformation of a fluid depends on its viscosity. The fluid tries to flow when it interacts with some other system.