propped beam has a span of 9 m. and carries a concentrated load of 60 kN at point B. E = 15000 MPa, I = 150x10⁶ mm⁴. 1. Which of the following gives the reaction at C.  a. 32.12 kN b. 33.67 kN c. 34.87 kN d. 31.11 kN

Q: 45° 5 kN 3 m C 45° 1.5 m B 1.5 m

A:

Q: 2. Assuming the upward reaction of the ground on beam AB to be uniformly distributed, (a) draw the…

A: Beam: Objective: (a) Draw the shear and bending moment diagram. (b) Determine the maximum absolute…

Q: Determine the length b of the triangular load and its position a on the beam such that the…

A: Given Data: The span of the beam is L=4 m. The intensity of the Uniformly Distributed load is w1=2…

Q: The beam is subjected to a load F = 400 N and is supported by the rope and the smooth surfaces at A…

A: Free body diagram:

Q: 80 kN 20 kN/m IC 3m 2 m Refer to the above diagram. Point A is a fixed conection. Member AC and CE…

A: To find the Fx, Fy and MA about point A-

Q: The 6 m long beam above is subjected to a point force of 15 kN at an angle of θ = 60°, a clockwise…

A: We are authorized to answer three subparts at a time, since you have not mentioned which part you…

Q: Determine the equivalent resultant force and couple moment at point O.

A:

Q: Determine the reaction at the roller support. Ans.: Blank 1 N Determine the moment reaction at the…

A:

Q: The reaction of the ground is uniformly distributed. Draw the shear and bending moment diagram for…

A: ###Calculation for SF and BM and Drawing of SFD and BMD ####

Q: The total load W is to be lifted using the mast hinged at B. The mast is of uniform section and…

A:

Q: The three forces shown are equivalent to a 50-kN upward force at A and a 200-kN.m counterclockwise…

A:

Q: Assume that w = 6.95 kN-m and L = 5.40 m. Determine the reaction force at B. Assume that El is…

A:

Q: Considering the beam below using Three Moment Equation, Determine the vertical reaction at points A,…

A: Data given Find : (a)  Vertical reaction at points A. B. and C using Three Moment Equation (b)…

Q: A 15 m long beam AB has a fixed support at A and a roller at 10 m from A. If the free end is…

A:

Q: 50 N 40 N/m 2.5 m 80 N В 30- 60° 1 m 3 m 1.5 m 30° A Determine the support reactions at pin A and…

A: A loaded beam is given and it has been asked to determine support reactions. Please refer step 2 for…

Q: c kN b kN/m 10 kN/m B. "a" m 3 m

A:

Q: 5. A 12-ft bar of negligible weight rests in a horizontal position on smooth inclines in the below…

A: Hello dear this is the solution of your problem The answer is found to be For bar to be in…

System of Forces

A force is an external influence or agent that changes the state of a system. According to Newton's second law, the force applied to a body is proportional to the change in momentum of a body. Hence, whenever a force is applied to a body, its momentum changes. If the body is at rest, under the action of force, its state of rest changes to motion. In other words, the magnitude of the momentum of the body changes from zero to a measurable value. Similarly, if the body possesses some initial velocity, it has some associated momentum, the effect of force can cause the body to halt or come to rest, that is, the momentum reduces to zero.