process uses a polymeric membrane whic

Q: A conical flask with a porous stopper is used to cultivate broth containing 8.1 g of moist…

A: The temperature is converted from Celsius to Kelvin. This system is diffusing A through non…

Q: Calculate the time required, to form 3.7 g of Strontium metal at the cathode when a 5.7 amp current…

A: Given- Current, I = 5.7 amp Weight = 3.7 g Molecular Mass of strontium, MM = 87.16 Valency of Sr in…

Q: Liquid propane is vaporized in a process before the gas is burned. a) If the inlet to the vaporizer…

A: Hi and thanks for the question, but you have posted multiple subparts, so we will answer the first 3…

Q: A combustion engine has been made to use a mixture of liquid hydrogen and liquid oxygen as a fuel…

A: Given data: Length of tube = 1 m  Diameter of tube = 0.8 m Flow rate of exhaust gas = 72 kg/s…

Q: A wastewater sample with a DO content of 1.4 mg/L is diluted with deionized water with a DO content…

A: DO of waste water sample = 1.4 mg/LDO of diluted water = 8.8 mg/LDO after mixing = 7.8 mg/LA)…

Q: A) What factors might lead to failure of the reactor and/or rupture disk?  B) Associate each factor…

A: Silane SiH4 analogues to methane with silicon. This is used in decomposition of silicon with…

Q: Liquid benzene (A) in a laboratory tube with a vapor pressure of 0.20 atm at a temperature of 298 K…

A: Evaporation rate for the system is asked.

Q: If the thermometer reads 15C (wet bulb temperature, T₁ = 15C), use the heat-mass transfer analogies…

A:

Q: 6. Diffusivity. the diffusivity of volatile solvents is frequently measured using an Arnold cell.…

A:

Q: An ethanol plant distills alcohol from corn. The distiller processes 2.0 t/h of feed containing 15%…

A: Distillation is defined as the process of separating the components or substances from a liquid…

Q: An electrolysis cell that deposits copper (from Cu2+ ions) operates for 30 minutes at an electric…

A: Given that: Copper is deposited from Cu2+ ion by electrolysis cell. Time taken, t = 30 min = 1800 s…

Q: An industrial chemist is studying small organic compounds for their potential use as an automobile…

A: Given, Volume of water=25 mL density of water=1 g/mL So, mass of water =density×volume mass of water…

Q: a) Why does the boiling point increase and freezing point decrease of a solution when compared to…

A: When a solute is dissolved in a solvent, the solute particles interact with the solvent particles.…

Q: If the thermometer reads 15C (wet bulb temperature, T₁ = 15C), use the heat-mass transfer analogies…

A:

Q: Nitrogen gas reacts with hydrogen gas to form ammonia gas (NH3). Consider the following illustration…

A: Given data: Initial volume of the reaction mixture = 15 L Pressure = 1 atm Gases behaves ideally.…

Q: a (meaning that 92% of the ben

A:

Q: The clear plastic bottles used for carbonated beverages (sometimes also called "soda," "pop," or…

A:

Q: Relative  volatility  is  a  measure  of  the  difference  between  the  vapour  pressure  of  the…

A: The term volatility is generally used when handling liquids. Volatility is a measure of vaporizing…

Q: CMC of a surfactant in water at 25 oC is 0.5 g L−1 and at 45 oC is 0.3 g L−1. The molar mass of the…

A:

Q: A brine solution containing 23.67% NaCl by mass is mixed with a weaker solution containing 2.81%…

A: Given  Mass flow rate of 23.67% solution (A) = 20.2 kg/h Weight fraction of 23.67 solution = 0.2367…

Q: QUESTION 1 The production of molten copper(1) sulfide is an important step in the making of copper.…

A: Given: A furnace contains mCu2S = 200 t at temperature T = 1200oC Mass of copper scrap (i.e. solid…

Q: Benzene is diffusing through a slab of air 1 cm thick at 25ºC and 2 atm. The partial pressure of…

A:

Q: An aqueous solution of acetic acid is to be extracted with isopropyl ether. The solution contains…

A: Given  The solution contains 24.6 kg of acetic acid and 80 kg of H2O Solvent isopropyl ether = 100…

Q: A solution is obtained by mixing 300 g of 25% solution and 400 g of 40% solution by mass. Calculate…

A: Given m1=300g,m2=400gx1=0.25,x2=0.4 Total mass of resulting mixture=m1+m2=300+400=700g…

Q: 100 kg of a mixture of sodium sulfate crystals (Na,SO, – 10H;0) and sodium chloride (Nacl) is heated…

A:

Q: In a paint manufacturing process, two different colored paints are being mixed in an infinitely…

A: Concentration of Paint A = 30%Volumetric flow rate of paint A = 10 Liters/MinuteConcentration of…

Q: A student wishes to determine the chloride ion concentration in a water sample at 25 °C using a…

A:

Q: 4. Barium carbonate is commercially important as a basis for the manufacture of other barium…

A: There are total four reactions involved in this system. Barium sulfide is obtained by heating…

Q: The surface of a 2.5 mm thick ammonia (A) (NH3) – water (B) (H2O) solution at 298 K is in contact…

A: Given data: Thickness of ammonia water solution surface = 2.5 mm Temperature = 298 K The…

Q: Water containing 0.5 Kg/L of salt is pumped into a tank at a rate of 2L/min, and the well-stirred…

A: Salt solution CA0=0.5 Kg/L v= 2L/min t=10 min Fresh water v= 2L/min t=10 min total t= 20 min…

Q: NaCl crystal is created from seawater within a series of evaporation and crystallization. A feed of…

A: NaCl crystals are produced from the evaporation of seawater.

Q: Find the density (in g/L) of CO, (g) and the number of molecules per liter (a) at STP and (b) at…

A: We know , density of gas = PM/RT Where, P = pressure of the gas M = molecular weight of gas R= gas…

Q: Liquid benzene is contained at 298K in a 2 cm diameter glass tube and maintained at a level 5 cm…

A: Glass tube T=298K D= 2 cm ∆z=5 cm =0.05m Properties of benzene 1) Boiling temperature Tb= 353K ,P=…

Q: Atmospheric (1 atm) air with a relative humidity of 40% blows over a smooth, wet flat plate. The…

A: Pressure =1 atm Relative humidity = 40 % Length of plate = 0.6 m Width of plate = 3 m Free stream…

Q: 5. Another student dissolves a 5.25 g sample of solid NaOH in 100.00 g of water at 25.00 °C in the…

A: Write the reaction as follows: NaOHs + H2Ol → NaOHaq    Given, The mass of solid NaOH, m1 = 5.25 g…

Q: Gallium is produced by the electrolysis of a solution made by dissolving gallium oxide in…

A: Given: Current=0.406 A Time=40 min

Q: Diffusion in Solids. Hydrogen at 0°C and 0.01 atm partial pressure diffuses through neoprene rubber…

A: Given data: Assuming A= Hydrogen, B= Neoprene DAB=1.03 x 10-10 m2s Solubility, S= 0.0151 m3m3 atm…

Q: Example 8.3-6: A gas stream containing 8 mole% CO with CO₂ at 500 °C is fed to a heat boiler. The…

A: In this system, the heat gained by the water will be equal to the gas stream's lost heat. Specific…

Q: In the process of producing jam, fruit juice containing 14% (w / w) dissolved solids is mixed in a…

A: The given information is depicted as a schematic flow chart as: Consider sugar and pectin as…

Q: (a) Take a basis of 100 kmol fresh feed. Draw and fully label a process flow chart and do…

A:

Q: A solution containing 5.96 g of an unknown liquid (nonvolatile, non-electrolyte) and 25.0 g…

A: The molar mass of the unknown liquid is to be determined.

Q: The vapor leaving the top of a distillation column goes to a condenser in which either total or…

A:

Q: a) 8.1% HCl in water by mass. The mixing process is continuous and steady-state. Two raw materials…

A: Hello Subscriber! There are multiple subparts to this question. As per our policy, we have solved…