Process 0→4 is an adiabatic process as shown. Which of the followings is true? Select all apply.-Isothermsなる► Vthe pressure increasesthe pressure decreasesthe pressure stays the samethe temperature increasesO the temperature decreasesO the temperature stays the samethe volume increasesthe volume decreasesthe volume stays the same Based on the given pV diagram, match the answers with questions. 0-4 and 0→8 are adiabatic processes.Isothermsv Q for process 0→1A. not enough informationv Q for process 0→8B. negativev Q for process 0→7C. positiveD. zero

Please see the answer below.Process 0→4:□ the pressure decreases (as 4 is at lower P value than 0)□ the temperature decreases (as T1<T2<T3, and 0 has temperature T2 and 4 has temperature T1)□ the volume increases (as 4 is at higher V value than 0)The process 0→1 is an isochoric process as the volume is held constant, meaning that the work done by the system will be zero. It follows that any heat absorbed by the system will be absorbed as internal energy and any heat lost by the system will be lost as internal energy. Therefore it is not certain heat is lost or absorbed during the process 0→1. Answer: A . Q for process 0→1. The process 0→8 is an adiabatic process so no heat is exchanged in this process. Answer: D . Q for process 0→8. The process 0→7 is an isothermal compression so heat is released by the system in this process(negative Q). Answer: B . Q for process 0→7.

Science

Physics

Process 0→4 is an adiabatic process as shown. Which of the followings is true? Select all apply. -Isotherms O the pressure increases the pressure decreases the pressure stays the same the temperature increases O the temperature decreases O the temperature stays the same O the volume increases O the volume decreases the volume stays the same

Process 0→4 is an adiabatic process as shown. Which of the followings is true? Select all apply. -Isotherms O the pressure increases the pressure decreases the pressure stays the same the temperature increases O the temperature decreases O the temperature stays the same O the volume increases O the volume decreases the volume stays the same

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Related questions

Q: Shown in the figure below is the cycle undergone by a Heat Engine. Your engine runs using 21.09…

Q: How much work in Joules is required to compress 7 moles of air (y =1.4) at 27°C and 1 atm to 1/3 of…

Q: The graph in the figure shows a pV diagram for 4.50 moles of ideal helium (He) gas. Part ca of this…

Q: The internal energy of steam is higher than that of water at 100°C. Select one: O True False

A: Concept used: Water gets converted into steam on giving extra energy.

Q: A system is connected to the outside environment via adiabatic walls, which of the following is…

A: We need to use the property of an adiabatic process to answer the question.

Q: A heat engine using a diatomic gas follows the cycle shown in the pV diagram. p (kPa) Q12 P₂ P₁ For…

Q: What is the net work done for the process ABCA as described by fig. Solution: B 3 1 V 2 L 5L

Q: Shown in the figure below is the cycle undergone by a Refrigerator. Your fridge runs using 22.60…

Q: 10. A heat engine takes 0.350 mol of an ideal diatomic gas around the cycle shown in 1.00 atm the pV…

Q: An ideal gas is compressed adiabatically by applying a force of 600 N over a distance of 10 cm how…

Q: TEXT ANSWER Give a description of each of the following processes: isothermic isochoric isobaric…

A: Given There are four different process are mention We have to write the some point about these…

Q: A sample of ideal gas follows the cyclical process shown in the figure. From A to B,the process is…

A: Given From A to B process is adiabatic at point A the values of Pressure and Volume is given by P1 =…

Q: Determine the work for the constant volume process, in Btu. W23=336.4 Btu

A: Given questions with answers and last answer is wrong . Therefore I am giving answer of last part.

Q: Find the total change in the internal energy of a gas that is subjected to the following two-step…

Q: When 1.60 ✕ 105 J of heat transfer occurs into a meat pie initially at 20.0°C, its entropy increases…

A: The equation for the change in entropy is Here, ΔS is the change in entropy, Q is the amount of…

Q: Completed 30.00 20.00 10.00 0.08.00 P +20.00 +48.33 V PV Diagram for Isobaric 100.00 T +48.33 Volume…

Q: An ideal gas undergoes the process a ---> 6 ---> c (b--->c Isochoric process) shown in the PV…

A: Question is from thermodynamics. Work done is equal to heat transferred. Refer attachment

Q: Based on the given pV diagram, how do you achieve process 0 to 2? by insuring that the…

Q: A diesel engine takes in air (r= 1.4) at 30 °C and compresses it adiabatically to 1/15 of its…

Q: During a phase change, what property(s) remain unchanged? (Pressure, Volume, Temperature, Density,…

Q: A sample of gas ina sealed container undergoes the cyclic process from state 1 to state 2 back to…

A: Answer

Q: rocess 0-8 is an adiabatic process as shown. Which of the followings is true? Sele AEth is positive…

Q: Shown in the figure below is the cycle undergone by a Heat Pump. Your heat pump runs using 38.07…

A: The number of moles of Argon is n=38.07 moles.The temperature at a is Ta=447 K.The pressure at a is…

Q: Which of the followings is true for process 0→3? Select all apply. (0→4 and 0→8 are adiabatic…

A: 0 ---> 3 is an isothermal process. Lets check each option one by one 1. ∆Eth is positive Since…

Q: 1 mole of an ideal gas follows the cycle shown in the figure. 1-2 is isobaric process, 2-3 is…

A: Number of moleFrom the figure1-2 is isobaric process, 2-3 is adiabatic process and 3-1 is isochoric…

Q: Check my work mode: This shows what is correct or incorrect for the work you have completed so far.…

A: The PV diagram shown is for a heat engine that uses 1.170 mol of a diatomic ideal gas as its working…

Q: A fixed amount of gas is expanded adiabatically. Which entry in the table below correctly depicts…

A: Given: Gas is expanded adiabatically.

Q: A gas is taken through the cyclic process shown in the figure. For one complete cycle, how much heat…

Q: Ti _T2 An ideal gas is taken through three different isothermal processes. The sketch represents the…

Q: A fixed amount of gas is expanded adiabatically. Which entry in the table below correctly depicts…

A: Work is done by the gas .The gas is expanded adiabatically .

Concept explainers

Human Metabolism

Being described as the most complicated machine ever encountered by humans, the human body and the cell metabolism is nothing less than a wonder. Metabolism is the set of life-sustaining chemical reactions within organisms.

Question

100%

Process 0→4 is an adiabatic process as shown. Which of the followings is true? Select all apply.
-Isotherms
なる
► V
the pressure increases
the pressure decreases
the pressure stays the same
the temperature increases
O the temperature decreases
O the temperature stays the same
the volume increases
the volume decreases
the volume stays the same

Based on the given pV diagram, match the answers with questions. 0-4 and 0→8 are adiabatic processes.
Isotherms
v Q for process 0→1
A. not enough information
v Q for process 0→8
B. negative
v Q for process 0→7
C. positive
D. zero

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

This is a popular solution!

SEE SOLUTION Check out a sample Q&A here

Step 1

VIEW

Step 2

VIEW

Step 3

VIEW

Trending now

This is a popular solution!

Step by step

Solved in 3 steps

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, physics and related others by exploring similar questions and additional content below.

Similar questions

P (Pa) 6,000 4,000 2,000 3 (A) -80 J (B) -40 J (C) 40 J (D) 80 J (E) 180 J 2 0 0 0.01 0.02 0.03 → V (m³) 28. A sample of nitrogen gas undergoes the cyclic thermodynamic process shown above. Which of the following gives the net heat transferred to the system in one complete cycle 1-2-3-1?
During an isothermal process, the number of mols of a gas is doubled while the pressure is held constant. By what factor did the gas volume change?
Answer the question as soon as possible
The heat engine shown in the figure uses 2.0 mol of a monatomic gas as the working substance. (Figure 1) Figure p (kPa) 600 400 200 0 0 0.025 2 3 0.050 ▼ Determine AEth, Ws, and Q for 3→1. Enter your answers in joules and separated by commas. ► View Available Hint(s) AEth, Ws, Q = Submit Part E η = V What is the engine's thermal efficiency? Express your answer as a percentage. ► View Available Hint(s) VG ΑΣΦ Submit ΑΣΦ ? % ? J
A system undergo a process consisting of the following two steps Step 1: The system absorbs 48 J of heat while 24 J of work is done on it Step 2: The system absorbs 24 J of heat while performing 48 J of work Calculate E for the overall process.
Each line of the following table gives data, in Btu, for a process of a closed system. Determine the missing table entries, in Btu. Process Q a b с d e i 40 -4 -10 3 W i i 5 0 10 E₁ IN 15 7 -10 8 E₂ H Mi 14 -8 ΔΕ i 30 10
A sample of gas in a sealed container undergoes the cyclic process from state 1 to state 2 back to state 1, as shown in the PV-graph below. 1 → V Which of the following statements is true about the heating done to the sample of gas across the entire process? Q > 0 < 0 Q = 0 O O