Procedure Note: The activity must be done at noontime 1. Prepare a cup and a basin filled with water. 2. Place the cup and basin filled with water outside where it may receive direct heat from the sun and check the water level of each the set up every hour for 4 hours. 3. Make sure that the water in both containers will not be thrown away by any external force. 4. Observe what will happen after 4 hours. Write all your observations in the table below. AMOUNT OF WATER CONTAINED HEAT (LESS OR MORE) (LESS OR MORE) CUP OF WATER BASIN OF WATER Guide Questions: 1. Which of the two will likely have more evaporation once exposed with the source of heat, a glass of water or a cup of water?

Procedure Note: The activity must be done at noontime 1. Prepare a cup and a basin filled with water. 2. Place the cup and basin filled with water outside where it may receive direct heat from the sun and check the water level of each the set up every hour for 4 hours. 3. Make sure that the water in both containers will not be thrown away by any external force. 4. Observe what will happen after 4 hours. Write all your observations in the table below. AMOUNT OF WATER CONTAINED HEAT (LESS OR MORE) (LESS OR MORE) CUP OF WATER BASIN OF WATER Guide Questions: 1. Which of the two will likely have more evaporation once exposed with the source of heat, a glass of water or a cup of water?

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

Three cylinders contain water as shown below. The pressure at point C is C Select one: a. Equal to pressure at B andA b. Lower than pressure at B and A c. Higher than pressure at B and A
show solution step by step.. Please show step by step solution..
Please good handwriting and clear ideas explaining the process! c) What do you expect for the equilibrium temperature if you plan to place windows on the submarine? Is it possible that it stays the same? Explain your answer qualitatively.
A nail with a mass of 6.695 g is placed into 6.26 mL of water in a graduated cylinder, and it sinks to the bottom. The water level increases to 8.43 mL. Determine each of the following and then enter only the answer to question iv below. i. What is the mass of the nail? ii. What is the volume of the nail? iii. Write down in your "Bring to lab notes" how you determined the volume of the nail. iv. Determine the density of the nail.Enter your answer for the density in units of g/mL in the box below with at least 2 decimal places.
Learning Task 3: Identification. identify the properties of matter being described in the following situations or examples. Write your answer on your answer sheet. 1. water climbing up the paper towel 2. vegetable oil floats in water 3. propane gas evaporates and fill the room right away 4. catsup is slow to pour 5. motor oil is slow to pour 6. a pin floating on water 7. Calcite 8. barometer 9. thin blade does not sink in the water 10. plastic
Answer thoroughly. Show clear and cohesive solution.
Need help with part D! Thanks
The density of a ring that may be silver, platinum, or a white gold alloy is being measured. Its mass under dry conditions is 4.29 g. In water at 20 °C having a density of 0.998 g/cm³, the mass is found to be 4.09 g. Think & Prepare 1. To find the density of an object you need its mass and volume. How can you accurately determine the volume of the ring? 2. How can you use the weightloss of the ring in water to determine the volume of the ring? What is the density of the ring? ✓ g/cm³ For comparison with the final answer (no need to enter an answer for this comparison), density of gold = 19.3 g/cm³ density of platinum = 21.45 g/cm³ density of silver = 10.49 g/cm³ density range of alloy = 14.7 g/cm³ to 16.9 g/cm³
1.) Is liquid volume directly proportional to temperature? Explain briefly 2.) Is Charles Law applicable to liquids?
+ Report - Glassware, Téchniques, and Measurement Lewis, Tereka REPORT SUMMARY Part I Density of Unknown Liquid Report your measurements to the correct number of significant figures. Use the images provided below to collect data virtually. If you have technical issues with the virtual data, please contact support. From the procedure 1. Obtain a 100 mL beaker and put about 60 mL of unknown solution into it. 2. Mass a clean dry 10 mL graduated cylinder on an analytical balance. Record the mass using the appropriate number of significant figures and units. (Use the same balance for future weighing to ensure accuracy in mass recordings.) Mass of empty 10 mL graduated cylinder (g) 11.611
help please with step by step solutions thank you
[Review Topics] [References] Use the References to access important values if needed for this question. A helium-filled weather balloon has a volume of 781 L at 21.9°C and 758 mmHg. It is released and rises to an altitude of 7.40 km, where the pressure is 352 mmHg and the temperature is -26.1°C. The volume of the balloon at this altitude is L. Submit Answer Retry Entire Group 9 more group attempts remaining