Problen A block weighing 125 pcf is 1 ft square and 9 inches deep 1. on a stratified liquid composed of a 7-in layer of water above a layer of mercury. (a) Determine the position of the bottom of the block. (b) If a downward vertical force of 260 lb is applied to the center of mass of this block, what is the new position of the bottom of the block? Ans: (a) 0.8 " below mercury (b) 4.67" below mercury

Q: #6 #7 Layer I H₁ = 9 ft Ydry=100 lb/ft³ Layer I H₁ = 4 m Ydry = 16.2 kN/m³ Layer I H₂ = 21 ft Ysat =…

A:

Q: A thin cylinder have inner radius 235 mm and thicknes 6 mm subjected to an internal pressure of 5…

A: Given data : The value of internal pressure p=5 MPa The value of thickness of thin cylinder t=6 mm…

Q: A strain gage is mounted at an angle of 30° with respect to the longitudinal axis of the cylindrical…

A:

Q: Determine Determine the Maximum Tensile Flexural Stress. the Maximum Vertical Shear Stress.

A: Flexural strength of any beam is the stress at which bending failure occurs. It is also known as…

Q: A thin cylinder have inner radius 235 mm and thickness 6 mm subjected to an internal pressure of 5…

A:

Q: The solid shaft is subjected to the following loads. Determine the diameter d of the shaft to the…

A: Determine the diameter d of the shaft to the nearest mm

Q: The wall thickness of a 3-ft diameter spherical tank is 3/4 in. Calculate the allowable internal…

A: Given data: Diameter = 3 ft Thickness = 0.75 in stress = 7 ksi.

Q: Sketch Mohr's Circle for Strain. Indicate the following Y Max InPlane on your sketch the following…

A:

Q: The kinematic viscosity of the oil filled between two concentric vertical 150 mm long cylinders is…

A: Given data in question  Length 150 mm Diameter 0.2 m Kinematic viscosity  Specific gravity of oil…

Q: Show step by step solution

A: When water flows downward, the shear stress on the boundary acts in the direction opposite to the…

Q: Q6. Hoop stress (0₁) in a thin-walled pressure vessel is 40 MPa. What is the maximum 'in-plane'…

A: Introduction : The given question is related with solid mechanics . In this question we are provided…

Load and resistance factor design

Load and resistance factors design (LRFD), also known as Limit state design (LSD), refers to the design method used in building engineering. A boundary condition is a condition of a structure where it can no longer meet the relevant design requirements. The condition may refer to the load level or other actions on the structure, while the terms refer to the integrity of the structure, suitability for use, durability, or other design requirements. A structure designed for LRFD is limited to keeping track of all possible actions during its design time and is always ready for use, with the appropriate level of reliability in each boundary condition. LRFD-based construction codes clearly define the appropriate levels of reliability in their instructions.