Problem I. Given the figure, determine the following unknowns using constant EI. 30 kN/m 20 KN a. Reaction at D (kN) b. Moment at A (kN m) 3m B c. Slope at D in radians d. Displacement at the application of 20kN load 2m 3m

Q: Problem 6 (25 minutes) The following rigid beam is supported by a pin and two steel rods (E=29,000…

A: Displacement at D = 0.031 in.Explanation:

Q: The mobile crane (weight = 48 kN) shown in the figure moves across the bridge of length, / = 14 m.…

A: We will find distance of resultant load from rear load. Resultant will be 3/4th distance.

Q: The initially stationary 24-kg block is subjected to the time-varying force whose magnitude P is…

A: Given data:- The given mass m = 24 kg Block. The force is zero then all-time greater than,=5 sec.…

Q: In the figure shown, El is contant. Determine the Moment at A in kNm. 100 kN 50 kN/m Sm D 3m 3m 4m O…

A:

Q: A structure as shown in the figure is hinged at A and rests on a roller at C. In using Castigliano's…

A:

Q: Calculate the distance x when the plank starts to slide. Calculate the normal reaction at B.…

A: Given:- plank mass=100 lb length = 10 ft. mass of man = 200 lb To find:- a) distance x when plank…

Q: PROBLEMI Psd the equation of motion of the uniform rigid bar OA of length I and mass m shown in…

A:

Q: 86

A: Approach to solving the question: Detailed explanation:Examples: Key references:

Q: Calculate the support reactions. 4m 2 kN/m 2m 10 kN ↓ 10 B

A:

Q: Consider the beam given in the figure. Given: X= 19 kN and E is constant. NOTE: This is a multi-part…

A:

Q: Calculate the bending moment at B. Let W = 14 kN/m

A: Given data  Find moment at support B.    Point C is hinge connection, so moment about hinge from…

Q: Determine the constant force P required to cause the 0.36-kg slider to have a speed v2 = 0.88 m/s at…

A:

Q: 223

A: Step 1.    Lets analyse the given data that     :Length of the beam (l): 2.5m  Angle of the force…

Q: Consider a cantilever beam shown in Figure 3 with the length 1, flexural rigidity EI, and an xtenal…

A:

Methods to Determine Vertical Stress

The load applied to the soil is transferred to the underground. The presence of water at soil pores and solid grains above the soil are the primary components that are responsible for the effective load transfer. Due to the load acting, the internal component of the soil or the underground formations undergoes deformations or a tectonic shift. The amount of deformation depends upon the amount of load acting on the soil surface, which indeed, depends on the weight of everything present above the soil. Due to this, the underground soil element develops internal stresses which try to resist the tectonic changes.