Problem 9: Displayed to the right are two carts connected by a cord that passes over a small frictionlesspulley. Each cart rolls freely with negligible friction. Consider the mass of the cart to be mj = 16.2 kg and theangle the first cart sits on to be 0, = 36.5°, while the mass of the second cart as m2 = 22.3 kg and the angle it sitson to be 02 = 49°.mim202 Part (b) What is the acceleration of the carts in meters per square second?a =cotan()asin()acos()E456.

Answered: Image /qna-images/answer/a879d6c6-eb33-49e8-ae1a-3563f81d1627.jpg

Problem 9: Displayed to the right are two carts connected by a cord that passes over a small frictionless pulley. Each cart rolls freely with negligible friction. Consider the mass of the cart to be m = 16.2 kg and the angle the first cart sits on to be 0, = 36.5°, while the mass of the second cart as m2 = 22.3 kg and the angle it sits on to be 02 = 49°. mi m2 02

Problem 9: Displayed to the right are two carts connected by a cord that passes over a small frictionless pulley. Each cart rolls freely with negligible friction. Consider the mass of the cart to be m = 16.2 kg and the angle the first cart sits on to be 0, = 36.5°, while the mass of the second cart as m2 = 22.3 kg and the angle it sits on to be 02 = 49°. mi m2 02

College Physics

11th Edition

ISBN:9781305952300

Author:Raymond A. Serway, Chris Vuille

Publisher:Raymond A. Serway, Chris Vuille

Chapter1: Units, Trigonometry. And Vectors

Section: Chapter Questions

Problem 1CQ: Estimate the order of magnitude of the length, in meters, of each of the following; (a) a mouse, (b)...

See similar textbooks

Similar questions

A can full of soda (total mass is about 375 g, where 355 g comes from the liquid and 20 g from the aluminum can, radius is about 33 mm) is released on a slope. The slope has an angle of 30° of inclination and a length of 40 cm. Due to friction, the can roll over the slope without slipping. Determine the time it takes for the can to reach the bottom of the slope.Repeat the calculation for the empty can (m = 20 g and R = 33 mm). Note: In both cases, ignore the contribution from the top and bottom metallicparts of the can (disks) to the moment of inertia.
The figure shows the Atwood tool with a disk-shaped pulley given as moment of inertia I. Here m = 2 kg of pulley mass and R0 = 20 pulley radius. The masses M1 = 1 kg and M2 = 3 kg, which were initially at rest, are released at time t = 0. The z-axis is defined towards the outside of the screen. a) What is the magnitude of the acceleration of the masses m / s ^ 2? a) 10/3 b)4 c)5 d)2 e)20/3
Two blocks with masses M1 and M2 (M2 > M2) are connected via a massless rope and a pulley (a solid disk with a mass of Mp and radius R). M2 is suspended a distance d above the ground. 10. Mp The system is released from rest and the rope does not slip on the pulley. Find the speed of M, right before it hits the ground. Express your answer in terms of the given values and any constants. M1 M2 d
A man stands on a merry-go-round that is rotating at 2.13 rad/s. If the coefficient of static friction between the man's shoes and the merry-go-round is ?s = 0.63, how far from the axis of rotation can he stand without sliding? (Enter the maximum distance in meters.) m
Two masses with mass mA = 3.220 kg and mB = 22.81 kg, respectively, hang with a massless line over an inhomogeneous pulley with mass mC = 41.81 kg. The mass center of the pulley is located in the middle of the pulley. The pulley is attached with a frictionless bearing in the middle. g = 9,806 m / s². If mass A accelerates upwards by 5.75 m/s², what force then acts on the suspension of the inhomogeneous pulley?
A rod of mass M and length L is attached to a wall with a pin joint, around which the rod is free to rotate. A horizontal rope attached to the end of the rod holds the rod at an angle θo to the horizontal. Express your answer in terms of M, L, θo, and g (and no other variables). What is the tension in the rope? Suddenly the rope breaks. As a result, the rod swings down. Immediately after the rope breaks, what is the rod’s angular acceleration?
A puck of mass m = 1.10 kg slides in a circle of radius r = 19.0 cm on a frictionless table while attached to a hanging cylinder of mass M = 4.10 kg by a cord through a hole in the table. What speed keeps the cylinder at rest?
Two equal 16.5 kg masses are at the ends of a 4.6 kg 60.5 cm rod that is initially spinning about the rods center at 55.7 rev./sec. suddenly the rods length is increased to 92.3 cm. How fast is the rod (& masses) spinning now? Neglect any frictional interactions in the axle. Enter in your in rev./sec.
A roundabout whose rotating base is a heavy uniform disc of radius 2m and mass 400 kg has a central pillar and handles which are of negligible mass (see figure). The roundabout is set rotating at a steady rate of 20 r.p.m. €) 20 r.p.m. Four small children, of mass 10 kg, 20 kg, 30 kg and 40 kg respectively, step gently on the edge of the roundabout, each with velocity 7.2 km/hr along a tangential direction and cling to the handles. After holding on for sometime, the children step gently off the roundabout with the same velocity but this time in a radial direction. Neglecting all effects of friction and air drag, the final rate of rotation of the roundabout will be about (a) 28 r.p.m. (c) 36 r.p.m. (b) 25 r.p.m. (d) 21 r.p.m.
The mass of two objects are M1 and M2 respectively, and M2 > M1. M2 must have a greater moment of inertia than M1. True or false?
A projectile of mass m is launched from the surface of the earth at an angle α with the vertical. If the initial speed of the projectile is v0 = √(GM / R) where M = 5.97 × 10^24 kg and R = 6371 km are the mass and radius of the earth. Determine the arc S or the distance reached by the projectile for an initial angle α = 24.54 radians. result in km
Now we have a rod-shaped space station of length 1402 m and mass 8.50 x 10^6 kg, which can change its length (kind of like an old-fashioned telescope), without changing its overall mass. Suppose that the station is initially rotating at a constant rate of 1.51 rpm. If the length of the rod is reduced to 1.51 m, what will be the new rotation rate of the space station? 5.08 rpm 2.54 rpm 3 8.13 rpm 4 1.52 rpm