PROBLEM 5 : The cable shown supports a uniformly distributed load of 30 kN/m of horizontal projection. 5a : Find the tension at the lowest point of the cable 5b: Find the tension at the left support 5c : Find the total length of the cable 30 kN/m 2 m 4 m 4 m

Q: Q.17.8 apart with one end 5 m above the other (as shown in figure below). The cable is loaded with…

A:

Q: Problem #5: A 6 = 10+C (degrees) D В The street-lights at A and B are suspended from the two poles…

A:

Q: 1.) The cable shown carries a triangularly distributed load. Find the tension of cable at the…

A: Due to symmetry of loading and boundary conditions about Vertical line passing through mid of span…

Q: H. 0.8 m 4 in. 0.6 m 12 in. E 1.2 m 1.2 m 30 in. 20 in. 3.6 kN 1.2 m 8 in.l 2. A rectangular plate…

A: Given:- The weight of the rectangular plate = 75 lb  The plate is held by cable EH  Point A and B…

Q: Q.4) Rod AB is in the x-y plane and supported by two cables as shown. The tension in cable AC is 910…

A:

Q: The tension in the supporting cable BC equals 900 N. 1. Express the 900 N tension in cable BC as a…

A:

Q: In the picture below, the beam AB is held up by cable BC on the right at B and supported by a pin on…

A: Question is base on the system in which a beam AB is held up by cable BC . Load on cable AB ,…

Q: aft. Calculate the t

A: Apply equilibrium :∑ Fz=0T2(31.52+32)+T2(31.52+32)+T1=mg2T2(0.44721)+T1=480(9.81).....(1)

Q: 20° B 50 D 55° VQ

A: To find the force in cable TDE and Q -

Q: 10- The antenna OD shown is supported by the three cables as shown. D(0,0,40) i- The unit vector of…

A: Given data: antenna OD is supported by the three cable.

Q: over the large pulley. A locking pin at A prevents rotation of the pulley. If µ = 0.4 between the…

A:

Q: 130 480 B 320 Z 450 → A Dimensions in mm 250 D 360 360 X Fig. P2.89 and P2.90 2.90 A rectangular…

A:

Q: A 100N load is supported by a strong bar as shown in the figure. The tension in the cable is 200N.…

A:

Q: A 30 kg mass M is held in place by the 50 N force F1, cable OA and cable Find the mass m of the…

A: Given : Mass M = 30 kg Force F1 = 50 N To Find :  The mass m of counterweight to keep point O in…

Q: 14 ft 6 ft K 16 ft F |G H B Q L he cable shown above is loaded with P 5 k and Q = 4 k. L = 4 @ 12 ft…

A:

Q: Cable AB passes over the small ideal pulley C without a change in its tension. What length of cable…

A:

Q: distributed load of 7 kN/m and the sag of the cable measured from the higher end is 6 m. Calculate…

A: To determine: Horizontal tension in the cable Maximum tension in the cable   Given, Uniformly…

Q: distributed load of 7 kN/m and the sag of the cable measured from the higher end is 6 m. Calculate…

A:

Q: The guy wires AB and AC are attached to the top of the transmission tower. The tension in cable AB…

A: Given : Tension in cable AB is = 9.9 kN To Find : Tension T in cable AC and Magnitude R of downward…

Q: Q.3) The L-frame in figure below supports forces from two cables. Cable "EAD" passes through a…

A:

Q: A cable PQ of length 25 m is supported at two ends at the same level as shown in the figure. The…

A:

Q: What exactly is a particle size analyzer, and how does it work?

A: Particle size analyzer is used for determing  the size as well as the distribution of particles of…

Q: Situation 1 The cable carrying 200-N loads at B and Cis held in the position shown by the horizonta…

A:

Q: A steel cable and a titanium cable support a rigid bar at A and B. Both cables have cross- sectional…

A: Given :

Cables

Cables are collections of wires, alternatively referred to as a cord, connector, or plug. They are one or more wires covered in a plastic covering that allows for the transmission of power or data between devices. The earliest use of recognizable electrical cable was the early commercialized telegraph lines. These were iron-made and tedious to produce and install cabling.