Problem 4: A 5000kg water tank is supported by four pipes of collective stiffness of 2.5kN/m. The structure has a damping attribute of 10000 kg/s. If the tank is initially displaced at +45mm to the right at a velocity of +25mm/s, determine the displacement and velocity at t = 10 seconds.

Problem 4: A 5000kg water tank is supported by four pipes of collective stiffness of 2.5kN/m. The structure has a damping attribute of 10000 kg/s. If the tank is initially displaced at +45mm to the right at a velocity of +25mm/s, determine the displacement and velocity at t = 10 seconds.

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

A rectangular tank 7m long by 2.4m deep and 2.65m wide, contains 1.2m of water.If the linear acceleration horizontal in the direction of the tank's length is 2.75m/s²a) Compute the total force due to the water acting on each end of the tankb) Show that the difference between these forces equals the unbalanced force necessary to accelerate the liquid massc) If the tank is filled with water and accelerate in the direction of its length at the rate 1.72m s³, how many litres of water are spilledd) What is the maximum acceleration should be to keep no water will spill out
Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a stationary flat plate which is inclined at an angle of 30° with the axis of the stream. Find, (i) Force normal to the plate (ii) Velocity of the jet (1) Mass flow rate of water kg/sec. Answer
Q.2.A.The closed tank in figure is at (20°c) (specific weight of air =0.0118 kN/m³). If the pressure at point (A) is (98 kPa) absolute, what is the absolute pressure at point (B)? IT 3m Air D 5m Air 7 3m Water B. Consider the following steady, two dimensional velocity field: V=(u,v)= (0.5 +1.2x)i + (-2-1.2y) j, Is there a stagnation point in this flow field? If so, where is it? u
Q4/ The outlet pipe from a pump is a bend of 45° rising in the vertical plane as shown in Fig. 4. The bend is 150 mm diameter at its inlet and 300 mm diameter at its outlet. The pipe axis at the inlet is horizontal and at the outlet it is 1 m higher. By neglecting friction, calculate the force and its direction if the inlet pressure is 100 kN/m² and the flow of the water through the pipe is 0.3 m/s. The volume of the pipe is 0.075 m³? L PI U₂ A₁ Fig. 4 P2 U2 A2 ور T
A mass of 8 kg is dropped onto the middle of a pinned-pinned beam with a velocity of V-1 m/s, as shown in the Figure. The impact causes vibrations of the mass, which sticks to the beam. The beam is made of steel (E-213 x 10 N/m?), is 2.6 m long, and has a moment of inertia l-3.6 x 10m. Determine the maximum acceleration of vibration. Assume the mass of the beam is negligible. M tv (m/s)
5.5
Q8
6.12 ft L D G_4.24 ft F C 0.88 R K T 12.12 + 1 LT-- A 45° j4 ft K ftl 4.24 ft Referring to the figure shown. Determine the horizontal force due to the water acting on the cylinder per foot of its length.
Calculate the support reaction at point A and B of the given figure. kindly show your complete solutions.
Q34. A 10 cm diameter jet of water éxerts a force of 2 kN in the direction of flow against a stationary flat plate which is inclined at an angle of 30° with the axis of the stream. Find, (i) Force normal to the plate (11) Velocity of the jet (ii) Mass flow rate of water kg/sec. Answor
The floor of a classroom is made of 125-mm thick lightweight plain concrete. If the floor is slab having a length of 9 m and width of 10 m. Determine the force in kN caused by the liveload. Liveload for private room = 1.92 kPa
27. Refer to Figure 13. What is the reaction at B? a. 275 N b. 375 N c. 475 N d. 575 N FIGURE 13 300 N/m В 3 m 1.5 m