PROBLEM 3 Determine the force in members BD, AD and CD. Pz = 3kN D Note: Supports A, B, and C are balls inside a collar. 1 upward reaction and 1 reaction perpendicular to the axis of the collar. 4m 1.0m A 1.5m 2m B

Q: Required information Consider the beam and loading shown. Assume that the flexural rigidity of the…

A: from equilibrium of bar AC          ΣFy=0          -5ω0×L2+1.6ω0L+vC=0…

Q: The beam AD is pinned to the wall and adjusted to the horizontal position by the tension member BC.…

A:

Q: |8.00 kips Sketch a Free Body Diagram of a BY section of the truss that facilitates determination of…

A:

Q: B. The bent beam ABC is attached to pin at C and rests against a roller support at B. Neglecting the…

A:

Q: If the gap between C and the rigid wall at D is initially 0.15 mm, determine the magnitudes of the…

A:

Q: 25. 2-10. Determine the components of the 250-N force acting along thé u ànd v axes. 60° и - 70° 45°…

A: Given that:

Q: *10-28. Determine the force in member AD of the truss. The cross-sectional area of each member is…

A:

Q: Find the force in member GI of the truss shown below. А 15kN 2m С D 15kN 2m F G E 15kN 2m H I 4m

A:

Q: how

A:

Q: 2 2-1. The steel framework is used to support the reinforced stone concrete slab that is used for an…

A: Given thata=2mb=5mba=52=2.5one way slabBE :-       200 mm thick reinforced stone concrete slab ,…

Q: find the global equilibrium of the truss.

A: The following  figure shows the Free Body Diagram of the truss.

Q: Determine the reactions at the supports, then draw the moment diagram. Assume B and C are rollers…

A: from the principle of super position: ∆'B=5wL4AC384EI where, w = uniformaly distributed load LAC =…

Q: The pipe cutter is clamped around the pipe P. If the wheel at A exerts a normal force of FA = 80 N…

A: Following is the given information:

Q: Determine the forces in members CG and GH of the symmetrically loaded truss.

A:

Q: 20 support B and joint C. The contact at E is smooth. Force P Ib is applied at F. Determine the…

A: Solution Finding the reaction at B and joint C

Q: end by a tie rod BC. Determine the reactions at A, and the #9-40. The beam is fixed at A and…

A:

Q: For the truss shown below is supported by a pin at A and roller at F. If it is loaded with P…

A: ∑FX=0⇒AX=0∑FY=0⇒AY=P=516 KN and FY=P=516 KN (by symmetry) Considering joint A:…

Graphical Methods

The graphical method is a method of solving equations involving more than one variable using the Cartesian coordinate system. In civil engineering, the use of the graphical method is limited to the problems involving two variables. The graphical method has a great impact in solving the questions regarding engineering mechanics.