Problem 3 Determine n and the percentage of the total power carried by the sidebands of the AM wave for tone modulation when (a) u = 0.5 and (b) μ = 0.3. = 0.5. For = 41² 100% => (0.5)² +- (0.5)² -100% = 11.11%

Problem 3 Determine n and the percentage of the total power carried by the sidebands of the AM wave for tone modulation when (a) u = 0.5 and (b) μ = 0.3. = 0.5. For = 41² 100% => (0.5)² +- (0.5)² -100% = 11.11%

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Related questions

Q: = What is the percent of modulation if the power in the side band is 5 W and * ?carrier power is 30…

A: Given: power in side band Psb = 5W carrier power Pc=30 W

Q: What is the difference between frequency modulation and phase modulation? DO NOT COPY FROM THE…

A: Frequency modulation Phase modulation Frequency changes at the instant but phase and amplitude…

Q: VIN = 0. Determine V,? %3D a. Vo is either -13V or +13V; more information Vo about VIN is required.…

A: Given: A circuit. According to question: Let the supply voltage of op-amp be Vsupply=±15V The…

Q: it is missing the power and one it is missing the carrier and one it is missing the amplitude and…

A: In this question , we have to tell about how Single side band differ from standard AM signal..

Q: Infinite number of sidebands are present in AM AM modulation index greater than 1 Modulation index…

Q: Calculate the modulation index for an FM wave where the maximum frequency deviation is 50 kHz and…

A: Given: In FM wave, The maximum frequency deviation, ∆f=50 kHz The modulating frequency, fm=5 kHz

Q: Calculate the side band power in an AM signal when there is 50% modulation and the carrier power is…

A: So we need to find the total side band power.

Q: A FM signal has a carrier swing of 100 kHz when the modulating signal has a frequency of 8 kHz. The…

A: Given: A FM signal having Frequency swing, fmax-fmin=100 kHz Frequency of modulating signal, fm=8…

Q: The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

A: For given Amplitude modulation we need to calculate peak voltage level for modulating signal .

Q: 6-17 An AM signal has an unmodulated peak carrier level of 200 V. Determine the maximum and minimum…

Q: 8/ Find the modulation index for the following AM modulated signal: () 2 15 1 05 0 -05 -1 -15 -2 0…

A: here we have to find the modulation index of the AM signal.

Q: In Pulse Width Modulation, if you want the signal to be high for 3/4 of the time and low for 1/4th…

Q: Calculate the modulation index (in kHz/V) in an

A: Given - Modulating amplitude = 9.3V frequency deviation = 75.1 kHz

Q: for a given signal with bendwidth B, which is a possible sampling frequency? O 0.5B B O 1.5B O 2B h

A: This is a problem of sampling frequency. The solution is given in the next step

Q: For an AM signal, the bandwidth is 10 kHz and the highest frequency component present is 705 kHz.…

A: Given : In the given question have they have mentioned an amplitude modulation system. The…

Q: In R3E, how much % of the total power is in the sideband at 90% modulation

A: In this question, how much % of the total power is in the sideband at 90% modulation.

Q: The carrier frequency is 500 Hz, and the modulating signal is a single- tone sinusoidal signal. The…

A: Consider the given AM wave,

Q: provide 2 similarities and 2 differences for each of them. Impedance vs. Radiofrequency Optical…

A: According to the question, we need to provide 2 similarities and 2 differences for each of them,…

Q: 16. A micron is * One millionth of a foot One millionth of a meter One-thousandth of a meter O One…

Q: Given the AM signal as shown: 0.005 0.01 0.015 0.02 0.025 0.03 0.035 0.04 0.045 0.05 Time (s) The…

A: The AM signal graph is given We have to determine the peak voltage level of the carrier in volts

Q: Using half width pulses make the derivation of power spectral densities and derivation of bandwidths…

A: According to the question, we need to calculate power spectral densities and derivation of…

Q: 3) Find and sketch the frequency spectrum of the half-wave rectified cosine wave form in the…

Q: 1. How many sinusoidal frequency components are there for a perfect switching square waves? 2.…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single- tone sinusoidal signal. The…

Q: AM spectrum consists of a) Carrier frequency b) Upper sideband c) Lower sideband d) Carrier…

A: Four options are given, we need to choose the correct option for the filing the blank.

Q: B- Determine the bandwidth for FM system to transmit a sinusiodal signal fom 0 to 15kHz with…

A: Note: Modulation index >1 over modulation Modulation index <1 under modulation

Q: d) x[n]= 2 sin(3n) Analytically, determine whether these signals are periodic (if periodic, state…

Q: | DSBSC signal generation using square wave information sign İnformation: 4 Vp-p 2 kHz square wave…

A: According to question we have to find how many sinc wave does the DSBSC signal consist of and what…

Q: Write the transmitted and received signals and draw the constallation for pi/4 QDPSK modulation if…

A: According to the question, we need to write the transmitted and received signals and draw the…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

A: Peak value of envelope is Ac(1+u) Lowest value of envelope is Ac(1-u) Where Ac is Carrier Amplitude…

Q: Differentiate FM with phase modulation.

Q: During 50% modulation, what percentage of average output power is in the sideband? Blank 1

A: Given, Percentage of modulation = 50%

Q: 4. If the output current of an FM broadcast transmitter is 8.5 A without modulation, what is the…

A: If the output current of an FM broadcast transmitter is without modulation: Modulation index:…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single tone sinusoidal signal. The…

A: In AM power of each side band given by (Ac2/8)u2 Total side band power is (Ac2/4)u2 u is modulation…

Q: 1. Calculate the thermal (Johnson-Nyquist) noise voltage spectrum Su(f) between points A and B. 1.5…

A: The given diagram is shown below,

Q: A square law demodulation is used for detection of a normal AM with 60% sinusoidal modulation. The…

A: Given data, Received signal power P0=4×10-8 W Input noise spectral density 10-12 W AM Modulation…

Q: 3. What is the best value for the modulation index, k. What will happen if B> A?

A: The best value for the modulation index, k, depends on the specific modulation scheme and…

Q: what frequencies will the output waveform be half-wave rectified? A full-wave rectified?

Q: single side spe ctrum for Home worlc: s ketch the function. the same 6 - 16

Q: The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

Q: x[n] = 8u[n] Calculate the average signal power of the given signal.

A: In this question we will find signal power..

Q: 5. A 300-W carrier is modulated on a depth of 60 %. Calculate the total power in the modulated wave…

A: In this question, Power of the carrier signal Pc=300-W modulated depth m=60 %. Calculate the total…

Q: DSBSC signal generation using square wave information sign İnformation: 4 Vp-p 2 kHz square wave…

A: DSBSC SINGAL GENERATOR signal CONSIST OF two TWO'SINE WAVES THEY ARE CALLED AS SIDEBANDS THEY ARE…

Q: A desired signal at 26.2 MHz is mixed with a local oscillator of 42.0 MHz. What is the image…

A: Given: Desired signal frequency, ftrx=26.2 MHz Local oscillator frequency, f0=42.0 MHz

Q: A square law demodu sinusoidal modulation.

A: It is given that modulation index=0.6 (u) For AM ,Figure of merit= u^2/(2+u^2) The details…

Q: The carrier frequency is 500 Hz, and the modulating signal is a single-tone sinusoidal signal. The…

A: Modulated signal has modulation index less than 1. Generally u<1 is the case of presence of…

Concept explainers

Frequency Modulation

Frequency modulation is a method or process of encoding the data of a specific signal (analog or digital) by modulating the carrier wave frequency according to the frequency of the modulated signal. Modulated signals are nothing more than information or data that should be conveyed after being converted into electronic signals.

Question

Problem 3
Determine n and the percentage of the total power carried by the sidebands of the AM wave
for tone modulation when (a) u = 0.5 and (b) μ = 0.3.
For = = 0.5.
100% =>
(0.5)²
7 + (0.5) ²
-100% = 11.11%

Expert Solution

This question has been solved!

Explore an expertly crafted, step-by-step solution for a thorough understanding of key concepts.

SEE SOLUTION Check out a sample Q&A here

Step 1: Taken required information to find efficiency of AM modulation

VIEW

Step 2: finding efficiency of AM modulation

VIEW

Solution

VIEW

Step by step

Solved in 3 steps with 3 images

SEE SOLUTION Check out a sample Q&A here

Knowledge Booster

Learn more about

Need a deep-dive on the concept behind this application? Look no further. Learn more about this topic, electrical-engineering and related others by exploring similar questions and additional content below.

Similar questions

AM signal's frequency is a constant True O False QUESTION 9 Noise equivelent bandwidth is always the same as -3dB bandwidth. True False QUESTION 10 A period signal's auto correlation is period as well. O True False
Determine the Bandwidth of a FM wave when the maximum deviation allowed is 75KHZ and the modulating signal has a frequency of 10KHZ. BW= .khz
7-15 An FM tone-modulated signal has a frequency deviation of 12 kHz and a moodulating frequency of 200 Hz. Deler- mine the transmission bandwidth.
AM spectrum consists of a) Carrier frequency b) Upper sideband c) Lower sideband d) Carrier frequency with both upper and lower sideband
An AM wave displayed on an oscilloscope has values of Vmax = 4.8 and Vmin = 2.5 as read from the graticule. What is the percentage of modulation? To achieve 75 percent modulation, what amplitude of the modulating signal Vm is needed?
11:10 I ZYI N 1 a . "l zain IQ In DSB-SC-AM modulation the information carried by carrier is * zero more than information carried by USB less than information carried by LSB equal to information carried by any side A signal has a series of harmonics with frequencies (2 MHz, 6 MHz,10 MHz) and so on contain a third harmonic of 10 MHz 2 MHZ 6 MHz 3 MHz The benofit of I DE in AM DSR SCic *
| DSBSC signal generation using square wave information sign İnformation: 4 Vp-p 2 kHz square wave Carrier: 4 Vp-p 100 kHz sine wave How many sine waves does the DSBSC signal consist of and what is the frequency of these waves?
1. Calculate the total power of AM signal (par-A). 2. Calculate the bandwidth of AM signal (part-A). 3. Draw the spectrum of AM signal (part-A). DC Vmax Vmin m 3v 1.4 0.25 0.7 2v 1 0 1 1v 0.8 -0.36 1.94
In an AM system, the carrier with frequency of 10 MHz and amplitude of 10 V is modulated by an audio frequency signal of 3 KHz frequency and a 6 V amplitudeEstimate the depth of modulation and draw the spectrum for(a) 100% modulation(b) 60% modulation
Find Reg between a aud b Delta and star trans fers ?
Find the modulation index if a (10 V and 1MHZ) Cos wave carrier is amplitude modulated by two different frequencies, with amplitudes of 2 V and 100KHZ Sin * wave, and 4 Vand 400KHZ Cos wave respectively 0.223 0.25 No right choice 0.447
The carrier frequency is 600 Hz, and the modulating signal is a single-tone sinusoidal signal. The x-axis is in time while the y-axis is the amplitude of the AM signal. Determine the total power of the AM signal in w. 2 1.5 1 0.5 -0.5 -1 -1.5 -2 0.005 0.01 0.015 0.02 0.025 0.03 0.035 0.04 0.045 0.05 Time (s)