Problem 3 A 3-phase, 50 HP, 415Vrms (line-to-line), 50HZ, 4-pole Y-connected induction machine has the following equivalent circuit parameters: Rs = 0.15625ohm Rr'= 0.185ohm Xm = 17.75ohm XI1= 0.7825ohm X12'= 0.7825ohm Rc = 148.75ohm If the machine is operating as a generator at the rated conditions (50 HP mechanical power and 415V terminal voltage), find, a) The slip. the slip in % is: b) Input torque. the input torque in N.m c) the stator current amplitude. the current in A is d) The rotor speed in rpm the rotor speed in rpm is

Q: Find the Vout for the circuit shown below. R1 R2 10kohm 2kohm U1 R3 15V 4kohm OPAMP 3T_VIRTUAL R4…

A:

Q: Find the control ratio C/R for the system given below H₂ G₂ G₁ H₂ G₂

A:

Q: Draw basic internal architecture of IC 7492 and design divide by 9 counter Sng IC 7492.

A: IC 7492 is a 4 bit ripple type counter i) Internal structure ii) Divide by 9 counter using IC 7492

Q: Vth=....2.V. Ra=..2. %3D Practical RL(Q) IL PL %23 96.4 77.7m 65.5m 25 50 75 is

A: “Since you have posted a question with multiple sub-parts, we will solve first three sub-parts for…

Q: 9.15 a) Show that, at a given frequency w, the circuits in Fig. P9.15(a) and (b) will have the same…

A: The given circuit diagram is shown below,

Q: Table Q4(c) shows the parameters for three types of gates. Based on your decision on the speed-…

A:

Q: Instructions: USE KMAPS or LC to reduce the equations and or Generate the equations by inspection…

A: the reduced equations using K-maps or logic minimization techniques because the circuit includes…

Gradient of a Scalar Field

Consider a room or a place where the temperature is denoted by a scalar field T, such that at each point (x, y, z), the temperature is given as T(x, y, z). It is independent of time, in which the temperature rises most quickly. The gradient of T will show the direction at that point by moving away from (x, y, z). How far will the rise in temperature in that direction be determined by the gradient magnitude? Consider a surface that has a height above sea level at point (x, y) which is given by H(x, y). At that point, pointing in the direction of the steepest slope or grade is the gradient of H. The magnitude of the gradient of the vector gives the steepness of the slope at that point. How a scalar field changes in another direction can be measured by the gradient by taking a dot product rather than just the direction of the greatest change?