Problem 2. Based on the figure below, which represents the spectrum of a DSB-LC signal, find the following. P(@) 47 2n -1200 -1100 -1000 -900 -800 800 900 1000 1100 1200° (a) What is the carrier and message signal frequencies in rad/sec. (b) Find the value of modulation index. (c) What is the message signal m(t). (d) Sketch the modulated signal in time domain p(t) and label the maximum and minimum of the waveform. (e) Calculate the average power for both the carrier (P) and side bands (P,). (f) Find the modulation efficiency (µ)

Problem 2. Based on the figure below, which represents the spectrum of a DSB-LC signal, find the following. P(@) 47 2n -1200 -1100 -1000 -900 -800 800 900 1000 1100 1200° (a) What is the carrier and message signal frequencies in rad/sec. (b) Find the value of modulation index. (c) What is the message signal m(t). (d) Sketch the modulated signal in time domain p(t) and label the maximum and minimum of the waveform. (e) Calculate the average power for both the carrier (P) and side bands (P,). (f) Find the modulation efficiency (µ)

Introductory Circuit Analysis (13th Edition)

13th Edition

ISBN:9780133923605

Author:Robert L. Boylestad

Publisher:Robert L. Boylestad

Chapter1: Introduction

Section: Chapter Questions

Problem 1P: Visit your local library (at school or home) and describe the extent to which it provides literature...

See similar textbooks

Similar questions

C. Phase reversal D. Modulator's sensitivity factor 39. In linear modulation, the intelligent signal is conveyed in A. The amplitude of the transmitted signal BA The sideband components of the transmitted wave C. The phase deviation modulated signal D. None of the above | 40. What communication technique or modulation scheme make use of channel noise as an added advantage? A. Asynchronous shift key modulation B. Vestigial sideband modulation C. Spread-spectrum D.4 Wideband Frequency modulation |41. Narrowband FM and AM share a lot of similarities except that , A+ The lower side frequencies are 180° out of phase. B. The upper side frequencies are 180° out of phase. C. The sideband frequencies are 180° out of phase. D. None of the above | 42. Modulation is done in , A. Transmitter B. Radio receiver C. Between transmitter and radio receiver D. None of the above |43. At 100 % modulation, the power in each sidebands is, A 50 % В. 40 % С. 60 % D 25 % | 44. In a TV transmission, picture is…
a.Find carrier peak amplitude (vc), carrier frequency (fc), message peak amplitude (vm), messagefrequency (fm) and modulation index (m). b.Write the equation of the VAM (t) in time domain. c.Sketch spectrum of the modulated transmitted AM signal and find the Bandwidth of theTransmitted AM signal d.
4. A modulated signal (AM) varies between the maximum values of +18V and -18V, if the carrier has an amplitude of 12V, a) What is the modulation index? b) What is the maximum magnitude of the modulator? c) Sketch the envelope of the modulated wave
In an AM modulator the message signal is m(t) = coswmit+2coswm2t, and the carrier wave is c(t) = Acosw.t. The modulation index is m = 0.5. a) Determine the amplitude of the carrier wave A. b) Determine the expression of the modulated signal with the AM modulation scheme. c) Determine the expression of the frequency spectrum of the AM modulated signal and then plot the frequency spectrum.
The figure shows the AM modulated signal. What is modulation index?
For single sideband (SSB) modulation d) Explain with drawing the demodulation process of SSB signal.e) How many single sideband (SSB) stations can be accommodated in a 180 KHz bandwidth if the highest modulating signal frequency fmax is 9 KHz?f) What are the main advantages and disadvantages of single sideband (SSB) modulation compared with ordinary amplitude modulation (AM).
I need the answer as soon as possible
Q6. Figure Q6 shows the line spectrum of a modulated signal (all components are positive and real). 3 1 232 234 236 238 frequency/kHz Figure Q6: Line spectrum of a modulated signal (a) Describe the modulation scheme. (b) What are the values of the carrier frequency, modulation frequency and the modulation index? (c) What is the transmission efficiency (ratio of modulated to total power) in this example? (d) The reception of this signal is undertaken with a superheterodyne detector using an intermediate frequency of 110 kHz. What is the appropriate local oscillator frequency? (e) Demodulation of this type of signal is usually accomplished using an envelope detector. Describe the principles of operation of an envelope detector and sketch an example circuit. (f) What considerations should be made about the component values in the design of an envelope detector in order to demodulate the signal after shifting to the intermediate frequency? Relative unitsS
If the amplitude of the modulation signal voltage was given to be -4v and +4v and carrier amplitude also given to be -22v and +22v, by suitable waveform diagram determine the Am modulated output. Remember to provide all necessary wave forms in practical terms.
A sinusoidally modulated AM waveform is shown below: Determine: a) Peak amplitude of the upper and lower side frequencies. b) Peak amplitude of the unmodulated carrier. The modulation index. The carrier power and the power in the sidebands. The total transmitted power. 3 0 -3 -9 The transmission efficiency. The amplitude of the carrier which must be added or subtracted to attain a modulation index of 0.5. In AM modulation, the modulation index is kept < 100%, why?
C- Put TRUE or FALSE for only TWO of the following and say why: 1. PCM modulation is very complex technique compared to DM. 2. Envelope detection for PSK signal is possible via using DPSK. 3. A frequency reuse factor can be reached to "1" as a maximum value.
c) An audio signal 10sin 27(2000t) amplitude modulates a carrier 20sin 2π(200000t). i) ii) iii) d) How Sketch the amplitude modulated wave. Determine the modulation index? What is the frequency content of the modulated wave? AM broadenet stations. nodated in a 100 KH