Problem 2: The dimensions of a cylindrical core sample are 10.16 cm long and 3.81 cm in diameter after it was thoroughly cleaned and dried. The direct core sample weighted 365.0 g. The core sample was then completely (100%) saturated with brine that has specific gravity of 1.04. The weight of the saturated core sample is 390.0 g. Calculate the porosity of the core sample?

Problem 2: The dimensions of a cylindrical core sample are 10.16 cm long and 3.81 cm in diameter after it was thoroughly cleaned and dried. The direct core sample weighted 365.0 g. The core sample was then completely (100%) saturated with brine that has specific gravity of 1.04. The weight of the saturated core sample is 390.0 g. Calculate the porosity of the core sample?

Structural Analysis

6th Edition

ISBN:9781337630931

Author:KASSIMALI, Aslam.

Publisher:KASSIMALI, Aslam.

Chapter2: Loads On Structures

Section: Chapter Questions

Problem 1P

See similar textbooks

Similar questions

Calculate the porosity
B1
Attempt 10 The weight percent of silicon in six different rock samples, each containing different amounts of silicon, was measured different methods. The results are given in the table. two Sample Method A Si wt% Method B Si wt% 1 11.570 11.550 2 15.380 15.290 3 17.950 17.830 4 22.840 22.810 5 25.110 25.170 6 27.070 27.030 Determine feale- 0.300 feale Incorrect Determine fuable at the 95% confidence level. A list of r values can be found in the Student's r table.
Estimate the terminal settling velocity in water at a temperature of 15°C of spherical silicon particles with specific gravity 2.4 and average diameter of 0.05mm. Assume p=999 kg/m3 and p= 0.00113 Ns/m2
lon concentrations obtained for a ground water sample (having pH = 8.1) are given below Ca2+ Mg2+ Na+ HCO3- SO4²- CI- 2- Ion Ion concentration 100 6 (mg/L) Atomic weight Ca 40 Mg = 24 15 Na || 23 250 H= 1, C 16 12, 45 S = 32, O =16 39 CI= 35.5 Carbonate hardness (mg/L as CaCO3) present in the above water sample is
One of the methods in measuring bulk volume for porosity measurement is direct calculation. By using the below data, determine the porosity for this core. Table 1: Parameters of rock-fluid Parameter Value, unit Core diameter 1.57 inch Core length 3 cm Dried core weight 100 g Saturated-brine core weight 110 g Brine density 1.30 g/cm³
Pls ans soon
4) Calculate the amount of water necessary for slaking a quicklime obtained from a 1000 kg limestone with 5% (by weight) impurities. Is this amount larger or smaller than is necessary for a quicklime obtained from a pure limestone? (Ca:40, C:12, O:16, S:32, H:1)
What would be the mass of the dried sample if the moisture content of the sample is 15% and the mass of wet sample is 150.9g? a 131.2 g b 100.6 g c 128.3 g d 173.5 g